English dropdown-ico

Whirlpool 8527809 manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Whirlpool 8527809, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Whirlpool 8527809 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Whirlpool 8527809. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Whirlpool 8527809 should contain:
- informations concerning technical data of Whirlpool 8527809
- name of the manufacturer and a year of construction of the Whirlpool 8527809 item
- rules of operation, control and maintenance of the Whirlpool 8527809 item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Whirlpool 8527809 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Whirlpool 8527809, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Whirlpool service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Whirlpool 8527809.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Whirlpool 8527809 item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    Installation Inst ructions IMPOR T ANT : Read and save these instructions IMPORTANT Installer: Leave Installation Instructions with the owner. Owner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. COMMERCIAL DR YER GAS Part No. 8527809 COMMERCIAL LAUNDRY PRODUCTS ® www.wh[...]

  • Page 2

    Page 2 Post, in a prominent location, instructions to be followed in the event the user smells gas. The information posted shall be obtained by consulting with the local gas supplier. Before you start... We have provided many important safety message in this manual and on your appliance. Always read and obey all safety messages. W ARNING This is th[...]

  • Page 3

    MAXIMUM LENGTH OF 4-INCH (10.2 cm) DIAMETER RIGID METAL VENT No. of 90° turns EXHAUST HOOD TYPE 2-1/2" (6.4 cm) 4" (10.2 cm) 4" (10.2 cm) 4" (10.2 cm) 4" (10.2 cm) 4" (10.2 cm) 64 FT. (19.5 m) 54 FT. (16.5 m) 44 FT. (13.4 m) 35 FT. (10.7 m) 27 FT. (8.2 m) 64 FT. (19.5 m) 54 FT. (16.5 m) 44 FT. (13.4 m) 35 FT. (10.7 m)[...]

  • Page 4

    exhaust hood or sweep elbow 180° sweep elbow wall wall roof main exhaust vent horizontal vent 2 ft. (61 cm) min. above vertical vent highest point of building main collector vent Do Not install screening or cap over end of vent. Gas requirements OBSERVE ALL GOVERNING CODES AND ORDINANCES. Page 4 An exhaust hood should cap the outside end of the ma[...]

  • Page 5

    Page 5 to dryer shutoff valve “open” position gas supply line H. If local codes and ordinances permit, it is recommended that new flexible metal tubing, design-certified by the AGA or CSA, be used for connecting the dryer to the gas supply line. (The gas feed pipe which extends through the lower rear of the dryer is provided with 3/8-inch metal[...]

  • Page 6

    6. Move dryer close to final position. Remove cardboard or hardboard from under dryer. 8. Connect gas supply to dryer. Use pipe-joint compound resistant to the action of L.P. gas for gas connections. If flexible metal tubing is used, be certain there are no kinks. If necessary for service, open the toe panel, use a putty knife to press on the toe p[...]

  • Page 7

    Page 7 6. Move dryer close to final position. Remove cardboard or hardboard from under dryer. 5. Remove the service door of the meter case. Lift the service door up at the back and remove. Install money- accepting device. (Refer to manufaturer's instructions for proper installation.) For dryers using coin slides, use adapter kit supplied with [...]

  • Page 8

    Page 8 3. Assemble 3/4" U.L.-listed strain relief (U.L. marking on strain relief) into the hole below terminal block opening. Tighten strain relief screws just enough to hold the two clamp sections together. Install power supply cord/cable through the strain relief. For a grounded, cord-connected appliance — GROUNDING INSTRUCTIONS: This appl[...]

  • Page 9

    Page 9 Four -wire connection... Four-wire r eceptacle (required for mobile homes) Four-wire power supply cord must have four, No.-10 copper wires and match a four-wire receptacle of NEMA Type 14-30R. The fourth wire (ground conductor) must be identified with a green cover and the neutral conductor by a white cover. NEUTRAL NEUTRAL (white) 3/4"[...]

  • Page 10

    Three-wire connection... Three-wire r eceptacle Page 10 Three-wire power supply cord must have three, No.-10 copper wires and match a three-wire receptacle of NEMA Type 10-30R. 4. Loosen or remove center terminal block screw. 6. Connect the other wires to outer terminal block screws. Tighten screws. 7. Tighten strain relief screws. 8. Reinstall ter[...]

  • Page 11

    Three-wire connection... Three-wire r eceptacle 8. To exhaust dryer, see Exhaust requirements, Pages 3-4. Connect exhaust vent to dryer exhaust outlet and exhaust hood using 4" (10.2 cm) clamps. Use caulking to seal exterior wall opening around exhaust hood. 9. Carefully move dryer into final position. Place level on top of the dryer, first si[...]

  • Page 12

    0" (0 cm)* Recessed area and closet installation instructions If dryer does not operate properly ... If you need assistance... Moving the dryer to a new location... Check the following to be sure that: 1. Electric supply is connected. 2. Circuit breakers are not tripped or house fuses blown. 3. Door is closed. 4. Controls are set in a running [...]

  • Page 13

    Product dimensions 29" (73.7 cm) dryer 27" (68.6 cm) dryer 29" (73.7 cm) Part No. 8527809 © 2001 Whirlpool Corporation Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022 Printed in U.S.A. 27-1/4" (69.2 cm) 16" (40.6 cm) ELECTRIC GAS EXHAUST 4-3/4" (12.1 cm) 13" (33 cm) 1-1/4" (3.2 cm) BACK VIEW[...]

