HP (Hewlett-Packard) Series v72 manual

User ’ s Guide Color Monitor Series v72[...]

© 2003 Hewlett-Packard Development Company , L.P . HP , Hewlett-Packard, and the Hewlett-Packard logo are trademarks of Hewlett-Packard Company in the U. S. and other countries/regions. Microsoft, MS-DOS, Windows, and W indows NT are trademarks of Microsoft Corporation in the U. S. and other countries/regions. Intel, Pentium, Intel Inside, an d Ce[...]

User’ s Guide iii Contents 1 Introduction Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 2 Safety and Maintenance Guidelines Safety Guidelines . . . . . . . . . . . . . . . . . . . . . . . . 2–1 Power Requirements . . . . . . . . . . . . . . . . . . . 2–1 Important Safety Information . . . . . . . . . . . . . . 2?[...]

iv User’ s Guide A Troubleshooting Solving Common Problems . . . . . . . . . . . . . . . . . A–1 Using the World Wide Web . . . . . . . . . . . . . . . . A–4 Preparing to Call Technical Support . . . . . . . . . . . A–4 B Technical Specifications v72 Series Monitor . . . . . . . . . . . . . . . . . . . . . . . B–1 C Agency Regulatory Noti[...]

User’ s Guide 1–1 1 Intr oduction Y our microprocessor-based, digita lly controlled color monitor is a high-perfor mance and easy-to-use product. It emplo ys the latest on-screen menu technology . Kit Contents The monitor kit contains: ■ CRT monit or ■ Monitor Base (pre-installed on select models) ■ AC power cord (select models) ■ Docum[...]

Introduction 1–2 User’ s Guide[...]

User’ s Guide 2–1 2 Safety and Maintenance Guidelines Safety Guidelines Power Requirements Refer to the “Power Cord Set Requ irements” on page C–4 f or information on the correct powe r cord set for this device. Important Safety Information Å WA R N I N G : T o reduce the risk of electric shock or damage to your equipment, do not disable[...]

Safety and Mainte nance Guidelines 2–2 User’ s Guide Maintenance Guidelines T o enhance the per formance and extend the life of your monitor , follow these guidelines: ■ Do not open your monit or cabinet or attempt to ser vice th is product yourself. If your monitor is not operating properly , or has been dropped or damaged, first unplu g fro[...]

Safety and Mainten ance Guidelines User’ s Guide 2–3 ■ Slots and open ings in the cabine t are provided for ventilation. These openings must not be bl ocked or covered. Never push objects of any kind into cabi net slots or other openings. ■ Do not place plants on top of yo ur monitor . W ater or dir t from the plant may get into the vent s.[...]

Safety and Mainte nance Guidelines 2–4 User’ s Guide Removing the Monitor Base In the event that you ne ed to disassemble the base from the monitor , fo llow these instructions: 1. If you must remov e the base attachment, release the catch and slide the base toward the back of your monitor . 2. Lift the base up and away from your monitor .[...]

User’ s Guide 3–1 3 Installation Monitor Base Installation On some monitors, the base mu st be attached prior to monitor installation. If you need to attach the base, fo llow these steps: 1. Align the hooks on the base with the sockets on the bottom of the monitor and attach the base.[...]

Installation 3–2 User’ s Guide 2. Push the base toward the front of the monitor until it stops. Monitor Installation Before installing your monito r , place it in a convenient, well-ventilated location near your computer . 1. T ur n off the power to your computer and other peripheral devices. 2. Connect the video cable (blue co nnector) 1 from [...]

Installation User’ s Guide 3–3 3. Connect the power cord 2 to the back of the monitor , then connect the power cord to a power outlet. 4. Power on your comput er and monitor . If your monitor fails to function properly , refer to Appendix A, “T roubleshooting.” 5. If necessar y , adjust the front panel monitor controls according to your per[...]

Installation 3–4 User’ s Guide[...]

User’ s Guide 4–1 4 Operation Information Files The CD-ROM included with this monitor contains two data files that must be installed onto your computer: An .INF file and an .ICM file. The .INF file designates softwa re and defines monitor resources used by Microsoft Windows to ensure monitor compatibility with the graphics adapter in your compu[...]

