Emerson CF2500TG01 manual

READ AND SA VE THESE INSTRUCTIONS “Botanica” Series Model No. CF2500OB01 CF2500HTW01 CF2500S01 CF2500TG01 Botanica Series Ceiling Fan Owner's Manual Part No. F40BP72200003 Form No. BP7220-3 ® Net Weight: 20.0 Lbs .[...]

2 W ARNING ! WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2 . Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on [...]

1. Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following: a. Fan motor and housing assembly b. One motor cover c. One ceiling cover d. Five blade flanges e. One hanger ball/downrod assembly f. One hanger bracket g. One switch housing cover assembly h. One uplight le[...]

Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capa- ble of withstanding a load of at least 50 pounds. If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 4 SECTI[...]

NOTE: Make sure the unused black motor lead is capped with a wire connector. Make sure all wire connectors are completely inside motor coupling cover and not pinched between the motor coupling cover and motor. 9. Screw two 1” threaded studs (supplied) into the motor (Figure 6). Leave approximately 7/8” of the stud extending above the motor. Sli[...]

17. Reinstall the switch housing assembly by passing the wires from the motor shaft through the collar, screw the assembly onto the motor shaft (Figure 11). Tighten the setscrew using the 5/32” hex wrench (supplied). Engage the connector from the switch housing to the motor connector. The two connectors are keyed and must be mated correctly befor[...]

18. Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 13). 7 CEILING FLOOR A T LEAST 7' Figure 12 TWO SCREWS SUPPLIED WITH OUTLET BOX HANGER BRACKET TA B OUTLET BOX OUTLET BOX HANGER BRACKET HANGER BALL/ DOWNROD ASSEMBL Y NOTE: CEILING COVER, SUPPL Y WIRES AND F AN WIRES OMITTED FOR [...]

22. Securely connect the wiring harness connector to the receiver connector, and connect the blue and yellow wires to the blue and yellow wires from the receiver (Figure 4). 23. Turn the receiver so that the flat side aligns with the open side of the hanger bracket (Figure 15). Fold and position the wires into the space above the hanger ball and in[...]

14. Use three 10-24 x 3/8" pan head screws and flat washers (supplied) to secure flange to blade (blades ordered separately) (Figure 22). Repeat for the remaining four blades. 15. Using the 5/32” hex wrench (supplied), loosen the setscrew in the collar and unscrew (counterclock- wise) the switch housing assembly from the motor shaft (Figure [...]

20. Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 27). 10 CEILING FLOOR A T LEAST 7' Figure 26 TWO SCREWS SUPPLIED WITH OUTLET BOX HANGER BRACKET TA B OUTLET BOX Figure 27 19. Reinstall the switch housing assembly by passing the wires from the motor shaft through the collar, scre[...]

11 NOTE: If you are installing a SR330 Remote Control or a SW350 Wall Control to operate the fan and light, refer to the installation instructions and wiring diagrams shown in Section A of this Owner’s Manual . 22. For a wall control installation you will need a three-wire (with ground) conductor cable between the ceiling and wall outlet boxes. T[...]

Attaching Light Kit To install an Emerson accessory light kit, remove the four screws securing the switch housing cover assembly to the switch housing. Remove the trim medallion from the bottom of the switch housing cover (Figure 32). Attach the light kit to the switch housing cover assembly with the lockwasher and nut supplied with the light kit ([...]

T r ouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. WARNING: Make sure main power is turned off. 2. Loose power line connections to the fan, 2. Check line wire connections to fan and or loose switch wire connections in the swi[...]

1 2 15 3 20 18 4 26 9 8 30 19 20 29 27 22 13 14 17 5 23 24 7 12 11 28 10 25 6 21 16 19 Repair Par ts 14 ACCESSORIES 1. Ceiling Fan Light Kits (see store or catalog). 2. Ceiling Fan/Light Controls (see store or catalog). 3. Downrod Extension Kits (see store or catalog). Before discarding packaging material, be certain all parts have been removed. HO[...]

15 Repair Par ts List Ref. Botanica Models N o. Description CF2500OB01 CF2500S01 CF2500HTW01 CF2500TG01 Hanger Pack, 761655-9 761655-16 761655-12 761655-13 containing: 1 Bracket, Hanger (1) — — — — 2 Hanger Ball Assembly (1) — — — — 3 Downrod (1) — — — — 4 Cover, Ceiling 761620-9 761620-24 761620-12 761620-23 5 Hub, Rubber 7[...]

Part No. F40BP72200003 Printed in Taiwan 04/03 Form No BP7220-3 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of C[...]