GE ZEK737BW manual

GE Monogram ® Installation Instr uctions 27" Built-In Ovens Models ZEK757WW ZEK757BW ZEK737WW ZEK737BW[...]

Before you begin—Read these instructions completely and carefully . IMPOR TANT: Save these instructions for local inspector’s use. IMPOR TANT: OBSER VE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INST ALLER: Be sure to leave these instr uctions with the Consumer . NOTE TO CONSUMER: Keep these instructions with your Use and Care Book for future [...]

Models available ZEK757WW White double convection oven ZEK757BW Black double convection oven ZEK737WW White single convection oven ZEK737BW Black single convection oven Dimensions and clearances Double oven A - 20 " (508 mm) B - 23 -1/2" (597 mm) C - 26 -13/16" (681 mm) D - 50 -3/4" (1289 mm) E - 26 -3/16" (665 mm) F - 1 -3[...]

Cabinet style options Design Infor mation Built-In Ovens Front Framed Partial Overlay Door Front Framed Full Overlay Door Frameless Monogram ovens are installed directly into a wall or wall oven cabinetr y , 27" minimum width. The front sur face of the ovens will be nearly flush with sur - rounding cabinetr y . T o obtain optimal appearance, c[...]

Installation options Single Oven Installed Below A ZMC1090WV/ZMC1090BV Microwave Oven Single Oven Installed Below A ZEM200WV Microwave Oven Design Infor mation Built-In Ovens • Install a single oven alone or below any Monogram microwave oven. • For an integrated look, install a single oven below the ZMC1090BV and ZMC1090WV built-in style microw[...]

Cabinetr y Built-In Oven s • 2" x 4" lumber for runners • Saw • Level • Phillips screwdriver and wood screws or other hardware for installing runners or shelf to support oven. Ovens are designed for installation in a cabinet 27" min. wide. • Cut 2" x 4" runners of appropriate length or solid shelf to support oven.[...]

Framed cabinet single oven DIMENSIONS A Cabinet Width 27" Min. B Cutout Width 25" Min. C Cutout Height 27-1/2" Min./28-1/8" Max. D Cutout Depth 23-5/8" Min. E Cutout Location 32-1/2" Recommended H Overall Height 28-9/16" W Overall Width 26-13/16" Use the infor mation in this dimension drawing for typical fram[...]

Recessed installation: Front framed cabinets with inset doors and drawers Cabinetr y Built-In Ovens Front Framed Inset Flush Door 8 Rough opening for single and double ovens: • Depth 24-1/2" min. from inside back to front of cabinet frame. – If the cabinet is not 24-1/2" deep, the back of the cabinet should be cutout. The cutout shoul[...]

Frameless cabinets Frameless Use the infor mation in this dimension drawing for typical frameless cabinets. The front face of the oven will be flush with cabinetr y doors or drawers. Whenever possible, order 27" frameless cabinet with the cutout sized to fit the oven. If you are using stock cabinets, additional finished filler pieces may be re[...]

Single oven installed below a microwave oven Order a double oven cabinet. See the chart above for cutout dimensions and receptacle locations for each microwave oven. • Allow 1-7/8" clearance between microwave oven and single oven, for trim kit or oven overlap. Models ZMC1090WV and ZMC1090BV do not require trim kits. When installed the outsid[...]

Single oven installed below a countertop Monogram 36" Halogen and ribbon cooktop can be installed over a single oven. Refer to cooktop installation instr uctions for cutout. • Locate the junction box 16" min. below the countertop. C 11 Cabinetr y Built-In Ovens Monogram ovens can be installed below a countertop. The rough opening of the[...]

Provide oven supports The ovens may be supported by either a solid bottom or 2 x 4 r unners. • The support must be level and rigidly mounted, flush with the bottom edge of the cutout. • The entire weight of the oven is supported by 2 x 4 r unners or the solid floor and must be capable of supporting 200 lbs. for double ovens and 150 lbs. for sin[...]

Determine need for filler panels Filler panel construction If the cabinets being used have an opening that is taller than the maximum dimensions indicated for the ovens, filler panels can be made to fill the gaps. Stock filler strips are usually available or for larger gaps order an extra drawer front. Drawer fronts are recommended because they wil[...]

Cut rail for filler panel Cut the rail out of finished material: • The width should match cabinet opening width. • The height of the top rail should be enough to securely attach the rail to the appearance panel, plus 1/4" oven trim overlap. • The height of the bottom rail should be enough to securely attach the rail to the appearance pan[...]

Cut and secure cleats to filler panel 15 For the bottom filler panel: • Cut 2 cleats out of 3/4" thick material, approxi- mately 1-1/4" wide. • Cut the cleats to a length leaving approximately 1/2" at the top of the filler panel to attach the rail. • Position the outside edge and bottom of the cleat against the cor ner pencil m[...]

Installation Built-In Ovens 16 • Outlet box • Electrical cable—3-conductor or 4-conductor wire—as required by local codes • Flexible power cable connector • Electrician’s pliers Note: Do not use an extension cord with these appliances. Monogram built-in single and double ovens require a separate, properly grounded 3-wire 120/208 or 12[...]

Finalize installation Caution: Do not lift oven or oven door by handle. Door glass breakage or handle damage may occur. Glass surface of door face extends beyond door frame on each side; be careful not to impact this exposed glass. Caution: When door is removed and hinge arms are at stop position, do not bump or try to move hinge arms. Hinges could[...]

Installation Built-In Oven s 18 • Slide oven into cabinet opening. • Drill 3/32" pilot holes through mounting holes in oven front frame. (2 screw holes for single ovens, 4 screw holes for double ovens.) • Secure oven in place with screws furnished. (Use dr ywall screws if cabinet is par ticulate board). Secure oven to cabinet CAUTION WAR[...]

Installation Built -In Ovens 19 • When connecting to a 4-conductor branch circuit: – Connect oven red lead to branch circuit red lead. – Connect oven black lead to branch circuit black lead. – Break connection between oven white lead and oven bare copper conductor . – Connect oven white lead to branch circuit neutral lead (white or gray).[...]

Monogram. ® General Electric Company Louisville, KY 40225 Pub. No. 49-8804  1996 GE Appliances (N.D. 616) 9/96 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. T o obtain specific information concerning any Monogram product or service, call GE Answer Center ® consumer information service at[...]