Haier L19C10B manual

USER'S MANUAL LCD TV RECEIVER Please read this manual carefully before using your television and keep this manual In a good place for future reference. MODEL: L1510A-C, L15C10A, L1920A-C, L1910A-C, L19C10A, L1510B-C, L15C10B, L1910B-C, L19C10B, L1911 W-C,L19C11 W , L2011 W-C, L20C11 W , L1912W-C,L19C12W , L2012W-C,L20C12W[...]

To users: Thank you for using our LCD-TV . Before connecting the LCD-TV and turning the power on, please read this book carefully . Please keep this book for later use. When it was loss of function by electrostatic shock, please switch the on/off button for restoring the function. CONTENT Safety Not ice Items........................................[...]

Safety Notice Items Incorrect usage will cause fire or electric shock. T o prevent this, please do as required when you are installing, using and cleaning this machine. To insure your safety and extend the life-span of LCD-TV , please read the following items carefully before using: l Please read and understand all the instructions before operation[...]

Front Panel Controls Control Panel Function 6 7 TV/AV MENU VOL- VOL+ CH- CH+ POWER 2 3 4 5 1. Power supply switch 2.TV/AV Select the input signals: PC 3. MENU Press to select the main menu 4. VOL- Volume down / Left orientation to adjust the item in the OSD VOL+ V olume up / Right orientation to adjust the item/Press to enter 5. CH- TV channel down[...]

Connection Options The figure is just f or reference, p lease see t he real. And the A C power supply switch is on the back of the set) DVD STOP PLA Y/P AUSE OPEN/CLOSE PREV NEXT DVD insert COMPONENT Input Connect a component video/audio device to these jacks VGA Input Connect to the VGA 15PIN analog output connector of the PC display card for PC d[...]

Remote Control Key Functions When using the remote control, aim it towards the remote sensor on the TV Stand By DVD Open/close DVD 10+ Scan Zoom Mute Swap Call Screen Display Program Number TV/AV and some other source Exchange Digital Selector TV/DVD Volume/Channel Selection MENU DVD Audio Picture Mode DVD STOP Tune Menu Button DVD SETUP DVD PAUSE/[...]

Remote Control Key Functions Installing Batteries 3 2 1 1.Slide open the cover of the battery compartment on the back of the remote control. 2.Load two AA alkaline batteries in the compartment. (plus and minus poles to respective mark) 3.Replace the cover of the battery compartment. Precautions Make sure that there is no obstacle between the remote[...]

Connection Instructions Ensure that you connect the grounding / earth wire to prevent possible electric shock. If grounding methods are not possible, have a qualified electrician install a separate circuit breaker . Do not try to ground the unit by connecting it to telephone wires, lightening rods, or gas pipes. Grounding External Equipment Connect[...]

Connection Instructions You can use your LCD-TV as a monitor for your personal computer using a VGA cable (not supplied). VGA Input Connection and use steps: 1.Read the user guide supplied with your computer and ensure that it has a VGA connector; 2.Make sure that the power of the LCD -TV and the PC are of f; 3.Connect a D type 15-pin VGA interface[...]

Connection Instructions COMPONENT (If connected to SVIDEO,select the SV external input source.) 3. Refer to the DVD player's manual for operating instructions. Component Input ports T o get better picture quality, connect a DVD player to the component input ports as shown below. S-VIDEO Input Connection and use steps: 1.Read the user guide sup[...]

Connection Instructions SCART Input 1.Link the scart terminal of some other equipment, such as DVD, to the TV SCART input terminal of the television. 2.Press TV/A V to select SCART mode. 3. Press Play button on external equipment for program play . HDMI HDMI HDMI Input How to connect Connect the cables from the external equipment's output jack[...]

Basic Operating Instructions Turn on the LCD-TV Switch on the power button on the back of the set and the TV will in s tandby mode. When the POWER button on the remote control is pressed and the LCD-TV is turned on, the indicator light on the front of the LCD-TV changes from red to green. When the LCD-TV is turned off using the POWER button, the LC[...]

Basic Operating Instructions Select the TV Channel You Want You can use the number keys on the remote control to directly select TV channels. The LCD-TV can store up to 100 channels , and you can press the keys on the remote control or on the panel to make a selection. 1. if you want to choose any channel from 0 to 9, please press the -/-- button U[...]

Menu Operations Picture Menu Options 1. Press MENU button to display the main menu, and V+/V- to select the main menu . 2. Press P+/P- to scroll through the options 3. Press V+/V- buttons to make changes to the parameters 4. Press the EXIT button to exit the menu * In this manual, the OSD (On Screen Display) may be different from your TV s because [...]

Menu Operations 3.Press V+/V- button to increase and decrease the level to adjust the selected option to your preference . 4. Repeat step 2 and step 3 until desired picture quality has been achieved . Function: :Adjust the brightness of the picture . By increasing the level, it will add more light to dark parts of the picture and by decreasing the [...]

Menu Operations Audio Menu Options continued You can adjust sound options to the levels you prefer. 2. Press P+/P- button to enter the audio menu and to go up and down to select the desired option . 3.Press V+/V- button to increase and decrease the level to adjust the selected option to your preference . 4. Repeat step 2 and step 3 until desired so[...]

Menu Operations Function Menu Options Menu Language Selection : The menus can be shown on the screen in the selected language. First select your language. 1. 2. Press P+/P- button to select . 3. Press V+/V- button to select your desired language. From this point on, the on-screen menus will be shown in the language of your choice. Press MENU and V+[...]

