Belling ILF800 manual

Fully Integrated Larder INST ALLA TION AND USER INSTRUCTIONS Y ou must read these instructions prior to using the appliance and retain them for future reference. ILF800[...]

1 Contents Introduction & safety warnings ...........................................................................2 Electrical requirements ...................................................................................... 3 T ransportation instructions ................................................................................. 4 I[...]

2 Congratulations on your choice of a Belling quality Appliance which has been designed to give you service for many years. W ARNING ! IMPORT ANT ! DO NOT connect the appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to [...]

ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply . Rating label is on the left hand side of fridge liner . We recommend that this appliance is connected to the mains supply via a suitable switched[...]

4 TRANSPORT A TION INSTRUCTIONS 1. The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally , it must only be laid on its left hand side when standing in the front of the appliance. Afte[...]

1. T o avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. 2. Do not operate this appliance unless installed to furniture. 3. The appliance should be located on a smooth surface. The four front and back feet can be adjusted as required. T o ensure that, your appliance is standing upright adjust [...]

6 REPOSITIONING THE DOOR Follow the step by step instructions and the diagram below . Numbers in brackets refer to diagrams.[...]

7 1. Switch off at the socket outlet and pull out the mains plug. 2. Remove all food, loose items and fittings from inside the appliance and door shelves. 3. Unscrew the bolts and remove the upper and bottom hinges from the cabinet and door . (1) (2) 4. Remove stoppers. (3) (4) 5. Fit the stoppers on the opposite side. (5) (6) 6. Reposition the upp[...]

Arrangement Examples (See diagram). 1. Baked, chilled cooked food, dairy products. 2. Meat, sausages, cold cuts, cans. 3. Fruit, vegetables, salads. 4. T ubes, small bottles and cans. 5. Egg tray . 6. Butter , cheese, dairy products. 7. Beverages, large bottles. 8 SUGGESTED ARRANGEMENT OF FOOD IN THE LARDER FRIDGE 1 1 1 2 3 7 6 5 4[...]

The following guidelines and recommendations are suggested to obtain the best results and storage hygiene. 1. Appliance is for the short term storage of fresh food and drinks. 2. Cooked dishes must be stored in airtight covered containers and are best placed on either of the removable shelves. 3. Fresh wrapped produce can be placed on the shelf. Fr[...]

ST ARTING Final Check Before you start using the refrigerator check that: 1. The feet have been adjusted for perfect levelling. 2. The interior is dry and air can circulate freely . 3. Clean the interior as recommended under "CLEANING AND CARE." 4. Insert the plug into the wall socket and switch on the electricity supply . When the door i[...]

CLEANING AND CARE ** We recommend that you switch of f the larder refrigerator at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp instruments or abrasive substances, soap, household cleaner , detergent and wax polish for cleaning. ** Use luke warm water to clean the cabinet of the refrigerator and wipe it dry .[...]

12 REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work switch off at the socket outlet and pull out the mains plug. Follow the instructions below to check if the light bulb has worked itself loose. If the light still fails to work obtain a replacement E14 screw cap type 15 W att (Max) bulb from your local electrical store [...]

DO'S AND DON'TS Do- Clean your larder refrigerator regularly . Do- Keep raw meat and poultry below cooked food and dairy products. Do- Keep food for as short a time as possible and adhere to 'Best Before' and "Use By" dates. Do- T ake off any unusable leaves on vegetables and wipe of f any soil. Do- Leave lettuce, cabb[...]

14 INST ALLA TION INSTRUCTIONS - DET AILED STEP BY STEP NOTE 1) Height of the product can be adjusted by the help of adjustable feet (front and back) to fit the furniture niche height (B). 2) Do not operate this appliance until it has been installed in the furniture.[...]

15[...]

16[...]

17[...]

18[...]

19[...]

20 GUARANTEE DET AILS Y our new Belling product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional replacement parts, but excluding consumable ite[...]

21 Recycling This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional auth[...]

Fully Integrated Larder ILF 800 PERFORMANCE Energy efficiency class Energy consumption - Kwh/year Net storage - vol fresh food ltrs (cu.ft.) T otal net vol - ltrs (cu.ft.) Frozen food compartment rating Conservation time from failure Freezing capacity fresh food - kg Climate class Operating noise level dB(A) Net storage - vol frozen food ltrs (cu.f[...]

23 WIRING DIAGRAM[...]

57 1540 0000 / AB 0844 815 3746 In case of dif ficulty within the UK, please call Belling Customer Care Centre Helpline on When you dial this number you will h ear a recorded message and be given a number of options. This indicates that your call has be en accepted and is being held in a queue. Calls are answered in strict rotation as our Customer [...]