Enviro C-11256 manual

PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET-BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH. Contact your building or fire officials about restrictions and installation inspection requirements in your area. SHERWOOD INDUSTRIES IS AN ENVIRONMENT ALL [...]

T able of Contents 2 Introduction........................................................................................3 Rating Label Location................................................................3 Fuel Quality ...............................................................................3 Safety W arnings & Recommendations........[...]

3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * R ATING L ABEL L OCATION : The rating label is located on the inside of the hopper . F UEL Q UALITY : Fuel quality is important, please read the following: Your Enviro pellet stove has been designed to burn ” (6mm) dia wood pellets and other[...]

4 Safety W arnings & R ecommend a tions Please read this entire Owner’s Manual before installing or operating your Enviro Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Any unauthorized modification of the appliance or use of replacement parts not recommended by the manufacturer [...]

5 Safety W arnings & R ecommend a tions ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 110-120 volts (4.2 Amps), 60 hertz electrical outlet and also must be accessible. If this power cord should become damaged, a replacement power cord [...]

21 13 / 16 " (554mm) 15 15 / 16 " (404mm) 22 1 / 16 " (561mm) 41 15 / 16 " (1065mm) 42 1 / 2 " (1080mm) 23 13 / 16 " (605mm) 26 1 / 8 " (664mm) 26 3 / 8 " (669mm) 24 3 / 16 " (615mm) Oper a ting Instructions D IMENSIONS & S PECIFICATIONS : Figure 1: Dimensions of Omega. T able 1: Omega Specifications[...]

7 Oper a ting Instructions C ONTROL B OARD F UNCTIONS : 1. ON/OFF BUTTON: Used to turn the unit ON and OFF manually . 2. FUEL TYPE BUTTON: Used to swi tch between fuel type modes; Pellet (for all qualities of wood FEED TRIM ON/OFF FUEL TYPE HEAT LEVEL AUTO/OFF HIGH/LOW MANUAL PELLET C-11256 MULTIFUEL FEED TRIM ON/OFF FUEL TYPE HEAT LEVEL AUTO/OFF H[...]

PRE-BURN CHECK : The burn pot liner holes must be clear and the liner installed properly against the ignitor tube and locked in place. Check the hopper f or enough pellets to start the unit. Note: Fuel T ype can only be changed when the unit is cold. The thermostat mode can be changed during normal operation. The unit has an automatic cleaning cycl[...]

9 the fire. • A tall, lazy flame with dark orange tips requires more air – Open slider (pull out) slightly . • A short, brisk flame, like a blowtorch, has too much air – Close slider (push in) slightly . • If the flame is in the middle of these two characteristics with a bright yellow/orange, active flame with no black tips then the air i[...]

R outine Cleaning and Maintenance The following list of components should be inspected and maintained routinely to ensure that the appliance is operating at its optimum and giving you excellent heat value. The appliance, flue gas connector and the chimney flue require regular cleaning. Check them for blockage prior to re-lighting after a prolonged [...]

Figure 9: Omega Burn Heat Exchanger Cleaning. 11 R outine Cleaning and Maintenance HEAT EXCHANGER TUBES (W eekly) There are two (2) sets of exchanger tube scrapers; the handles are located under the top grill (trivet). Lift the grill and move the handles all the way up and down a few times (ONL Y WHEN THE UNIT IS COLD) in order to clean away any fl[...]

R outine Cleaning and Maintenance EXHAUST PASSAGES (Biannually) 1. Open the firebox door by lifting the handle. 2. Remo ve the burn pot assembly and clean all the parts. 3. Lubricate all screws with penetrating oil. 4. Using a ” socket, remove the two (2) bolts that hold the firebox liner in place. V acuum the firebox and firebox liner thoroug[...]

13 W arr anty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest level of quality and customer service is the most important thing we do. Each Enviro stove is built on a tradition of using only the finest materials and is backed by our Exclusive Lifetime Limited[...]

W arr anty Exclusions and Limitations: 1. This W arrant y does not cover tarnish, discolor ation or wear on the plating or paint. 2. This W arrant y excludes wear and tear or breakage caused by cleaning, mo ving or service on log set. 3. A qualified installer must install this stove or fireplace. This Limited W arranty cov ers defects in materials [...]

15 W arr anty 17 . Damage to plated surfaces caused by fingerprints, scratches, melted items, or other external scores and residues left on the plated surfaces fr om the use of abrasiv e cleaners or polishes is not covered in this warr anty . 18. The Limited W arr anty does not cover tarnish, discolor ation or wear on the plated surfaces. 19. The p[...]

16 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ NAME OF DEALER: _________________________________________ ADDRESS: _________________________________________ ____[...]