Menu Operations Function Menu Options Continued 4. : T o select the display mode between and 5. : 6. : Press V+ to reset some settings to the factory default . 7. CHILD LOCK: Press V+ to enter it and the following appears on the screen: DISPLAY MODE 4:3 FULL SCREEN BLUE SCREEN RESET T o set , the screen will be in blue screen after 3 seconds if the[...]

Menu Operations Adjust Menu Options 1. Press MENU and V+/V- button until the following menu appears on the screen ADJUST AUTO SYNC. PHASE CLOCK H. POSITION V. POSITION Note: This menu only appears in PC mode . 2. Press P+/P- button to enter the adjust menu and to go up and down to select the desired option 3.Press V+/V- button to increase and decre[...]

Menu Operations Tuning Menu Options 1. Press MENU and V+/V- button until the following menu appears on the screen Note: This menu only appears in TV mode . 2. Press P+/P- button to enter the tuning menu and to go up and down to select the desired option . 3.Press V+/V- button to increase and decrease the level to adjust the selected option to your [...]

Menu Operations EXCHANGE : Press V+ to display the menu as follows: Press P+/- to select the item and then V+/- to adjust the channel and V+ to confirm.( F or example: press P+/- to select FROM item, and then press V+/- to adjust the channel number to 1; then Press P+/- to select TO item, and V+/- to adjust the channel number to 9; press P+/- to se[...]

TELETEXT P+ P- V- V+ MENU T eletext T eletext is an information system, broadcast by certain channels, which can be read like a newspaper . It also provides subtitles for people with hearing difficulties or those who are unfamiliar with the language in which a particular program is being broadcast (cable networks, satellite channels, etc.). T elete[...]

TELETEXT T eletext Cancel mode This feature allows the TV picture to be displayed while next page to be searched is entered and found. Only the top teletext line is displayed until the page is found. Press the button to hide the teletext information. Either press the button or the T ext button to exit the cancel display mode. Language change Pressi[...]

Basic Playback Preparations Press the TV/DVD button on the front panel or TV/DVD on the remote control to enter the DVD status. Press the TV/DVD button on the front panel or TV/DVD on the remote control again to return to the TV mode. 1. Press OPEN/CLOSE to open the disc tray, place a disc on the disc tray. If there is no disc placed on the disc tr[...]

Advanced Playback PROGRAM When playing discs, press " PROGRAM " to enter program mode. Press the digit buttons to select the program number that you want. When finished, move the cursor to select "START" . This will start the program playback. If you want to cancel this function, press " STOP " , then press "PLAY/[...]

Special Function Playback JPEG DISC PLA YBACK Insert a Kodak picture CD or JPEG picture CD into the tray and the disc will be loaded automatically. If the disc type can be identified, the player will start showing the pictures one by one (slide show mode).If a navigation menu will be displayed use the navigation buttons to select a file, then press[...]

SETUP DVD System Setup DVD System Setup General Setup Process 1.Press the SETUP button, the General Setup Page,Preference Page will be displayed in turn. 2.Press CH+/- b to select, the item, then press to enter the submenu. 3.Press CH+/- bu to select then press PLA Y/ENTER to confirm. 4.Press EXIT key or press SETUP repeatedly to exit the set-up me[...]

..General Setup Page.. Tv Display 4:3 LB Angle Mark On Osd Lang ENG Caption On Screen Saver Off Tv Display 4:3 LB Angle Mark On Osd Lang ENG Caption On Screen Saver Off Tv Display 4:3 LB Angle Mark On OsdLang ENG Caption On Screen Saver Off Tv Display 4:3 LB Angle Mark On Osd Lang ENG Caption On Screen Saver Off DVD System Setup(Continued) DVD Syst[...]

..Preference Page.. DVD System Setup(Continued) DVD System Setup The Preference Page is only available when there is no disc in the player. These settings are applied consistently to all discs which are inserted and played. Preference Page TV Type MULTI(Auto), NTSC, and PAL MULTI : This player supports different TV output, including systems. Usuall[...]

DVD System Setup(Continued) DVD System Setup Default: Resets all settings (except password and parental lock status) for this DVD player back to the manufacturers original settings. Press ENTER to perform the reset. Note: Some functions may not be available depending on the type of disc. ..Preference Page.. Reset TV Type Parental Password Default A[...]

Playable Discs The following discs can be played: You cannot play discs other than those listed above. You cannot play non-standardized discs, even if they may be labeled as above. The performance of CD-R or CD-RW disc is depend on the way of disc-burning. In a few cases, their performance may not be very well or even not playable. Support discs: D[...]

Compare DVD disc with other discs: DVD LD Encode method Digital/MPEG Analog Capacity 133 minutes 242 minutes 266 minutes 484 minutes Playing Time Single-side 60 minutes double-side 120 minutes 12cm Disc diameter 30cm/20cm Horizontal resolution More than 500 line No more than 430 line Multiple kinds Picture proportion One kind Subtitle 32 kinds 16 k[...]

T o assist in location possible faults use help guide below . Note: 1.If the fault can not be repaired using the above guide consult with your local authorized service center. 2.The TV set must only be repaired by a qualified registered service person. Never attempt to remove the back cover as the TV set has dangerous voltages in side that may caus[...]

Specifications Note: All specifications are subject to change without notice. All quality are approximate value. Specifications of the television that you have just purchased may vary from the information in this table due to technical innovations. Accessories Picture, sound system Audio output External input port Power requirements Temperature 1.5[...]

V0.1 0090508942C[...]