Bissell 92L3 manual

USER’S GUIDE 92L3 SERIES 3 Safety Instructions Product View Assembly Operations Maintenance and Care T roubleshooting Consumer Services Replacement Parts 4 5-6 6-10 11-16 16-17 18 18 Additional Accessories Warranty 19 20 PowerClean ® BAGLESS V ACUUM ug110-4054_92L3_608.indd 1 ug110-4054_92L3_608.indd 1 8/8/08 2:36:26 PM 8/8/08 2:36:26 PM[...]

2 T hanks for buying a BISSELL Vacuum 2 www .bissell.com 800.237.7691 W e’re glad you purchased a BISSELL vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Y our BISSELL vacuum is well made, and we back it with a limited one year warranty . We also stand behind it w[...]

3 I MPOR T ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, inc luding the following: READ ALL INSTRUCTIONS BEFORE USING Y OUR UPRIGHT V ACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance. W ARNING: T o red[...]

4 www .bissell.com 800.237.7691 Handle Power Switch Easy Empty ™ Dirt Container Headlight Height Adjustment Knob Foot Window W ashable Pre-Motor Filter Carry Handle Lock ‘n Seal ® Lever HEP A Media Post Motor Filter Wide Cleaning Foot Upper T ank Inner Cyclone Power Cord Crevice T ool Dusting Brush/ Upholstery T ool T wist ‘n Snap™ Hose Ha[...]

5 www .bissell.com 800.237.7691 The only tool you’ll need to assemble your vacuum c leaner is a Phillips screwdriver . Attach handle to vacuum 1 . Locate the handle and cord wrap. Remove the screw packet taped to the handle. 2. Stand the vacuum upright and from the rear of the unit, slide the base of the handle firmly into the grooves at the top [...]

Attach vacuum hose and tools 1. Attach the T wist ‘n Sna p™ Hose by lining up the tabs on the base with the corresponding notches on the back of the vacuum as shown. 2. T urn the T wist ‘n Snap Hose to the right to lock the hose into place. 3. Grasping the Quick Reach Handle, slide the end of the Hose Wand onto the Hose Wand Base. Sna p the H[...]

Handle positions Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three c leaning positions. 1. Upright – For storage and above floor cleaning with tools. 2. Normal Cleaning – Press handle release pedal once. Position used for most household floor cleaning tasks. 3. Lo[...]

T ransporting cleaner 1. T o move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward. 2. The cleaner can also be moved by using the carry handle. Special on-board tools Y our vacuum is not only a powerful carpet and rug cleaner , it’s also a versatile above floor vacuu[...]

Special on-board tools (continued) Crevice T ool: Use in tight narro w spaces. Extension Wand: Use with desired attachment for a longer reach. Hose Wand: Use with desired attachment for a longer reach or for cleaning hard to reach places. T urboBrush: Use rota ting brush action for small flat areas such as cushions and beds. NOTE: Press gently down[...]

Power cord usage 1. T o use your vacuum, remove the cord and plug it into an electrical outlet. For your convenience, there is a quick release cord wrap for easy cord removal. There is also a cord clip that is part of the upper cord wrap where you can attach the cord when vacuuming. 2. When you are finished cleaning, turn vacuum cleaner off. 3. Unp[...]

T o maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters frequently . Perform the following maintenance steps: 1. Empty the dirt container when the dirt reaches the “Full” line on the container , or more frequently to prevent overfills. Fo[...]

1. Unplug the vacuum from electrical outlet. 2. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container . If the filter becomes dirty , pull out the tray , lift out the foam filter pad and clean it. NOTE: The pre-motor filter may be hand washed in cold water with mild detergent.[...]

13 www .bissell.com 800.237.7691 M aintenance and care Replace drive belt 1. Unplug the vacuum from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (Steps 1-4 of check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley . Discard the old drive belt. 3. Place new drive belt over motor p[...]

14 www .bissell.com 800.237.7691 M aintenance and care Replacing lightbulb 1. Unplug the vacuum from electrical outlet. 2. Using a screwdriver , first remove 2 screws on either side of lens and pull out to remove the lens. 3. Remove the bulb from the socket by grasping the bulb and pulling gently . Install the new bulb by pushing it gently into the[...]

15 www .bissell.com 800.237.7691 M aintenance and care Clearing clogs Low suction or poor pickup may be due to a clog in the vacuum c leaner . If you notice a change in the sound of the motor , check for c logs. 1. Unplug the vacuum from electrical outlet. 2. Empty dirt container . 3. Check upper tank for build up or clogs. 4. If you notice a clog [...]

16 www .bissell.com 800.237.7691 T roubleshooting Vacuum c leaner won’t run Possible causes Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker W ARNING: T o reduce the risk of electric shock, turn power OFF and disconnect polarized plug from electrical outlet[...]

17 www .bissell.com 800.237.7691 T roubleshooting Vacuum c leaner won’t run (continued) Possible causes Remedies 3. Damaged power cord 3. Unplug, check for damage, replace as necessary Vacuum c leaner and tools won’t pick up dirt Possible causes Remedies 1. Incorrect height adjustment 1. Adjust powerfoot to correct height 2. Hose not attached t[...]

16 www .bissell.com 800.237.7691 18 1 For information about repairs or replacement parts, or questions about your warranty , call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare , Inc . PO Box 3606 Grand Rapids MI 49501 A TTN: Consumer Ser vices Or visit the BI[...]

16 www .bissell.com 800.237.7691 19 123 45 These items are available for purchase as accessories for your BISSELL P owerClean: T o purchase call 1-800-237-7691 or visit www.bissell.com. Item Part No. Part Name 1 203-1056 Crevice T ool 2 203-1059 Dusting Brush/Upholstery T ool 3 203-1429 T urboBrush 4 203-1068 Extension Wand 5 203-1216 T wist '[...]

16 www .bissell.com 800.237.7691 20 www .bissell.com 800.237.7691 W arranty - BISSELL PowerClean ® V acuum This warranty gives you specific legal rights, and you may also have other rights which may var y from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover , please contact B[...]