Electrolux FN620K manual

• Assembly • Operation • Maintenance • Service and Adjustments • Storage • Troubleshooting • Repair Parts OWNER'S MANUAL 184873 11.27.02 TR PRINTED IN U .S.A. MODEL NO . FN620K 3.5 HP 17 Inc h Tiller 00137 For P ar ts and Service, contact our authorized distrib utor: call 1-800-849-1297 For T echnical Assistance: call 1-800-829-5[...]

2 • Ne ver operate the tiller without proper guards , plates, or other saf ety protective de vices in place. • K eep children and pets aw ay . • Do not ov erload the machine capacity by attempting to till too deep at too f ast a rate. • Ne ver operate the machine at high speeds on slippery surf aces. Look behind and use care when bac king. [...]

3 CONGRA TULA TIONS on y our purchase of a new tiller . It has been designed, en gi neered and manu fac tured to give you the best pos sible de penda bil ity and per fo r m ance. Should you e xperience any prob lems you can not easily remedy , please contact your nearest authorized service center . W e hav e com pe tent, well-trained tech ni cians [...]

4 ASSEMBL Y OPERA T OR’S POSITION (See Fig. 1) When right or left hand is mentioned in this manual, it means when you are in the oper ating position (standing behind tiller handles). Y our new tiller has been assembled at the f actor y with e xception of those par ts left unassembled f or shipping pur poses. T o ensure saf e and proper operation [...]

5 ASSEMBL Y TILLER HANDLES CABLE HANDLE P ANEL BOL TS FIG. 2 HAN DLE P ANEL HEX BOL T 5/16-18X3/4" TILLER HANDLE HEX BOL T 5/16-18X1" FLA T W ASHER LOCK W ASH ER NUT DEPTH ST AKE SUPPORT BOL T HEX BOL TS, LOCK W ASH ERS, AND HEX NUTS DEPTH ST AKE SUPPORT NUT “A” ENGINE BRA CK ET HAL VES FIG. 3 ST AKE SPRING INST ALL DEPTH ST AKE ASSEM[...]

6 KNO W Y OUR TILLER READ THIS O WNER'S MANU AL AND SAFETY RULES BEFORE OPERA TING Y OUR TILLER. Compare the illustrations with y our tiller to familiarize y ourself with the location of various controls and adjustments. Sav e this manual f or future reference . RECOIL ST ARTER HANDLE DEPTH ST AKE TINE SHIELD CHOKE CONTROL FOR W ARD TINE CONTR[...]

7 OPERA TION The operation of any tiller can result in f oreign objects thrown into the e yes, which can result in severe e ye damage . Alwa ys wear safety glasses or eye shields bef ore star ting y our tiller and while tilling. We recommend a wide vision saf ety mask over spectacles or standard saf ety glasses. TRANSPORTING Y OUR TILLER CA UTION: [...]

8 OPERA TION FIG. 7 OIL FILLER PLUG OIL LEVEL T O ST ART ENGINE (See Fig. 8) CA UTION: Keep drive contr ol bar in “DISENGA GED” position when start- ing en gine. When star ting engine f or the fi rst time or if engine has run out of fuel, it will take e xtra pulls of the recoil star ter to mov e fuel from the tank to the engine. • Mak e sure[...]

9 OPERA TION • Y ou will fi nd tilling much easier if you lea ve a ro w un- tilled between passes. Then go back betw een tilled rows . (See Fig. 9) There are two reasons f or doing this. First, wide tur ns are much easier to negotiate than about-f aces. Sec ond, the tiller won’t be pulling itself , and you, to ward the row ne xt to it. • Set[...]

10 GENERAL RECOMMEND A TIONS The warranty on this tiller does not co ver items that ha ve been subjected to operator ab use or negligence. T o receiv e full value from the w arranty , operator must main tain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tiller . All adjustments in [...]

11 MAINTENANCE FIG. 12 AIR CLEANER (See Fig. 13) Ser vice air cleaner car tridge e ver y twenty-fi ve hours, more often if engine is used in very dusty conditions. • Loosen air cleaner screws, one on each side of cov er . • Remo ve air cleaner cov er . • Carefully remov e air cleaner car tr idge. Be care ful. Do not allow dir t or de bris to[...]

12 MUFFLER Do not operate tiller without muffl er . Do not tamper with e xhaust system. Damaged muffl ers or spark arresters could create a fi re hazard. Inspect pe ri odi cally and re place if nec es sar y . If y our engine is equipped with a spar k arrester screen assembly , re mov e ev er y 50 hours f or cleaning and inspection. Re place if d[...]

13 TILLER T O ADJUST HANDLE HEIGHT (See Fig. 15) F actor y assemb ly has provided lowest handle height. Se lect handle height best suited f or your tilling conditions. Handle height will be diff erent when tiller digs into soil. • If a higher handle height is desired, loosen the f our nuts securing handle panel to engine brack ets. • Slide hand[...]

