Emerson CF820PW00 manual

READ AND SA VE THESE INSTRUCTIONS Part No. F40BP73510000 Form No. BP7351 U.L. Model No.: CF820 Net Weight: 37.0 Lbs. Model Numbers LA F A YETTE ™ Ceiling F an Owner's Manual CF820ORB00 Oil R ubbed Br onze CF820PW00 P ewter[...]

2 WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference 2. Before attempting installation, servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power fro[...]

3 This Manual Is Designed to Make it as Easy as Possible for Y ou to Assemble, Install, Operate and Maintain Y our Ceiling Fan One stepladder One wire stripper One Phillips head screwdriver Four 15-watt (max.) candelabra base bulbs (not supplied) Three 40-watt (max.) candelabra base bulbs (not supplied) MA TERIALS Wiring outlet box and box connecto[...]

1. Place the flange onto the blade. Secure the flange to the blade using the four #10-32 x 8mm pan head screws and four #10 flat washers (supplied). Repeat for the four remaining blades. (Figure 1) 2. Place the upper glass shade into the styrofoam for fan motor assembly. 3. Attach the fan motor assembly to the upper glass shade using the four #10-3[...]

14. Obtain the hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 6). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 25. Discard the 12” downrod if using the 6” downrod. [...]

17. Loosen the two setscrews in motor coupling if necessary. Separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the desired downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 7). The clevis pin must go thro[...]

7 The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support of 50 lbs. or Less”. WARNING Ho w to Hang Y our Ceiling F an A T LEAST 7' FLOOR CEILING Figure 12 The fan must be hung with at least 7' of clearance from floor to blades (Figur[...]

8 OUTLET BOX BLACK SUPPL Y WIRE BLACK/WHITE RECEIVER WIRE BLACK F AN WIRE BLUE F AN WIRE BLUE RECEIVER WIRE YELLOW F AN WIRE YELLOW RECEIVER WIRE CEILING COVER WHITE RECEIVER WIRE WHITE F AN WIRE WIRE CONNECTOR RECEIVER WHITE SUPPL Y WIRE SUPPL Y GROUND WIRE (GREEN OR BARE) HANGER BALL GROUND WIRE (GREEN) HANGER BRACKET GROUND WIRE (GREEN) HANGER B[...]

Switch Housing Installa tion 4. After connections have been made, separate the white and green wires from the black, blue and orange wires. 5. Carefully turn the wires upward and insert them up through the open side of the hanger bracket and into the outlet box. Push the green equipment/earth ground and white grounded neutral wires into one side of[...]

1. Remove the center housing plug from the switch housing for downlight kit assembly. 2. Slide the two connectors and wires from the downlight kit assembly into the switch housing hole (Figure 20). 3. Screw the downlight kit assembly onto switch housing. Install hex jam nut and nut (supplied in parts bag) onto threaded nipple inside of switch housi[...]

The SW116 wall control transmits the command signals via radio waves to the SW105 receiver installed in the ceiling fan ceiling cover. The SW105 receiver is required for the SW116 wall control to function. Power for the SW116 wall control comes from the 12V battery, located in the wall control. Replacement 12V batteries recommended are Duracell MN2[...]

Operating Y our Ceiling F an IMPORT ANT Fan installation must be completed, including the installation of the fan blades, before testing of the remote control. Your SW116 Fan/Light Wall Control (Figure 27) has full control of your fan, lights, and airflow direction. 1. To set the desired fan speed, push the HI, MED, or LOW buttons to operate your f[...]

13 T r ouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. WARNING: Make sure main power is turned off. 2. Loose power line connections to the fan. 2. Check line wire connections to fan 3. Fan/Light Wall Control is OFF. 3. Turn ON[...]

14 R epair P ar ts U.L. Model No.: CF820 U.L. Model No.: CF820 28 29 13 30 15 16 1 7 9 3 2 18 6 35 17 24 23 22 19 20 21 33 34 27 31 29 32 5 8 4 H I H I M E D M E D L O W L O W F AN OFF R E V R E V LIGHT 10 11 26 14 25 12[...]

15 R epair P ar ts Listing Key Model No. N o . Description CF820ORG00 CF820PW00 * Hanger Pack, Consisting of: 761655-72 761655-73 1 Hanger Bracket (1) — — 2 Hanger Ball (1) — — 3 Downrod - 12” (1) — — * Parts Bag Containing: 763488 763488 4 Pin, Clevis (1) — — 5 Clip, Hairpin (1) — — 6 Connector Wire Nut, 12 GA (5) — — 7 T[...]

Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Printed in China 02/08 Form No. BP7351 Part No. F40BP73510000 U.L. Model No.: CF820 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson Electric Co. ceiling fan against all d[...]