Genie 3452535556 manual

3452535556 Included W all Control MUST be installed prior to operation of this Garage Door Operator Safe-T -Beam ® Safety Reverse System Must be installed to close door SA VE THIS MANUAL FOR FUTURE REFE RE NC E NOTE: Y our Residential Operator comes with a Rail Assembly which is standard for up to a 7 foot 6 inch high door . An extension kit for a[...]

6 To avoid damage to your door and/or operator , make sure you disable any door locks prior to installing your operator . 2 PRE-INST ALLA TION CHECK LIST FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM Things to consider if you are planning to “do-it-yourself.” In many ca se s you will be replacing an existing door operator with a new one, howeve[...]

3 7 TYPICAL SECTIONAL DOOR INST ALLA TION FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM TYPICAL SUPPORT BRACKET EXTENSION SPRING OR T ORSION SPRING SAFE-T -BEAM ® BRACES ADDED HEADER BRACKET MOUNTING BOARD TYPICAL 1-PIECE DOOR INST ALLA TION 48" POWER CORD TO 120V GROUNDED OUTLET 4 1 3 6 2 3 5 SECTIONAL DOOR 1-PIECE DOOR[...]

4 SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PA G E PRE-INST ALLA TION CHECKS . . . . . . . . . . . . . . . . . . . . . . . . . . 2- 3 OPERA TOR FEA TURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SAFETY FEA TURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[...]

5 RECOMMENDED TOOLS FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 5/32" Drill Bit 7/16" and 9/16" Sockets Step ladder Drill Ratchet Carpenter ’ s level Pencil T ape measure Wire strippers Phillips screwdriver Adjustable wrench PA R TS IDENTIFICA TION - Not Shown Full Size . 30 40 Single-button remote control Multi-button remote con[...]

6 1-PIECE RAIL HARDW ARE EXPLODED VIEW FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM [ 2 ] 3-PIECE RAIL HARDW ARE EXPLODED VIEW [ 4 ] 10 3 9 11 25 15 16 23 28 17 27 25 26 42 24 20 12 18 47 22 9 10 41 41 10 13 39 12 10 39 14 8 9 22 18 47 7 26 42 20 24 6 9 15 11 16 23 28 9 10 5 17 27 25 22 22 39 13 14 39 1 1 48[...]

Power Head Assembly 1J 1N 1X 1L 1N 1E 1K 1D 1A 1N 1H 1B 1Q 1G 1D 1F 49 1P 1M 1N 7 Item Part Name Number Required 1 pc. rail 3 pc. rail 1P ower head assembly (box) 11 2R ail assembly (1-piece) (box) 1 3 Rail (1-piece) (box) 1 4 Rail assembly (3-piece)(items 5, 6, 7) (box) 1 5F i rst rail section (box) 1 6M i ddle rail section (box) 1 7 End rail sect[...]

FIG. 1-4 Attach rail strap . 8 OPERA T OR ASSEMBL Y FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 1 NOTE: For 1-piece rail—skip to step 4. 1. Identify the rail sections (Fig. 1-1) . • First rail section (attaches to power head). – 2 holes each end. – Half-circle notch 1 end. – Motor end has no notch. • Middle rail section . – 2 holes [...]

FIG. 1-5 Align arro w . FIG. 1-8 Attach emer gency release cord & tag . 9 6. Attach rail to power head . • Place rail in front of power head with rail strap at opposite end. • Support door end of rail (rail strap) at about same height as power head. – Check if magnet is in place (Fig. 1-6 inset) . Insert carriage slide into rail (Fig. 1-6[...]

10 10. Attach limit switch wires . • Uncoil limit switch wires. – Place into channels located along top of rail . – Run wires back to power head through hole in top of power head (Fig. 1-12) . – Use wire clips to hold wires in place (Fig. 1-13) . • Attach limit switch wires to terminals on power head (Fig. 1-14) . – White wire (“OPEN?[...]

FIG. 2-1 Finding highest point of travel (sectional) . 11 INST ALLA TION FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 2 IMPORT ANT 1. READ AND FOLLOW ALL SAFETY , INST ALLA TION AND OPERA TION INSTRUCTIONS. If you have questions or do not understand an instruction, call The Genie Company or an authorized Genie Dealer . 2. Do Not install operator o[...]

12 NOTE: If header bracket location needs to be above header for garage door opening, you need to add a “mounting surface.” A 2" x 6" board securely attached (fasteners not included) across wall studs on either side of your mark is sufficient (Fig. 2-4) . OPEN ORANGE P ARTS BAG 2. Mounting the header bracket . NOTE: Although header br[...]

Mounting Straps [22] 13 MOUNTING THE OPERA T OR: 1. Getting Started . • Position rail/power head assembly (Fig. 2-7) . – Rail strap leaning on wall next to header bracket. – Place material on floor under power head to protect from scratching. (A box, stool, or similar device may be needed to clear a torsion spring, as shown.) 2. Mounting the [...]

