Go to page of
Similar user manuals
-
Indoor Fireplace
Monessen Hearth IDV SERIES IDV380NVC
40 pages 5.76 mb -
Indoor Fireplace
Monessen Hearth WDV500
48 pages 3.98 mb -
Indoor Fireplace
Monessen Hearth EYF18
36 pages 1.01 mb -
Indoor Fireplace
Monessen Hearth Direct Vent Gas Fireplace MDV500
4 pages 0.33 mb -
Indoor Fireplace
Monessen Hearth BUF400
1 pages 0.45 mb -
Indoor Fireplace
Monessen Hearth Designer Vent Free Firebox LLF36
1 pages 0.48 mb -
Indoor Fireplace
Monessen Hearth DESIGNER SERIES
26 pages 2.73 mb -
Indoor Fireplace
Monessen Hearth Vent Free Firebox GCUF32C
1 pages 0.47 mb
A good user manual
The rules should oblige the seller to give the purchaser an operating instrucion of Monessen Hearth PL20, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.
What is an instruction?
The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Monessen Hearth PL20 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.
Unfortunately, only a few customers devote their time to read an instruction of Monessen Hearth PL20. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.
What should a perfect user manual contain?
First and foremost, an user manual of Monessen Hearth PL20 should contain:
- informations concerning technical data of Monessen Hearth PL20
- name of the manufacturer and a year of construction of the Monessen Hearth PL20 item
- rules of operation, control and maintenance of the Monessen Hearth PL20 item
- safety signs and mark certificates which confirm compatibility with appropriate standards
Why don't we read the manuals?
Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Monessen Hearth PL20 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Monessen Hearth PL20, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Monessen Hearth service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Monessen Hearth PL20.
Why one should read the manuals?
It is mostly in the manuals where we will find the details concerning construction and possibility of the Monessen Hearth PL20 item, and its use of respective accessory, as well as information concerning all the functions and facilities.
After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.
Table of contents for the manual
-
Page 1
Installation & Operating Instructions ?[...]
-
Page 2
P arlor V ent F ree F ireplace ?[...]
-
Page 3
3 P arlor V e nt F ree F ireplace ?[...]
-
Page 4
4 P arlor V e nt F ree F ireplace 0. Input ratings are shown in BTU per hour and are for elev atio ns up to ,0 00 feet . For ele vatio ns abov e ,0 00 fee t, inp ut ratin gs sh ould be red uced 4 per cent for ea ch 1,000 feet above [...]
-
Page 5
5 P arlor V e nt F ree F ireplace FP2552 PL20 controls This unvented gas heater requires no outside venting and burns cleanly with high heating efficiency . This zero-clearance unvented gas heater can be installed against (or recessed into) any w[...]
-
Page 6
6 P arlor V e nt F ree F ireplace 32 56 ” (816 mm) 18 56 ” (460 mm) 19 56O ” (495 mm) 25 6 ” (651 mm) 31 (6 ” (810 mm) 4 56 ” (105 mm) 1 1/16" (17 mm) Rough Opening Height 8 56O ” (216 mm) 5 56 ” (130 mm) 20” (508 mm) Rough Opening Width 10 56QE ” (256 mm) 10 6 ” (270 mm) 1[...]
-
Page 7
7 P arlor V e nt F ree F ireplace Make sure you have received all parts: Check your packing list to verify that all listed parts have been received. Y ou should have the following: • Unvented gas heater • Ceramic fiber logs • T wo () anchoring screws • Installation/oper[...]
-
Page 8
8 P arlor V e nt F ree F ireplace This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ventilation air . ?[...]
-
Page 9
9 P arlor V e nt F ree F ireplace Carefully select the best location for installation of your unvented fireplace. The following factors should be taken into consideration. • Clearance to side wall, cei[...]
-
Page 10
10 P arlor V e nt F ree F ireplace Ensure that minimum clearances shown in are maintained. Left and right c[...]
-
Page 11
1 1 P arlor V e nt F ree F ireplace If unit is to be “built in”, fireplace framing can be built before or after the appliance is set in place. [...]
