BTC BCE5232IA manual

Dual Digital Drive CD-RW 5232IA User’s Manual[...]

DANGER INVISIBLE LASER RADIATION WHEN O PEN AVOID DIRECT EXPOSURE TO BEAM VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN ATTENTION RADIATIO N DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYO NS. Copyright Statement It is a criminal offence, under applicabl e copyright law s,[...]

FCC Compliance Statement This device complies with Part 15 of the FCC Ru les. Operation is subject to the following two condit ions: 1. this device ma y not cause harmful i nterference, and 2. this device must accept any interferen ce received, including interference that may cause undesired operat ion. FCC Warning Statement This equipm ent has bee[...]

Table of Contents INTRODUCTION 1 S YSTEM R EQUIREMENTS 2 P ACKAGE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWARE I NSTALLATION 4 D RIVER I NSTALLATION 6 For the CD-RW Drive 6 For the Card Reader 6 S OFTWARE I NSTALLATION 9 Windows Environment 9 CONNECTION & OPERATION 10 F RONT P ANEL 10 R EAR V IEW 12 TECHNICAL DATA 14[...]

Dual Digital Drive 1 INTRODUCTION Thank you for the purchase of CD-RW 5232IA, a perfect and compact dual storage drive with the combination of an IDE CD-ReWritable drive and a USB-connected card reader. CD-RW 5232IA backs up all writing modes and different CD formats. It supports maximum 52x speed writing ability on CD-R discs, 32x speed on CD-RW d[...]

Dual Digital Drive 2 System Requirements For IBM compatible PCs, the syst em requirements recommended are as follows: ♦ Pentium II 350MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦ IDE host interface supporting ATAPI MMC command & USB host interf[...]

Dual Digital Drive 3 INSTALLATION Host Interface Connections Most current mainboards have two IDE ports (primary and secondary) which can connect two IDE cables. Tw o IDE cables allow you to connect up to four devices, but it is reco mmended that you separate IDE ports for your hard drive and your CD-ReWritable dr ive. This will ensure that your ha[...]

Dual Digital Drive 4 Hardware Installation 1. Turn off the power to the computer system. 2. Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer. 3. Insert the drive into one of the vacant 5.25" drive bays and secure it with screws to your PC. 4. Connect one end of the 40-pin IDE ca[...]

Dual Digital Drive 5 6. Connect the USB cable at the back of the drive to the USB connector on the mainboard. The red wire of the cable needs to plug into Pin 1 on the board.  This drive supports USB 1.1 and if you connect to USB 2.0 connector, only tran sfer rate of USB 1.1 will be a vailable. IDE RED WIRE MOTHER BOARD USB RED WIRE 7. Re-attach[...]

Dual Digital Drive 6 Driver Installation For the CD-RW Drive For the CD-RW drive itself of CD-RW 5232IA, it is an IDE device supporting Plug & Play, and Windows 98SE/ME/2000/XP can automatically detect the drive and load the appropriate driver. For the Card Reader Windows 98SE/2000 If you run Window 98SE or 2000, please install the provided dri[...]

Dual Digital Drive 7  Click “OK” if you have already had USB cabl e connected (Refer to Hardware Installation, St ep 6.)[...]

Dual Digital Drive 8  Make sure to restart your computer. Windows ME/XP Since Windows ME and XP already have USB Mass Storage support, the card reader can be detected and wo rk fine without installing driver. However, we recommend that you in stall the provided driver to have more explicit operation status of the card reader, as described below.[...]

Dual Digital Drive 9 After the driver installation, 4 extra ic ons with different card type indicated will show in Device Manager/My computer. And then you can use each slot of the card reader for file archiving/recording. While the card reader is reading data of memory cards, the icon for the card accessed will light up and the LED beside the card[...]

Dual Digital Drive 10 CONNECTION & OPERATION Front Panel 1 2 7 83 4 9 10 11 6 5 1. Headphone Jack By plugging in the headphone jack here, you can listen to an audio CD (CD-DA disc) directly playing from the drive. 2. Headphone Volume Control This knob adjusts the audio output level. Turn the wheel to the right/left for the volume control of you[...]

Dual Digital Drive 11 Flashes “ red ” while writing a CD-R/CD-RW disc. 6. LED Indicator (card reader) Once the USB cable is correctly connected, this LED will light yellow , which means the card slots are ready to use. 7. Slot for Memory Stick (MS)/Memory Stick Pro (MS Pro) 8. Slot for Secure Digita l (SD)/MultiMediaCard (MMC) 9. Slot for Compa[...]

Dual Digital Drive 12 Rear View 6 34 5 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connec t the drive to your sound card with a 4-pin audio cable. 3. [...]

Dual Digital Drive 13 5. Pow er Supply Connector By plugging the computer’s power supply cable here, you can connect the drive and your computer system. 6. USB Cable Connect the USB cable to the U SB connector on the mainboard. The red wire of the cable needs to plug into Pin 1 on the board.[...]

Dual Digital Drive 14 TECHNICAL DATA Interface CD-RW Drive: IDE Card Reader: USB 1.1 Form factor 5.25" Half Height Writing speed CD-R: 8X/16X/24X/32X /40X/48X/52X CD-RW: 4X/10X/12X/16X /20X/24X/32X Writing modes TAO (Track at once), DAO (Disc At Once), SAO (Session at once), Multi-session, Incremental Packet Writing Digital Media CompactFlash,[...]

Dual Digital Drive 15 Access time 90ms at ⅓ stroke(52X CD-ROM) 180ms at full stroke(52X CD-ROM) 99ms at ⅓ stroke (32X CD-RW) 200ms at full stroke (32X CD-RW) Disc loading Tray (motorised), Dust Sealed Audio output level Line out = 0.6 ± 10%Vrms Headphone out = 0.6± 10%Vrms Power 5 VDC & 12VDC Card Reader power directly from computer power[...]

Dual Digital Drive 16 Environment CD-RW Drive Temperature Operating 5°C to 45°C Non-operating -20°C to 60°C Humidity Operating 8% ~ 80%RH Non-operating 5% ~ 95%RH Card Reader Temperature Operating 0°C to 40°C Non-operating -20°C to 45°C Humidity Operating 0% ~ 90%RH Non-operating 0% ~ 95%RH[...]

3100551760 Version 1.0 June 2003[...]