Bloomfield 1226 manual

p/n 76580 Rev. D ECN-12888 M712 05 0616 cps 712 OWNERS MANUAL for HOT WATER DISPENSER 2 GALLON MODELS: 1222 1222CA 5 GALLON MODELS: 1225 1226 Includes: Installation Operation Use & Care Servicing Instructions Model 1222 Dispenser PRINTED IN UNITED STATES OF A M ERICA[...]

NOTE: For your protection, please note that equipment in this shipment was carefully inspected and packaged b y skilled personnel before le aving the factory. Upon acceptance of this shipm ent, the transportation company assumes full responsibility for its safe delivery. IF SHIPMENT ARRIVES DAMAGED: 1. VISIBLE LOSS OR DAMAGE: Be certain that any v [...]

MODEL VOLTS 1ø 50/60Hz WAT T S AMP S 1ø POWER SUPPLY CORD 1222 120 1800 15.0 NEMA 5-15P 1222CA k 120 1500 12.8 1225 k 208 4000 19.0 1226 k 240 4000 16.5 NEMA 6-30P 1 TABLE OF CONTENTS SPECIFIC A TIONS Thank Y ou for purcha sing this Bloomfield Industries appliance. Proper installation, professional operation and consistent maintenance of this app[...]

FE AT U R E S AN D OP E R ATI NG CO NT R O L S 2 712 76580 Owners Manual H ot Water Dispenser[...]

PRECAUTIONS A ND GENERA L INFORMATION 3 WA RNI NG : Electric Shock Hazard All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which require the use of tools. Failure to heed this warning can result in electrical shock. WA RNI NG : Injury Hazard All installation p[...]

INSTALL A TION 4 RE A D THIS C A REFULL Y BEFORE ST A RTING THE INST AL LA TION REFER TO EXPLODED VIEWS PAGE 14 FOR COMPONENT NAMES/NUMBERS. Unpack the unit. Inspec t all components for completeness and condition. Ensure that all packing materials have been removed from the unit. LEVELING THE UNIT Two Gallon Dispenser is NOT provid ed w ith adjusta[...]

INSTALLATION (continued) 5 NOTE: This equipment must be installed to comply with applicable federal, state an d local plum bing codes and ordinanc es. WARNING ELECTRIC SHOCK HAZARD: Dispenser must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line will provide suc h a ground. Electrical shock will cause death or se[...]

OPERATION 6 Fig. 3 Dispenser Operation Diagram A. ST ART- UP For initial start-up, or if the di spenser has not been u sed for an exte nded period of time: ♦ Be su re the water suppl y is properl y connected and the water suppl y valve is turned ON . ♦ Be sure t he W ATER TANK IS FILLED. IMPORTANT: Fill the water tank before energizing tank hea[...]

CLEANING I NSTRUCTIONS PROCEDURE: Clean Hot Water Dispenser PRECAUTIONS: Disconnect dis penser from electric pow er. Allow dispenser to cool. FREQUENCY: Dail y TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Bristle Brush 1. Discon nect dispenser f rom electric pow e r. Allo w to cool before clea ning. 2. W ip e exte rior of dispenser w ith a sof[...]

TROUBLESHOOTING SUGGEST IONS SUGGESTED REMEDY Check po w er supply cord Check / reset circuit breaker Press switch to "ON" Adjust thermostat for desired tem perature Allow to cool hi-limit will self- reset Examin e wiring & connec tors, controller, pow er board and heating element Repair/replace as need ed Turn water supp ly O N Clean[...]

SERVICING IN STRUCTIONS CA UTI ON Electric Shock Hazard Opening acce ss panels on this dispenser may expo se uninsulated electrical components. Disconnect dispenser from electrical power before removing any pan el. ACCESS PANELS REAR PANEL: Remove r ear panel to acces s hot water tank, thermostat, heating elements, tubing, w ater leve l cont rol a [...]

SERVICING INST RUCTIONS (continued) TEMPERATURE ADJUSTMENT Check temperature at discharge of faucet. Remove thermostat access button plug to access thermostat. Turn thermostat shaft clock w is e to increase temperature. REMOVE TANK LID ASSEMBLY Unplug dispen ser or turn circuit breaker OFF . Tur n OFF w ater supply. Remove rear panel. Disconnect fi[...]

SERVICING INSTRUCT IONS (continued) IMPORTANT: When replacing heating element, also replace seal gaskets . NOTE: Any abrasion or roughness on the flat end of the seat cup will re quire replacing the seat cu p: REPLACE HEATING ELEMENT Remove t ank lid assembly as detailed on p age 10. Remove two he x nu ts holding element to cover. Pull element from[...]

CA UTIO N - CH EMICA L BURN HA ZAR D Deliming chem icals are caustic. W ear ap pr op riate protect ive gloves and goggles during this procedure. Never siphon deliming chemicals or solutions by mou th . This operation should only be perfo rme d by qualified an d experienced service personnel. IMPORT ANT: DO NOT spi ll, splash or pour water or delimi[...]

EXPLODED VIEWS A ND P A RTS LISTS 13 SERVICE KITS FAUCET REPAIR KITS 84686 Faucet & Shank Complete 8700-25 L Seat Cup (only) SOLENOID REPAIR KITS 83612 Solenoid Complete, Single 120V (1222, 1222CA) 83760 Solenoid Complete, Single 240V (1225, 1226) 85218 Inlet Fitting Kit (includes cap, fitting, washer & screen) 85219 I nlet Strainer (only )[...]

EXPLODED VIEW & PARTS LIST 14 NOTE: Model 1225/1226 shown. Model 1222/1222CA is similar. 712 76580 Owners Manual H ot Water Dispenser[...]

EXPLODED VIEW & PART S LIST (continued) 15 ITEM DESCRIPTION 1222 P/N 1222CA P/N 1225 P/N 1226 P/N 1 WRAP, B ODY 2 TANK ASSY 3 PANEL, TOP BACK 4 PLUG, BU TTON 7/8" 8705-36 8705-36 8705-36 8705-36 5 SUPPORT, TANK 6 LIGHT, PILOT GREEN 8718-31 8718-31 8718-31 8718-31 7 LABEL, HW DISPENSER 8 LIGHT, PILOT AMBER 61178 61178 61178 61178 9 CONTROL,[...]

WIRING DIAGRA M 16 2-GALLON MODELS 1222 and 1222CA 712 76580 Owners Manual H ot Water Dispenser[...]

WIRING DIAGRA M (continued) 17 5-GALLON MODELS 1225 and 1226 712 76580 Owners Manual H ot Water Dispenser[...]

Bloo mfiel d Indu str i es, Inc. Division of Carrier Co mmercial Refrigeration In US and Can ada T elep hone: 775 -689- 5700 Fa x: 888-492 -2783 Fa x: 800-356 -5142 () websi te: www . wellsbl oomfi eld. com fo r orders onl y Bloomf ield I ndustr ies p roudly suppo rts CFESA Commerc ial Food Equ ipment Serv ice Associa tio n PRINTED IN UNITED STATES[...]