-
Page 12
1 P arlor V e nt F ree F ireplace FP2561 anchor screws Anchor Screws 3/16" x 1 Zv " FP561 Figure 10 - Secure Heater to Floor or Hearth ?[...]
-
Page 13
13 P arlor V e nt F ree F ireplace A qualified gas appliance installer must connect the heater to the gas supply . Consult all local codes. [...]
-
Page 14
14 P arlor V e nt F ree F ireplace When tightening the joint to the valve, hold the valve securely to prevent movement. T est all gas joints from the gas meter to the heater valve for leaks using a gas analyzer or soap and water solution after completing conn[...]
-
Page 15
15 P arlor V e nt F ree F ireplace FP2112a wiring diagram 8/09 Figure 15 - Wiring Diagram Switch On/Off Switch On/Off Switch Optional Remote or W all Switch ODS Pilot V alve TH = 3 TP = 1 TP/TH = ODS Pilot Spade T erminal FP1 1a ?[...]
-
Page 16
16 P arlor V e nt F ree F ireplace 1. Open bottom access door . . Connect the remote wire connectors t[...]
-
Page 17
17 P arlor V e nt F ree F ireplace The millivolt system and individual components may be checked with a millivolt meter having a 0-1000 mV range. Conduct each check shown in chart below by connection meter test leads to terminals as indicated. [...]
-
Page 18
18 P arlor V e nt F ree F ireplace — This unit is supplied with four (4) ceramic fiber logs. Do not handle these logs with your bare hands. ?[...]
-
Page 19
19 P arlor V e nt F ree F ireplace L G720 PL20 Log 2 Log # LG70 Figure 20 - Place Log #2 L G719 PL20 Log 1 Log #1 LG719 Figure 19 - Place Log #1 . Place Log # on burner by aligning hole in bottom of log with pin located at front of burner . Gently push log down until it comes[...]
-
Page 20
0 P arlor V e nt F ree F ireplace L G721 PL20 Log 3 Log #3 LG71 Figure 21 - Place Log #3 3. Place Log #3 by placing rectangular notch on bottom of log onto the rectangular protrusion on top of log #. Place the other end of log #3 between the front grate and the small 'L' shaped bracket located on the right s[...]
-
Page 21
1 P arlor V e nt F ree F ireplace FP2273 pilot bad flame FP2272 pilot correct flame ?[...]
-
Page 22
P arlor V e nt F ree F ireplace [...]
-
Page 23
3 P arlor V e nt F ree F ireplace FP2552 PL20 controls This appliance is equipped with a piezo ignition device which automatically lights the pilot. If piezo is not working properly , refer to [...]
-
Page 24
4 P arlor V e nt F ree F ireplace FP2563 Piezo 1. Read the safety information label. . Make sure the manual shutoff va[...]
-
Page 25
5 P arlor V e nt F ree F ireplace 1. Remove any items necessary for easy access to the pilot (for example: logs, screens, etc.[...]
-
Page 26
6 P arlor V e nt F ree F ireplace ?[...]
-
Page 27
7 P arlor V e nt F ree F ireplace ?[...]
-
Page 28
8 P arlor V e nt F ree F ireplace 1. Complete Burner Assembly 1 90D0076 90D0095 . V alve 1 14D0467 14D0[...]
-
Page 29
9 P arlor V e nt F ree F ireplace Ref. Description Qty . PL0 1. Log #1 1 90D0086 . Log # 1 90D0087 3. Log #3 1 90D0088 4. Log #4 1 90D0089 1 2 3 4 900093 PL20 logs[...]
-
Page 30
30 P arlor V e nt F ree F ireplace Optional f irebric k k its can be installed. Refer to installation instruc tions provided wit h kit or Adobe Arched Firebrick PLAAFBA Tuscany Arched Firebrick PLTAFBA Cobbled[...]
-
Page 31
31 P arlor V e nt F ree F ireplace 1. Remove face from packaging. . Hold face securely on each side. 3. Place the four (4) hooked protrusions on the back of t[...]
-
Page 32
3 P arlor V e nt F ree F ireplace The following components are warranted for life to the original owner , subject to proof of purchase: Firebox, Combustion Chamber , Heat Ex[...]