Poulan PB24H48YT manual

OPERA T OR'S MANU AL MODEL: PB24H48YT LA WN TRA CT OR AL W A YS WEAR EYE PR O TECTION DURING OPERA TION Visit our website: www .poulan-pro.com W ARNING: Read this Man u al and f ollow all W arnings and Saf ety Instructions. F ail ure to do so can re sult in serious in ju ry . IMPOR T ANT MANU AL Do Not Thr ow A wa y 404402 02.09.06 VB Printed [...]

2 I. GENERAL OPERA TION • Read, understand, and f ollow all instructions on the machine and in the manual bef ore star ting. • Do not put hands or f eet near rotating par ts or under the machine. K eep clear of the discharge opening at all times. • Only allow responsible adults, who are f amiliar with the in str uc tions, to oper ate the mach[...]

3 • Be sure the area is clear of bystanders bef ore operat- ing. Stop machine if anyone enters the area. • Ne v er carr y passengers. • Do not mow in rev erse unless absolutely necessar y . Al ways look do wn and behind bef ore and while bac k- ing. • Ne v er carry children, ev en with the b lades shut off . They ma y f all off and be serio[...]

4 SAFETY RULES ......................................................... 2-3 PRODUCT SPECIFICA TIONS ....................................... 4 CUST OMER RESPONSIBILITIES ................................. 4 ASSEMBL Y ................................................................. 5-6 OPERA TION .....................................................[...]

5 UNASSEMBLED P AR TS (2) Keys Slope Sheet Key (1) Oil Drain Tube ASSEMBL Y When right or left hand is mentioned in this man ual, it means when you are in the oper ating po si tion (seated be hind the steer ing wheel). T O REMO VE TRA CT OR FROM CAR TO N UNP A CK CART ON • Remove all accessib le loose par ts and par ts car tons from car ton. • [...]

6 ASSEMBL Y CHECK TIRE PRESSURE The tires on your tr actor were o v erinfl ated at the f actory f or shipping pur poses. Correct tire pressure is impor tant f or best cutting perf ormance. • Reduce tire pressure to PSI shown on tires . CHECK DECK LEVELNESS F or best cutting results, mo wer housing should be properly le v eled. See “T O LEVEL M[...]

7 OPERA TION These symbols ma y appear on your tr actor or in literature supplied with the product. Lear n and understand their mean- ing. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FORWARD FAST SLOW ENGINE ON ENGINE OFF FUEL CHOKE MOWER HEIGHT R[...]

8 OPERA TION KNO W Y OUR TRA CT OR READ THIS O WNER'S MANU AL AND SAFETY RULES BEFORE OPERA TING Y OUR TRA CT OR Compare the illustrations with y our tractor to f amiliarize y ourself with the locations of v arious controls and ad just ments. Sav e this man ual f or future ref erence . Our tractors conf orm to the applicable saf ety standards [...]

9 OPERA TION FIG. 4 T O USE CHOKE CONTROL - N (See Fig. 6) Use choke control whene v er y ou are starting a cold engine. Do not use to star t a war m engine. • T o engage choke control, pull knob out. Slowly push knob in to disengage. The operation of any tractor can result in f oreign objects thr own into the e yes, which can result in severe e [...]

10 OPERA TION T O ADJUST MO WER CUT TING HEIGHT (See Fig. 8) The po si tion of the at tach ment lift le ver (A) de ter mines the cut ting height. • Put attachment lift le v er in desired cutting height slot. • Slide pointer tab (T) to desired cutting height as a reminder f or ne xt time y ou mow . The cutting height range is ap prox i mate ly 1[...]

11 OPERA TION FIG. 11 T O WING CAR TS AND O THER A T TA C H MENTS T o w only the attachments that are recommended by and comply with specifi cations of the manuf acturer of your trac- tor . Use common sense when towing. T oo hea vy of a load, while on a slope, is dangerous . Tires can lose traction with the ground and cause y ou to lose control of[...]

12 CA UTION: Alcohol b lended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to sep a ra tion and f or ma tion of acids during storage. Acidic gas can dama ge the fuel system of an engine while in storage. T o av oid engine pr oblems, the fuel system should be emptied before stor age of 30 days or longer . Drai[...]

13 FIG. 12 MO WING TIPS • Mower should be properly le v eled f or best mowing per- f ormance. See “T O LEVEL MOWER HOUSING” in the Ser vice and Adjustments section of this manual. • The left hand side of mower should be used f or trim- ming. • Drive so that clippings are discharged onto the area that has been cut. Hav e the cut area to th[...]

14 MAINTENANCE T R A C T 0 R Inspect Muffler/Spark Arrester Clean Air Filter Change Engine Oil (with oil filter) Replace Air Filter Paper Cartridge Replace Spark Plug Check Engine Oil Level Clean Engine Cooling Fins Clean Air Screen 1 - Change more often when operating under a heavy load or in high ambient temperatures. 2 - Service more often when [...]

15 MAINTENANCE FIG. 13 025 44 MANDREL ASSEMBL Y BLADE BLADE BOL T (SPECIAL) CENTER HOLE ST AR B A TTER Y Y our tractor has a batter y charging system which is suf fi cient f or normal use. Howe v er , per iodic charging of the batter y with an automotive charger will e xtend its life. • K eep battery and ter minals clean. • K eep battery bolts[...]

