Casablanca Fan Company 6643Z manual

1 P/N 6643Z HN0210 BEFORE YOU ST ART ..................................................................................................................................................................... 5 SAFE USE.........................................................................................................................................[...]

2  Plate     Please take a moment to locate the model number and serial number from your fan (see below) and record this informatio[...]

3 P anama ® Item # Des cripti on Pict ure ( not to sc ale ) Quant ity 1 . Moto r Housing 1 2. Ceili ng plate 1 3. Phillips S crewdri v e r 1 4. 1 1 / 2 " x 8-32" Roundhead screws and W ashers , 2 E A 5. Screw Pack: Lag Screw and W asher (1) 1 E A 6. Wire Nuts (4), 4 7 . Canopy and Canopy Hatch 1 8. Perma•Lock™ Downrod and Ball Assemb[...]

4 Item # Des cripti on Pict ure ( not to sc ale ) Quant ity 1 1. Blad e Irons 5 1 2. Blade Iron Screws 1 1 1 3. Blade Screws and W ashers 16 EA 1 4. Light Pull Chain Switch (G model only) 1 1 5 . Light Pull Chain Fandangle (G model only) 2 - ( 6 6x xG ) 3 - ( 6 6Dx xG) 16. W-41 Single Rotary (optional for G model only) 1 1 7 . W -81 Dual Rotary (op[...]

5 P anama ® Circuit Breaker (T rip breaker for the circuit you will be working on) Fuse Box (Remove fuse for the circuit you will be working on) 18" 70" SAFE USE  CAUTION: RISK OF ELECTRICAL SHOCK! Installation is to be in accordance with the National Electrical Code, ANSI/NFP A 70-1999 and local codes. If you are unfamiliar with the [...]

6 MOUNTING RECOMMEND A TIONS SL OPED CEILING INST ALLA TIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you fo[...]

7 P anama ® Using Existing Ceiling Fixture Outlet Box After turning the power OFF at its source (either the circuit breaker or fuse box), lower the old xture and disconnect the wiring. Check the ceiling xture outlet box to be sure it is marked “Approved for Ceiling Fan Mounting.” If it is not, a new box must be installed. GE T TING ST AR[...]

8 Pr epare for fan installation as follow s: 3a. Rout e the wir es from the mot or throu gh the Pe rma  Lo ck™ downrod and ball assembly . 3b. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod . Thread the downrod into the motor coupling until it stops turning, this will take at least four[...]

9 P anama ® Step 5. T o hang the fan body in the canopy , hold the fan body rmly and insert the ball into the canopy open- ing. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball ts in to the pin opposite the canopy opening. NOT E: Independent control of the ligh t xture using a W -81 acc essory con tro[...]

10 Step 6a. Attach the fan wires to the ceiling xture outlet box wiring by twisting the bare ends of the wir es t ogether and then securing with a wire nut. T est that the connection is secure by pulling on the wir e nut. Connect in this order: Step 6b . W -85 W iring Connections     ?[...]

11 P anama ® PROCEED T O Y OUR F AN’ S CONTROL FEA TURE SECTION FOR INST ALLA TION/OPERA TING INSTRUC TIONS :             BLADE/BLADE HOLDER INST ALLA TION Step 10. Attach the blades to the blade hold ers wit h the [...]

12 Pull-chain switches on the fan con trol the fan and lights . Using the fan contr ol pull- chain switch: F an o at start. First pull: fan ON, High speed Second pull: Medium speed Third pull: Medium Low speed Fourth pull: Low speed Fifth pull: F an OFF Using the optional light pull-chain switch: Light o at start. First pull: light ON Second [...]

13 P anama ® R                      by the W-81 wall contr ol.            OF F by the W- 81 and the int ens ity adjusted from low t o high. ?[...]

14 ® 3 W ALL CONTROL AND HARDWARE (not to scale) Switch Mounting Screws (2) W all Plate Screws (2) White (2) Almond White W all Plate(1) W-85 W all Control Switch Bezels (1) White (1) Almond Almond W all Plate(1) (4) Wire Cap Before installing the W-85 wall control you will need to check and see if you will need to change the bezel on the front of[...]

15 ® 3 LOCA TING PINS (4) Figure #5 ALMOND BEZEL BEZEL T ABS BEZEL ALIGNMENT PIN AND HOLE Figure #3 ALMOND BEZEL RUBBER KEY P AD W-85 W all Control Bezel replacement: - CONTINUED Step 17c. Reinstall the rubber key pad on to the four (4) locating pins located on the almond bezel as shown in Figure #3 and #4. Step 17d. T o attach the bezel back on t[...]

16 ® 3     W -85 CONTROL INST ALLA TION 1. Use only the Casablanca W-85 wall control. 2. Do not use any additional control with your Inteli- T ouch 3 fan (for example, dimmer , or fan speed control). 3. Do not use more than one fan per wall control. 4. [...]

17 ® 3 DU AL W8 5 INST ALLA TION T o co nt r ol th e fa n an d li g ht s fr om t wo l oc at i on s (a t hr ee - wa y ci r cu it ) , us e two W-85 w al l c on t ro ls as shown in the wiring diagram in Figure #5. Before installing the two switches into the wall, place both switches side by side, then locate the 4 dip switches on the side of the t[...]

18 ® 3 OPERA TION POWER The button is normally left in the on position. Always turn the power of f during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. The butt on must be left on to retain a previ ously set fan speed or light level. OPERA TION SPEED C ONTROL F AN CONTROL ON - OFF: A [...]

19 ® 3 CHANGING FREQUENCY SET TING NOTE: All fans leave the factory set to “1 1 1 1” Y ou will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately . DIP   SET TO ‘1 11 1’ (Factory Setting[...]

20 ® 3 OPERA TION HOMESAFE ® PR O G RA M The   makes an unoccupied home appear occupied by turning the lights on and off at random times. T o enter the Home-Safe Program: 1) T o operate the lights and fan for Home Safe Program – Press the But- ton off for a least 5 seconds. 2) T urn the on. [...]

21 ® 3 OPERA TION F ANMINDER ™ P R OG R AM The Fan-Minder feature will add to your comfort when used in the bedroom. The program reduces the speed of the fan each two-hour interval to compensate for cooling night air . T o enter the Fan-Minder Program: 1. T urn the OFF for at least 5 seconds. 2. T urn the ON. 3. Immediately operate the button[...]

22 ® 3 Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance. TROUBLESHOO TING TIPS This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, includi[...]