  • Page 14

    Inst ructions d’installation IMPOR T ANT : Lire et conserver ces instructions. IMPORTANT Installateur : Remettre les instructions d’installation au propriétaire. Propriétaire : Conserver les instructions d’installation pour consultation ultérieure. Conserver les instructions d’installation pour consultation par l’inspecteur local des i[...]

  • Page 15

    Page 2 On recommande que l’utilisateur affiche en un lieu très visible les instructions décrivant ce que le client doit faire si une odeur de gaz est perceptible. Obtenir cette information auprès du fournisseur de gaz local. A vant de commencer ... Nous donnons de nombreux messages de sécurité importants dans ce manuel et sur votre appareil [...]

  • Page 16

    Nbre de coudes À 90° TYPE DE BOUCHE DE DÉCHARGE 6,4 cm (2-1/2 po) 10,2 cm (4 po) 10,2 cm (4 po) 10,2 cm (4 po) 10,2 cm (4 po) 10,2 cm (4 po) 19,5 m (64 pi) 16,5 m (54 pi) 13,4 m (44 pi) 10,7 m (35 pi) 8,2 m (27 pi) 19,5 m (64 pi) 16,5 m (54 pi) 13,4 m (44 pi) 10,7 m (35 pi) 8,2 m (27 pi) 0 1 2 3 4 17,7 m (58 pi) 14,6 m (48 pi) 11,6 m (38 pi) 8,8[...]

  • Page 17

    bouche de décharge ou conduit horizontal coude de déviation à 180° mur mur toit conduit d’évacuation collectif coude de déviation 61 cm (2 pi) min. au-dessus du point le plus élevé du bâtiment conduit vertical Ne pas installer une grille ou un couvercle sur l’extrémité du conduit d’évacuation. Spécifications Page 4 L’extrémit?[...]

  • Page 18

    Page 5 vers la sécheuse robinet d’arrêt - position d’ouverture H. Si les codes et règlements locaux le permettent, on recommande l’emploi d’un conduit métallique flexible neuf de conception homologuée par l’American Gas Association ou CSA pour le raccordement de la sécheuse à la canalisation d’arrivée de gaz. (Le raccord qui dé[...]

  • Page 19

    Commencer ... Page 6 prise de courant à 3 alvéoles canalisation d’arrivée de gaz robinet d’arrêt (gaz) conduit de décharge Avec la sécheuse dans la buanderie. 1. Enlever le ruban adhésif dans les angles avant de la sécheuse. Ouvrir la sécheuse; enlever les brochures et sachets de pièces. Essuyer parfaitement la surface interne du tamb[...]

  • Page 20

    Page 7 Commencer ... 1. Enlever le ruban adhésif dans les angles avant de la sécheuse. Ouvrir la sécheuse; enlever les brochures et sachets de pièces. Essuyer parfaitement la surface interne du tambour avec un chiffon humide. 2. Prendre deux cornières de carton de l’emballage et les placer sur le plancher à l’arrière de la sécheuse. Sai[...]

  • Page 21

    Page 8 3. Installer un serre-câble de 3/4 po (agrément UL, avec marque sur le serre-câble) dans le trou au-dessous de l’ouverture du bloc de connexion. Serrer les vis du serre-câble juste assez pour que les deux parties du serre-câble soient maintenues ensemble. Faire passer le câble d’alimentation entre les deux plaquettes. Exécuter les[...]

  • Page 22

    Page 9 Circuit à quatre conducteurs… Le cordon d’alimentation à quatre conducteurs doit comporter quatre conducteurs de cuivre no 10, et on doit disposer d’une prise de courant à quatre alvéoles à type NEMA 14-30R. Le quatrième conducteur (liaison à la terre) doit être identifié par un isolant vert et le conducteur neutre par un isol[...]

  • Page 23

    Circuit à trois conducteurs… Le cordon d’alimentation à trois conducteurs doit comporter trois conducteurs de cuivre no 10, et on doit disposer d’une prise de courant à trois alvéoles de type NEMA 10-30R. 4. Desserrer ou enlever la vis de la borne centrale du bloc de connexion. 5. Connecter le conducteur neutre (blanc ou central) du cordo[...]

  • Page 24

    Circuit à trois conducteurs… Prise de courant à trois conducteurs 4. Ôter la vis de la borne centrale du bloc. 5. Séparer le conducteur de liaison à la terre de l’appareil (vert avec rayure jaune) de la vis de connexion au châssis. Connecter le conducteur de liaison à la terre et le conducteur neutre (blanc ou central) à la borne centra[...]

  • Page 25

    0 cm (0 po)* Instructions pour l’installation dans un placard ou un encastrement Si la sécheuse ne fonctionne pas correctement... Si vous avez besoin d’aide... Déménagement de la sécheuse... Contrôler pour vérifier que : 1. Le circuit d’alimentation électrique est bien alimenté. 2. Les disjoncteurs ne sont pas ouverts et les fusibles [...]

  • Page 26

    Dimensions du produit Pièce n° 8527809 © 2001 Whirlpool Corporation Préparé par Whirlpool Corporation, Benton Harbor, Michigan 49022 Imprimé aux É.-U. Sécheuse 73,7 cm (29 po) Sécheuse 68,6 cm (27 po) 73,7 cm (29 po) 69,2 cm (27 1/4 po) 40,6 cm (16 po) 12,1 cm (4 3/4 po) 33 cm (13 po) 3,2 cm (1 1/4 po) VUE ARRIÈRE 46,7 cm (18 3/8 po) 10,2[...]