Operation 4–2 User’ s Guide Installing Drivers The HP monitor comes with driver software allowing you to take advantage of the Plug and Play feature of the Windows Me, Windows 2000, or W indows XP operating system. This software enables the computer to communicat e with the monitor and use all the monitor features . HP computers may come with t[...]

Operation User’ s Guide 4–3 Windows Me users The procedure for installing the driver for yo ur operating system may var y . T o install the driver for the v72 monitor: 1. Click Start , select Setting s , and then click Contr ol Panel . 2. Double-click Display . 3. Click the Settings tab. 4. Click the Advanced button. 5. Select the Monitor tab. [...]

Operation 4–4 User’ s Guide 8. Click Properties . 9. Select the Driver tab. 10. Click Update Driver . 11. S elect the Install from a list or specific location box, and then click Next . 12. S elect the Don’ t search box, and then click Next . 13. Click Have Disk . 14. Click Browse . 15. Find and open the hp_v72.inf f i l e o n t h e C D - R O[...]

Operation User’ s Guide 4–5 Fr ont Panel Contr ols Front Panel Controls Item Icon Name Function 1 Select Launches on-screen displays, selects functions and adjustments, and exits menus and On-Screen Display . 2 Left Adjustment Moves backward thro ugh menu options or decreases adjustment levels . 3 Right Adjustment Moves for ward through menu op[...]

Operation 4–6 User’ s Guide On-Screen Display The On-Screen Display (OSD) adjusts the screen image based on your viewing preferences. T o access the OSD, do the following: 1. If the monitor is not already on, pres s the Power button to turn on the monitor . 2. Press the Select button t o di splay the On-Screen Display menu. A screen similar to [...]

Operation User’ s Guide 4–7 On-Screen Display Functions Use the Right-Adjustment and Left-Adjustment buttons fou nd on the front control panel of your monit or to adjust these functions. On-Screen Display Icons and Functions Icon Function Description Contrast Right-Adjustment increases the contrast and Left-Adjustment decreases the contrast. Br[...]

Operation 4–8 User’ s Guide Parallelo- gram This control corrects the tilted vertical edges of the image on both sides of the screen that are in the same direction. Til t (Rotation) Right-Adjustment tilts the sides of the image to the right and Left-Adjustment tilts the sides of the image to the left. Degauss This control demagnetizes the scree[...]

Operation User’ s Guide 4–9 Monitor Messages No Signal Message If a “No Signal” message displays on your monitor , check to be sure your video cable is properly connected and ensure that your computer is powered on.[...]

Operation 4–10 User’ s Guide Out of Frequency Range Message I f a n “ O ut o f F r eq u e n c y R a n g e ” m e s s a g e d i s p l a y s o n y o u r m o n i t o r , your video resolution and/or refresh rate are set higher than the levels your monitor suppor ts. T o change the video resolution or refresh rate on your mon itor , follow these[...]

Operation User’ s Guide 4–11 Using the Ener gy Saver Mode Y our monitor is designed to meet strict Environmental Protection Agency (EP A) Energy Star ® requirements for reduced power consumption. Using a combination of hardware and software functions, this energy-saving fe ature allows your computer to control your monitor’ s power consumpti[...]

Operation 4–12 User’ s Guide[...]

User’ s Guide A–1 A Tr o u b l e s h o o t i n g Solving Common Pr oblems The following table lists possible problems, the possible cause of each problem, and the recommended solutions. Problem Possible Cause Solution Screen is blank. Power cord is disconnected. Connect the power cord. Power switch is off. T ur n on power . Video cable is impro[...]

T roubleshooting A–2 User’ s Guide Color is abnormal. A ma gnetic object may be nearby . Move the object farther aw ay . Monitor may have been moved or inadver tently bumped. Press the SELECT button to access the On-Screen Display . Select Degauss to activate. Hewlett-Packard suggests you not degauss more than once within a 30-minute peri od of[...]

