Go to page of
A good user manual
The rules should oblige the seller to give the purchaser an operating instrucion of White Rodgers 36j27-554, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.
What is an instruction?
The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of White Rodgers 36j27-554 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.
Unfortunately, only a few customers devote their time to read an instruction of White Rodgers 36j27-554. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.
What should a perfect user manual contain?
First and foremost, an user manual of White Rodgers 36j27-554 should contain:
- informations concerning technical data of White Rodgers 36j27-554
- name of the manufacturer and a year of construction of the White Rodgers 36j27-554 item
- rules of operation, control and maintenance of the White Rodgers 36j27-554 item
- safety signs and mark certificates which confirm compatibility with appropriate standards
Why don't we read the manuals?
Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of White Rodgers 36j27-554 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of White Rodgers 36j27-554, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the White Rodgers service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of White Rodgers 36j27-554.
Why one should read the manuals?
It is mostly in the manuals where we will find the details concerning construction and possibility of the White Rodgers 36j27-554 item, and its use of respective accessory, as well as information concerning all the functions and facilities.
After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.
Table of contents for the manual
-
Page 1
The 36J27 combination gas valve is designed for direct spark ignition (DSI) and hot surface ignition (HSI) system applications. This control is equipped with redundant and main solenoid valves that control gas ow to the main burners, a pressure regulator and a two-position on/o switch for regulation and electrical shut -o of the solenoid v[...]
-
Page 2
2 MOUNTING POSITIONS UPRIGHT , OR 0° TO 90° FROM UPRIGHT 3.000 MAX. SWING RADIUS Swing Radius Fig. 3 – Dimensions Length .................................. 4.75" Width ................................... 2.38" Height .................................. 4.58" Swing Radius ........................ 3.00" Upright (inlet left) 90 [...]
-
Page 3
3 CAUTION ! Do not short out terminals on gas valve or primary control to test. Short or incorrect wiring can cause equipment damage, property damage, and/or personal injury . This control is not intended for use in locations where it may come in direct contact with water . Suitable protection must be provided to shield the control from exposure to[...]
-
Page 4
4 INST ALLA TION 1 . T urn o electrical power to the system at the fuse box or circuit breaker . Also turn o the main gas supply . 2. If replacing an existing valve, disconnect all plumbing and electrical connections from the old control. 3. The control may be installed upright, + or – 90˚ from upright, or vertical (refer to g. 2 ). The[...]
-
Page 5
5 The gas valve outlet pressure was pre-adjusted for both Nat. and LP at the factory , but ne adjustment is possible by removing the access plug and turning the ne-adjustment screw with a 1/8" at blade screwdriver . Adjustment must only be done while monitoring outlet pressure with a suitable manometer properly attached to the outlet [...]
-
Page 6
6 A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner . Do not try to light the burner by hand. B. BEFORE OPERA TING smell all around the appli- ance area for gas. Be sure to smell next to the oor because some gas is heavier than air and will settle on the oor . FOR YOUR SAFETY[...]
-
Page 7
7 NO TES[...]
-
Page 8
White-Rodgers is a business of Emerson Electric Co. The Emerson logo is a trademark and service mark of Emerson Electric Co. www. white-rodgers.com www.emersonclimate.com[...]
-
Page 9
White-Rodgers est une entreprise d’Emerson Electric Co. Le logo d’Emerson est une marque de commerce et une marque de service d’Emerson Electric Co. www. white-rodgers.com www.emersonclimate.com[...]
-
Page 10
7 REMARQUES[...]
-
Page 11
6 A. Cet appareil n’est pas doté d’une veilleuse d’ allumage. Il est pourvu d’un dispositif d’ allumage qui allume automatiquement le brûleur . Ne tentez pas d’ allumer le brûleur de façon manuelle. B. A V ANT DE FAIRE FONCTIONNER L ’ APP AREIL , sentez tout autour de l’ appareil pour déceler toute odeur de gaz. Sentez à proxi[...]
-
Page 12
5 La pression à l’ entrée de la vanne à gaz a été préréglée à l’usine pour le gaz naturel et le GPL, mais il est possible d’ eectuer un réglage précis en enlevant le bouchon d’ac cès et en tournant la vis de réglage précis à l’ aide d’un tournevis à lame plate de 1/8 po . Il faut eectuer ce réglage uniquement en s[...]
-
Page 13
4 INST ALLA TION 1. Coupez l’alimentation électrique au système au niveau du panneau de fusibles ou de disjoncteurs. Coupez également l’alimentation principale en gaz. 2. Si vous remplacez une vanne existante, débranchez tous les raccordements d’ électricité et de plomberie de l’ancienne commande. 3. La commande peut être installée [...]
-
Page 14
3 Ne court-circuitez pas les bornes sur la vanne à gaz ou la commande principale. Un court-circuit ou un branchement incorrect peut causer des dommages à l’ équipement ou à la propriété ou encore des blessures. Cette commande n’ est pas conçue pour être utilisée dans des endroits où elle pourrait entrer en contact direct avec de l’ [...]
-
Page 15
2 POSITIONS DE MONT AGE À LA VERTICALE OU ENTRE 0° ET 90° P AR RAPPORT À LA VERTICALE Rayon de giration Longueur .................................... 4,75 po Largeur ....................................... 2,38 po Hauteur ...................................... 4,58 po Rayon de giration ......................... 3,00 po Debout (entrée à gauche[...]
-
Page 16
La vanne à gaz combinée 36J27 est conçue pour les systèmes à allumage direct par étincelle (ADE) et à allumage par surface chaude (ASC). Cette commande est dotée d’ électrovannes principales et redondantes qui contrôlent le débit de gaz aux brûleurs principaux, d’un régulateur de pression et d’un interrupteur de marche/arrêt à [...]