16 MAINTENANCE V- B E LT S Check V -belts f or deterioration and wear after 100 hours of operation and replace if necessary . The belts are not ad just able . Re place belts if they begin to slip from w ear . TRANSAXLE COOLING The transmission f an and cooling fi ns should be kept clean to assure proper cooling. Do not attempt to clean f an or tra[...]

17 MAINTENANCE MUFFLER Inspect and replace corroded muffl er and spar k arrester (if equipped) as it could create a fi re hazard and/or dam- age. SP ARK PLUGS Replace spark plugs at the beginning of each mowing season or after e v er y 100 hours of operation, whiche v er occurs fi rst. Spark plug type and gap setting are shown in “PROD UCT SPE[...]

18 D C B H E F M L K A W ARNING: T O A V OID SERIOUS INJUR Y , BEFORE PERFORMING ANY SER VICE OR AD JUST - MENTS: • Depress brake pedal fully and set parking brake. • Place attachment c lutch in “DISENGA GED” position. • T urn ignition key to “ST OP” and remove key . • Make sure the blades and all mo ving parts have completely stopp[...]

19 - Pivot bar to wards y ou and inser t other end of bar into hole in rear mower br ac ket (D). Mov e mower as needed to inser t bar . - Secure with washer and retainer spring as shown using small 5/16 retainer spring. NO TE: Be sure mo wer side suspension arms (A) are point- ing f orward bef ore sliding mower under tractor . • Slide mower under[...]

20 SER VICE AND ADJUSTMENTS T O LEVEL MO WER Make sure tires are properly infl ated to the PSI sho wn on tires. If tires are ov er or under infl ated, it ma y aff ect the appearance of y our lawn and lead y ou to think the mo wer is not adjusted properly . VISU AL SIDE-T O-SIDE ADJUSTMENT (See Fig. 24) • With all tires properly infl ated and i[...]

21 SER VICE AND ADJUSTMENTS FIG. 25 02548 B B PRECISION SIDE-T O-SIDE ADJUSTMENT (See Fig. 26) • With all tires properly infl ated, park tractor on le v el ground or drive w a y . CA UTION: Blades are sharp. Protect y our hands with gloves and/or wrap blade with hea vy cloth. • Raise mower to its highest position. • At both sides of mo wer ,[...]

22 NO TE: Each full turn of the adjustment nut will change mower height about 1/8". • Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lo wer than the rear tip . • Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut. SER VICE AND ADJUSTMENTS T O REPLACE[...]

23 SER VICE AND ADJUSTMENTS electric 02953 A B C D E F G H J FIG. 30 T O REMO VE WHEEL FOR REP AIRS (See Fig. 31) • Block up axle securely . • Remove axle co v er , retaining r ing and washers to allo w wheel remov al (rear wheel contains a square k e y - Do not lose). • Repair tire and reassemble . • On rear wheels only: align groov es in [...]

24 SER VICE AND ADJUSTMENTS FIG. 32 WEAK OR DEAD BA T T E RY FULL Y CHARGED BA T T E RY REPLA CING BA TTER Y (See Fig. 33) W ARNING: Do not shor t batter y ter mi nals b y allowing a wrench or any other object to contact both terminals at the same time. Bef ore connecting batter y , remov e metal bracelets, wristwatch bands , rings, etc. P ositive [...]

25 ST ORA GE Immediately prepare your tr actor f or storage at the end of the season or if the tractor will not be used f or 30 da ys or more. W ARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reac h an open fl ame or spark. Allo w the engine to cool before storing in any en cl o sure . TRA CT OR Remo[...]

26 TR OUBLESHOO TING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly . 2. See “T O ST ART ENGINE” in Operation section. 3. Engine fl ooded. 3. W ait sever al minutes bef ore attempting to star t. 4. Bad spark plug. 4. Replace spark plug. 5. Weak or dead battery . 5. Recharge or replace battery . 6. [...]

27 TR OUBLESHOO TING POINTS Engine dies when 1. Re v erse operation system 1. T ur n ignition key to tractor is shifted (ROS) is not "ON" while ROS "ON" position. into reverse mower or other attachment See Operation section. is engaged. Engine continues to run 1. F aulty operator-saf ety presence control system. 1. Check wiring,[...]

28 LIMITED W ARRANTY The Manuf acturer warr ants to the original consumer purchaser that this product as manufactured is free from def ects in materi- als and work man ship. For a period of two (2) y ears from date of purchase by the original consumer purchaser , we will repair or replace, at our option, without charge f or parts or labor incurred [...]

29 15 DEGREES MAX. FO LD ALONG DO TTED LINE THIS IS A 15 DEGREE SLOPE ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mow slopes greater than 15 degrees. Make turns gradually to prev[...]

This product has been exper tly en gi neered and carefully manu fac tured to r igid quality stan dards. As with all mechanical products, some adjustments or par t replacement ma y be necessar y during the life of y our unit. F or P arts and ser vice, contact our author ized distributor: call 1-800-849-1297 • F or replacement par ts, hav e availab[...]