T roubleshooting User’ s Guide A–3 “No Signal” is displayed on screen. Monitor video cable is disconnected. Connect the 15-pin monitor video cable to the computer . Be sure that the computer power is on. “Out of Frequency” is displayed on screen. Video resolution and/or refresh rate are set higher than what your monitor supports. Restar[...]

T roubleshooting A–4 User’ s Guide Using the W orld Wide W eb Before contacting customer ser vic es, refer to the suppor t W eb site at: http://www .hp.com Preparing to Call T echnical Suppor t If you cannot solve a problem usi ng the troubleshooting tips in this section, you may need to ca ll technical support . Have the following information [...]

User’ s Guide B–1 B T echnical Specifications v72 Series Monitor Screen Size 17” (43 cm) visual diagonal Viewable screen size 16” (40.6 cm) Dot Pitch 0.28 mm (Diagonal) Display Area Default 234 x 312 (mm) typical Display Colors Infinite Display Resolutions 640 x 480 640 x 480 640 x 480 720 x 400 800 x 600 800 x 600 1024 x 768 1024 x 768 128[...]

T echnical Specifications B–2 User’ s Guide Inrush Current 30 amps @ 120V 60 amps @ 220V Power Consumption 100 W (Max.) Dimension (W x H x D) Unpacked w/attached base 16.6 x 17 x 17.5 inches (maximum) 410 x 432 x 445 mm (maximum) W eight 38 lb Max. 17 kg Max. Operating T emperature 50 o F to 95 o F 10 o C to 35 o C Storage T emperature –22 o [...]

User’ s Guide C–1 C Agency Regulator y Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursua nt to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter ference in a resident ial installation. T[...]

Agency Regulator y Notices C–2 User’ s Guide Cables C o n n e ct i on s to t h is d ev i ce m u st b e m a de w it h s hi e ld e d c a bl e s wi t h metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations. Declaration of Conformity for Pr oducts Marked with FCC Logo, United States Only This device complies with Pa[...]

Agency Regulator y Notices User’ s Guide C–3 Av i s C a n a d i e n Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. Eur opean Notice Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low V oltage Directive (73/23/EEC) issued by the Commi[...]

Agency Regulator y Notices C–4 User’ s Guide EP A Ener gy Star Compliance Monitors that are marked with the Energy Star ® Logo meet the requirements of the EP A Energy St ar program. As an Energy Star Partner , Hewlett-Packard Company has determined that this product meets the Energy Star gu idelines for energy efficiency . Specific details on[...]

User’ s Guide D–1 D TCO‘99 Requirements Y ou have just purchased a TCO’99 approved and labelled product. Y our choice has provided you with a product developed for professional use. Y ou r purchase has also contributed to reducing the burden on the environment and also to the fur ther development of environmentally adapted electronics produ[...]

TCO‘99 Requirem ents D–2 Us er’ s Guide There are also other characteristics of a computer , such as energy consumption levels, that are import ant from the viewpoints o f both the work (internal) and natural (e xter nal) environments. Since all methods of electricity generation have a negative effect on the environment (for example, acidic a[...]

TCO‘99 Requirements User’ s Guide D– 3 Below you will find a brief summar y of the environmental requirements met by this product. Th e complete envi ronmental criteria document may be ordered from: TCO Development SE-114 94 St ockholm, Sweden Fax: +46 8 782 92 07 Email (Internet): development@tco.se Current information regarding TCO’99 app[...]

TCO‘99 Requirem ents D–4 Us er’ s Guide Cadmium Cadmium is present in rechargeable batteries and in the color-generating layers of cert ain computer displays. Cadmium damages the nervous system and is toxic in high doses. The relevant TCO’99 requirement state s that batteries, the color-generating layers of disp lay screens and the electric[...]

User’ s Guide D– 5 Lead Lead can be found in picture tube s, display screens, solders and capacitors. Lead damages the nervou s system and in higher doses , causes lead poisoning. The rele vant TCO´99 requ iremen t permits the inclusion of lead since no replacement has yet been developed. Lead is a heavy metal that is Bioaccumulative.[...]

D–6 Us er’ s Guide[...]