English dropdown-ico

Winegard MV-1111 manual

1
2
3
4
5
6
7
8
9
10
11
12

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Winegard MV-1111, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Winegard MV-1111 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Winegard MV-1111. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Winegard MV-1111 should contain:
- informations concerning technical data of Winegard MV-1111
- name of the manufacturer and a year of construction of the Winegard MV-1111 item
- rules of operation, control and maintenance of the Winegard MV-1111 item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Winegard MV-1111 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Winegard MV-1111, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Winegard service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Winegard MV-1111.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Winegard MV-1111 item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 Movin’ View TM Digital Satellite Mobile Antenna Models MV-2222/MV-1111 Made in the U.S.A. U.S. Patent Nos. 6,023,247; 6,188,300 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2001 2451021 Rev. 1/06/03 WINEG ARD ®[...]

  • Page 2

    2 DIRECTV ® is an official trademark of DIRECTV , a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton. DIGITAL BROADCAST SYSTEM SATELLITE(S) Introduction Congratulations! Y ou have purchased one of W inegard’ s latest developments in the mobile satel- lite reception product [...]

  • Page 3

    3 2 Cable clamps 1 Cable entry plate 1 large yellow spade connector 2 small red spade connectors All required screws and washers 1 base with electronics, dish, stacked LNBF 1 tube silicone 1. Open box and remove packing material. 2. Lift unit out of box vertically . Do not turn box and “roll” out, or turn upside down to r emove. ! USE 2 PEOPLE [...]

  • Page 4

    4 Installation Diagram FIGURE 1 ADJUSTABLE BASE FOOT REFLECTOR REAR BASE FOOT MUST DIRECTL Y F ACE REAR OF VEHICLE SWITCH LOCATION POWER SUPPLY AZ MOTOR COUNTERWEIGHT Remove wire ties holding mount EL MOTOR LEVELING SCREW ADJUSTABLE BASE FOOT LEVELING SCREW LEVELING SCREW HEYCO ® CONNECTORS GPS ANTENNA REAR ADJUSTABLE BASE FOOT FRONT OF VEHICLE ! [...]

  • Page 5

    5 6. On each foot, screw the flange nut to the base of the leveling screw on the mounting foot, flange up. Place rubber washer , with the rubber side up, on the nut, Figure 2. Push mounting foot under base. Push foot screw through the base and tighten lock nut to secure foot to base. Be sure the base feet are pointing away from the base. Base feet [...]

  • Page 6

    6 10. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 1 1. Put approved sealant in the area under the base feet. Place base foot on top of the sealant and screw down using (2) #10 screws (provided) for each base foot. 12. Unscrew the locknuts in the base and remove the base from feet. Put the other (4) #10[...]

  • Page 7

    7 CABLE- ENTRY PLATE CABLE CLAMP - EVERY12”-16” 1. Decide the best location for the cables to enter the vehicle, and the location of the switch and receiver (see “Installing the switch and receiver” below .) Drill a 1/2” hole in the roof, push wires inside. Make proper connections ( remember you must have fil- tered +12 VDC power source )[...]

  • Page 8

    8 WIRING TWO RECEIVERS SECONDAR Y SATELLITE PRIMARY RECEIVER SATELLITE INPUT NOT USED INPUT IN OUT OUT SP-2052 SAT RECEIVER D575p DEMUL TIPLEXER DEMUL TIPLEXER DC BLOCK RECEIVER Initializing & replacing the dome after connecting the receiver(s) — 1. Park vehicle where it is free of all obstructions and with a clear view of the satellite. 2. D[...]

  • Page 9

    9 Operation Your new MV-2222/1111 features: • GPS technology • Fast signal acquisition times • Easy “one-button” operation • Ability to toggle between satellites using remote control, if subscribing to multi- satellite programming NOTE: For Model MV -1 11 1 vehicle must be parked. 1. T urn on receiver and television set. This unit will [...]

  • Page 10

    10 Signal strength screen meter shows some signal strength, but constantly moves up and down, and is never locked on satellite. Unit continues to move, but never finds any signal. Have signal strength on the even or odd transpon- ders, but not on both transponders. The unit continues to move and the signal strength screen shows that it is finding t[...]

  • Page 11

    11 Base Diagram FIGURE 9 TO RECEIVER TO LNBF CONTROL BOX DETAIL DO NOT USE AZ MOTOR EL MOTOR 8-PIN POWER T A s:part-no1021p11 CONTROL BOX (DETAIL BELOW) POWER SUPPLY #1 POWER SUPPLY (POWER WIRE, SEE DETAIL) #4 COAX CABLE AT CONTROL BOX #3 CONTROL BOX TO LNBF EL MOTOR #2 LNBF VOLTAGE HEYCO CON- NECTORS AZ MOTOR GPS ANTENNA[...]

  • Page 12

    12 Winegard Company • 3000 Kirkwood S treet • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www .winegard.com Printed in U.S.A. © 2002 Winegard Company 2451021 Rev . 1/06/03 TWO YEAR LIMITED WARRANTY Winegard Company warrants this Winegard product (excluding receiver) against any defects in materials or workmanship within two (2) [...]