Extron electronic DVI 104 RX manual

User ’s Guide DVI 104 Tx/Rx 68-1549-01 Rev . C 10 08 DVI Fiber Optic Extender[...]

Pr ecautions This symbol is intended to alert the user of important opera ting and mainten ance (se rvicing ) instru ctions i n the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. Caution Rea[...]

安全须知 • 中文 这个符号提示用户该设备用户手册中 有重要的操作和维护说明。 这个符号警告用户该设备机壳内有暴 露的危险电压，有触电危险。 注意 阅读说明书 • 用户使用该设备前必须阅读并理 解所有安全和使用说明。 保存说明书 • 用户应保存安全说明[...]

[...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx 1 Description The DVI 104 Tx and DVI 104 Rx are ber optic transmitter/ receiver units that extend DVI signals up to 1,640' (500 m) using four multimode ber optics cables. The transmitter plugs directly into the sour ce device and the receiver plugs dir ectly into the display device. The tra[...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx, cont’d 2 Features Power Supply — Separate power supplies are pr ovided for both the transmitter and receiver . Power LEDs — The LEDs are on the top and bottom panels of both the receiver and transmitter . They illuminate blue when the unit is receiving power . No mounting hardware required — [...]

DVI 104 Tx/Rx • User’ s Guide 3 b LC Jacks — Four ber optic cables connect the transmitter to the receiver . The cables connect to the four female LC jacks in each of the units. A label on the top panel identies the unit as the transmitter or receiver and identies the ber optic port numbers and the power input. N For the transmitt[...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx, cont’d 4 Rear panel features Male Connector 13 68 17 19 22 24 9 3 c A single-link DVI-D male connector is used to connect the transmitter to the source and the r eceiver to the output device. Pin Signal Pin Signal Pin Signal 1 TMDS data 2- 9 TMDS data 1- 17 TMDS data 0- 2 TMDS data 2+ 10 TMDS data [...]

DVI 104 Tx/Rx • User’ s Guide 5 f Label — a label on the top panel identies the unit as the transmitter (Tx, left panel of the gure below) or r eceiver (Rx, right panel of the gure below) and also identies the ber optic port numbers and the power input. 33-1641-01 Re v. A 05 08 5 V 123 4 Extron www .extron.com TO COMPUTER (Tx) [...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx, cont’d 6 Setup and Operation When using the DVI 104 Tx/Rx for the rst time or if the display device is changed, it is essential to set up the EDID Minder . The setup process places EDID information on a EEPROM chip in the transmitter , which allows the video source to boot up correctly . This pr[...]

DVI 104 Tx/Rx • User’ s Guide 7 7 . Apply power to the receiver by inserting the cable fr om the external power supply into the input jack. The LEDs should illuminate a solid blue. 8. Ensure that the display device is still power ed on, connect the receiver dir ectly to the DVI input, and tighten the thumbscrews. 9. Ensure that the PC or sour c[...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx, cont’d 8 T rouble Shooting Display does not show an image Ensure that all plugs and jacks used by the external power • supplies are rmly connected. If the cable is loose or slips out of the slot easily , move the release catch fr om its normal position above the locking catch, to the adjusted [...]

DVI 104 Tx/Rx • User’ s Guide 9 Ensure that the transmitter is rmly plugged into the • source device and the r eceiver is rmly plugged into the output device. T ry resetting the system by unplugging and reconnecting • the DVI connectors or the power jacks. T ry rebooting the computer . • Screen is distorted or displays noise Ensure [...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx, cont’d 10 Specifications N The DVI 104 TX/RX consists of a transmitter (DVI 104 TX) and a receiver (DVI 104 RX) with fiber optic cables linking the two units. N These transceivers ar e Class 1 laser products. They meet the safety regulations of IEC-60825, F AD 21, CFR 1040.10, and FDA 21 CFR 1040[...]

DVI 104 Tx/Rx • User’ s Guide 11 Cooling ........................................... Convection, no vents Mounting Rack mount ........................ No Furniture mount ................ No Enclosure type .............................. Plastic Enclosure dimensions .................. 0.6" H x 1.5" W x 2.3" D (1.5 cm H x 3.9 cm W x[...]

DVI 104 Tx/Rx • User’ s Guide DVI 104 Tx/Rx, cont’d 12 Parts Included parts Included Parts Replacement part number DVI 104 Tx/Rx 60-977-01 DVI 104 Tx 60-977-12 DVI 104 Rx 60-977-13 (2) 5 VDC Power Supply DVI 104 Tx/Rx User ’ s Guide Fiber optic cables Accessories Part number 4-ber MM LC-LC - 10 m (33') 26-652-01 4-ber MM LC-LC - [...]

DVI 104 Tx/Rx • User’ s Guide 13[...]

DVI 104 Tx/Rx • User’ s Guide 14[...]

Extron’ s W arranty Extron Electr onics warrants this product against defects in materials and workmanship for a period of three years fr om the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electr onics will, at its option, repair or replace said pr o[...]

© 2008 Extron Electronics. All rights reserved. Ex tron US A - We st Headquar te rs + 80 0.6 33 .9 87 6 I nside U S A / C anad a On ly +1 .7 1 4.4 91 .1 50 0 +1 .7 1 4.4 91 .1 51 7 FA X Ex tron US A - East + 800 .6 33 .9 87 6 I nside U S A / C anad a On ly +1 .9 19 .8 63 .1 79 4 +1 .9 19 .8 63 .1 79 7 FA X Ex tron EM EA + 800 .3 98 7. 66 73 I nsid[...]