14 SER VICE AND ADJUSTMENTS TINE OPERA TION CHECK (See Fig. 21) Be sure tines do not rotate when engine is running and tine control is in the “OFF” position. W ARNING: Disconnect spark plug wire from spark plug to pre vent star ting while chec king tine operation. FINAL CHECK “OFF” POSITION • With tine control “OFF” (up), push down on[...]

15 SER VICE AND ADJUSTMENTS V -BEL T IDLER PUL LEY TRANS MIS SION PUL LEY BEL T GUIDE ENGINE PULLEY BEL T GUIDE T O REPLA CE V -BEL T (See Fig. 23) Replace V -belt if it has stretched considerab ly or if it has crac ks or fray ed edges. Belt guard must be remo ved to ser vice belt. See “T O RE- MO VE BEL T GU ARD” in this section of manual. BEL[...]

16 ST ORA GE ENGINE OIL Drain oil (with engine w ar m) and replace with clean oil. (See “ENGINE” in the Maintenance section of this man ual). CYLINDER(S) • Remo ve spark plug. • P our 1 ounce (29 ml) of oil through spar k plug hole into cylinder . • Pull star ter handle slowly se veral times to distrib ute oil. • Replace with ne w spar [...]

17 Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly . 2. See “T O ST ART ENGINE” in the Operation section. 3. Engine fl ooded. 3. Wait se veral min utes before attempting to star t. 4. Dir ty air cleaner . 4. Clean or replace air cleaner car tridge. 5. Water in fuel. 5. Drain fuel tank and carburetor , and [...]

18 REP AIR P AR TS TILLER - - MODEL NUMBER FN620K HANDLE ASSEMBL Y 1 137176X505 Brack et, Handle 2 72140512 Bolt, Carriage 5/16-18 UNC x 1-1¦2 3 9266R Grip, Handle 4 151473 Handle, L.H. 5 73680500 Lockn ut, Crown 5/16-18 6 19111116 W asher 11/32 x 11/16 x 16 Ga. 7 19121414 W asher 3/8 x 7/8 x 14 Ga. 8 74760516 Bolt, He x Hd. 5/16-18 x 1 9 74760512[...]

19 REP AIR P AR TS TILLER - - MODEL NUMBER FN620K BEL T GU ARD AND PULLEY ASSEMBL Y KEY P ART NO . NO . DESCRIPTION 16 12000035 Ring, Klip 17 73350600 Nut, He x, Jam 3/8-16 18 161806 Pulley , Idler 19 175377 Ar m, Idler 20 74760620 Bolt, He x 3/8-16 x 1-1/4 21 106968X Shaft, Idler Ar m 25 73350500 Nut, He x, Jam 5/16-18 KEY P ART NO . NO . DESCRIPT[...]

20 REP AIR P AR TS TILLER - - MODEL NUMBER FN620K WHEEL AND DEPTH ST AKE ASSEMBL Y 1 9194R Pin, Cle vis 2 74760520 Bolt, He x 5/16-18 x 1-1/4 3 74760512 Bolt, He x 5/16-18 x 3/4 4 73220500 Nut, He x 5/16-18 5 10040500 W asher , Lock 5/16 7 4921H Clip , Hair pin 8 318J Suppor t, Depth Stake , R.H. 9 9193R Stake , Depth 10 9551R Rivet, Drilled 13 317[...]

21 KEY P ART NO . NO . DESCRIPTION 1 165774 Tine, Outer , R.H. 2 4921H Retainer , Spring 3 165772 Tine, Inner , R.H. 4 165771 Tine, Inner , L.H. 5 165773 Tine, Outer , L.H. 6 9194R Pin, Cle vis KEY P ART NO . NO . DESCRIPTION REP AIR P AR TS TILLER - - MODEL NUMBER FN620K TINE ASSEMBL Y[...]

22 REP AIR P AR TS TILLER - - MODEL NUMBER FN620K TRANSMISSION KEY P ART NO . NO . DESCRIPTION 16 19091412 W asher 9/32 x 7/8 x 12 Ga. 17 19092016 W asher 9/32 x 1-1/4 x 16 Ga. 18 10040400 W asher , Lock 1/4 19 74610412 Bolt, He x 1/4-28 x 3/4 Gr . 5 20 - - - - - - - Engine, Briggs Model 94202 (Order par ts from engine Manuf ac- turer) KEY P ART NO[...]

23 KEY P ART NO . NO . DESCRIPTION 1 132629 Decal, Logo 2 163989 Decal, Logo 4 127185X Decal, Descr iption 5 110613X Decal, Tine Control 6 110614X Decal, Hand Placement 8 120076X Decal, W ar ning, Rotating Tines 9 171803 Decal, Briggs & Stratton 10 171806 Decal, 3.5 HP 11 162384 Decal, W ar ning 12 165327 Decal, Speed Control - - 184873 Manual,[...]

00137 LIMITED W ARRANTY The Manuf acturer warrants to the original consumer purchaser that this product as manuf actured is free from de- f ects in mater ials and work man ship. For a period of two (2) y ears from date of purchase by the original consumer purchaser , we will repair or replace , at our option, without charge for par ts or labor incu[...]