CDA FWC151 manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style FW C1 5 1 / FW C30 1 / FW C60 1 / FW C62 1 W ine Cooler s Manual for Inst allation, Use and Maintenanc e[...]

Important The CDA Gr oup Ltd cannot be held r esponsible for injuries or losses caused by incorr ect use or installation of this product. Please note that CD A reserve the right t o invalidate the guar antee supplied with this product f ollowing incorr ect installation or misuse of the appliance or use in a commer cial envir onment. This appliance [...]

Befor e first use Y ou must allow the appliance t o settle for at least tw enty four hours prior t o switching the po wer on. It is rec ommended that you remove all int ernal and external packaging and clean the interior of the applianc e prior to first use, using a solution of bicarbonate of soda and warm wat er and then thoroughly dry the inter[...]

Use and Contr ols FWC1 5 1 FWC30 1 T o switch the po wer on/o ff Press and hold the pow er button f or five seconds. T o change the temper ature • Press the up or down butt ons until the requir ed temperatur e is shown on the display. • The preset temper ature is 1 2˚C / 54˚ F . • T o change the temperatur e display from F ahrenheit to C e[...]

Use and Contr ols FWC60 1 T o switch the po wer on/o ff Press and hold the light and t emperatur e set buttons simultaneously f or five seconds. T o change the temper ature • Press the temper ature set but ton once to select the upper zone. • The LED display for the upper z one will flash. • Press the up or down butt ons until the requir ed[...]

Use and Contr ols FWC62 1 T o switch the po wer on/o ff Press and hold the pow er button f or five seconds. T o change the temper ature • Press the up or down but tons for the zone until the r equired temperatur e is shown on the display. • The preset t emperatur e is 1 2˚C / 54˚ F . • T o view the set temperatur e, touch the up or down bu[...]

Use Humidity Contr ol (all models exc ept FWC1 5 1) The wine coolers ar e equipped with a humidity control system to maint ain optimal humidity within the wine cooler . Fill the humidity reserv oir approximat ely 3/4 full with water . Place the r eservoir on the runners on the top shelf as shown in fig. 5. Ensure it is locat ed correctly t o preve[...]

Car e and Cleaning Alwa ys disconnect the appliance from the mains electrical supply bef ore an y cleaning or maintenance. • Do not use abrasive pr oducts or detergents. Aft er washing, rinse and dry thoroughly. • The exterior of the appliance and the door seal should be cleaned using mild soapy wat er and dried thoroughly . • The interior ca[...]

T roubleshoo ting If you ha ve any pr oblems with your appliance, you should check the tr oubleshooting guide prior t o calling CD A Customer Car e to pr event unnecessary service calls and po tential cost. If the appliance is not w orking , chec k • There is pow er to the appliance • The house fuses or circuit br eakers are int act and the fus[...]

Installing the wine cooler This appliance is intended t o be installed in a space betw een two units. The minimum space r equired is: FWC1 5 1 – 1 50 mm wide x 555 mm deep x 825 mm high FWC30 1 – 300 mm wide x 580 mm deep x 825 mm high FWC60 1 – 600 mm wide x 580 mm deep x 825 mm high FWC62 1 – 600 mm wide x 580 mm deep x 825 mm high Please[...]

Installation This appliance is designed to fit under w orktops between 820 – 890mm in height, using one of tw o plinth plates to ensur e that the feet ar e concealed fr om view . Installation under a kitc hen w orktop betw een 820-850 mm in height Install the wine cooler as described on page 9. Extend the adjust able feet to bring the wine coole[...]

fig. 7 fig. 8 fig. 9 fig. 1 0 Rev ersing the door I t is possible to r everse the door on this applianc e, if requir ed. T o do so, follow the steps below: 1 . Open the door and remov e the screws (1) securing the bottom hinge to the appliance(6). Support the door t o prevent it fr om falling. 2. Gently pull down the door (5) to r emove it from[...]

Electrical information W arning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1 363A 1 3 amp fused plug. T o change a fuse in this type of plug, follow the steps below: 1 . Remove the fuse cover and fuse. 2. Fit replacement 1 3A fuse, AST A approved to BS 1 362 type, into the fuse cover . 3. Replace fu[...]

13[...]

14[...]

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style T o contact our Customer Car e Department, or for Service, please contact us on the det ails below .[...]