INST ALL DOOR ARMS: Sectional doors OPEN YELLOW P ARTS BAG 1. Attach the arms . • Fasten curved door arm to door bracket using clevis pin (24) and cotter pin (25) (Fig. 2-10) . • Straight arm to carriage using clevis pin (24) and cotter pin (25) (Fig. 2-10) . 2. Connecting the arms . • Slide carriage back and forth to adjust arm length. – O[...]

3. Wiring . • Route wire (29) using either method shown (Fig. 3-5) . • Wires along rail are held in place with wire clips. – Wires can be slipped under the wire clips already in place. 15 SAFE-T -BEAM ® SYSTEM INST ALLA TION FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 3 NOTE: The operator will not close the door automatically unless the Sa[...]

FIG. 3-8 T erminal attachments at power head . OPEN RED P ARTS BAG 3. Wiring (cont’) . • Securely fasten wires to wall as you go. – Use insulated staples (included). – Staples should be snug only . 16 • Make wire attachments at “ STB ’ s. ” – Splitting and stripping wire ends to be connected as shown (Fig. 3-6) . – Loosen termin[...]

FIG. 5-1 T erminal attachments at power head . W ALL CONTROL INST ALLA TION FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 4 1. Finding the mounting location . • Pick a convenient location for mounting wall control. – Location you choose should be in direct sight of door . – It should be at least 5' above floor to prevent small children f[...]

18 CONNECTING TO POWER FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 5 1. Plug the operator into a properly grounded electrical outlet . 2. Check Safe-T -Beam ® alignment (Fig. 6-3) . To reduce the risk of electrical shock, this equipment has a grounded type plug that includes a third ( grounding ) pin. This plug will only fit a grounded type outl[...]

19 LIMIT SWITCH / FORCE ADJUSTMENT FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM 6 NOTE: During operator cycling for force adjustment, the motor protector may shut off power to the operator . If this occurs, wait about 20 minutes to allow the motor protector to reset. 1. Adjusting limit switches. • Locate force control knobs on power head (Fig. 7[...]

FCC and IC CER TIFIED 20 PROGRAMMING REMOTE CONTROLS 7 FIG. 8-1 Learn code button and LED 1. Programming . • Locate learn code button and indicator LED on front of power head (under force adjustment screws) (Fig. 8-1) . • Press and release learn code button. – Indicator LED will blink at a rate of twice per second. • Wi thin 30 seconds , pu[...]

21 MUL TI-BUTT ON REMOTE 1. Programming . NOTE: Each button on a multi-button remote is designed for use with 1 door . Y ou cannot pro- gram 2 buttons to operate the same door , nor can you program 1 button to operate 2 doors. • For each button . – Program each button separately . – Follow single button remote procedure (previous page) for ea[...]

22 IMPORT ANT SAFETY INSTRUCTIONS 1. READ AND FOLLOW ALL INSTR UCTIONS. 2. Nev er let children operate or pla y with the door controls . K eep the remote control a wa y from children. 3. Alwa ys keep the mo ving door in sight and a wa y from people and objects until the door is completely closed. NO ONE SHOULD CR OSS THE P A TH OF THE MO VING DOOR.[...]

23 TROUBLESHOOTING GUIDE (CONTINUED) FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM • Check lock switch on wall console. • Check power source. – Plug a lamp into outlet used for power head If lamp works, power source is OK. – If not, check fuse or circuit breaker . • Power is OK. – Check connections at power head terminals. – Check con[...]

24 WIRING DIAGRAM FOR HELP-1.800.354.3643 OR GENIECOMP ANY .COM Tr ansmitters comply with all United States and Canadian legal requirements as of the date of manufacture . No warranty is made that they comply with all legal requirements of an y other jurisdiction. If transmitters are to be used in another countr y , the i mpor ter m ust determine c[...]

A No C .O.D . shipments. Please include chec k or money order , do not send cash. Allow 3-4 weeks f or deliv er y . We accept Visa or Mastercard phone orders. 1.800.354.3643. Please hav e par t number and credit card ready . Please add local sales tax if y ou reside in one of the states listed. California Connecticut Florida Georgia Illinois Indian[...]

MODEL DESCRIPTION PRODUCT CODE PRICE (US$)* QTY . TOT AL MODELO DESCRIPCIÓN CÓDIGO PRECIO* CANTIDAD TOT AL MODÈLE DESCRIPTION CODE DU PRODUIT PRIX ($ US)* QTÉ T OT AL Delux e Remote Control with Intellicode ® GIT -1 Controlador remoto de lujo con Intellicode ® 33069R $34.95 Télécommande de lux e av ec Intellicode ® 2-Button Remote Control [...]

C The Genie Company Professional Access Systems LIMITED W ARRANTY What is covered: Any defect in material and product workmanship from personal, normal household use in accordance with the Owner ’ s Manual. For how long: H2000C-1 Series - 3 years on Motor , and 1 year on all other parts. 350L- 1 Series - 3 years on Motor , and 1 year on all other[...]