Husqvarna 5521 CHV 96143000106 manual

200 6 - 1 2 O 0 6 020 76 5521 CHV Operator's Manual Operator's Manual Walk M o wer 9 614300010 6[...]

2 W ARNING: Battery posts, terminals and related ac cessories contain lead and lead compounds, chemicals known to the State of Cal ifornia to cause can cer and birth defects or oth er re productive harm. W ash hands after handling. W ARNING: Engine exhaust, some of its constituents, and certain vehicle com po- nents contain or emit chem icals known[...]

3 SAFETY RULES ......................................................... 2-3 PRODUCT SPECIFICA TIONS ....................................... 3 CUSTOMER RESPONSIBILITIES................................. 3 ASSEMBL Y .................................................................... 4 OPERA TION ......................................................[...]

4 FIG. 2 FRAME HANDLE VINYL BINDINGS FRAME OPENING ASSEMBL Y Read these instructions and this man ual in its entirety before you attempt to assemble or operate your new lawn mow er. IMPORT ANT : THIS LAWN MOWER IS SHIPPED WITH- OUT OIL OR GASOLINE IN THE ENGINE. Y our new lawn mower has been as sembled at the factory with the ex ception of those pa[...]

5 FUEL V AL VE LEVER KNOW YOUR LA WN MOWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR LA WN MOWER. Compare the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. MEETS CPSC SAFETY REQUIREMENTS Our rotary walk-behind power[...]

6 TO CONVERT MOWER Y our lawn mower was shipped ready to be used as a mulcher . T o convert to bagging or discharging: REAR BAGGING (See Fig. 5) • Lift rear door of the lawn mower and place the grass catcher frame hooks onto the door pivot pins. • T o convert to mulching or dis charging operation, remove grass catch er and close rear door. HOW [...]

7 PIVOT PINS REAR DOOR GRASS CA TCHER HANDLE CA TCH ER FRAME HOOK FIG. 5 OPERA TION SIDE DISCHARGING (See Fig. 6) • Rear door must be closed. • Open mulcher door and install dis charge defl ector under door as shown. • Mower is now ready for discharging operation. • T o convert to mulching or bagging operation, dis charge defl ector must [...]

8 OPERA TION MOWING TIPS CAUTION: Do not use de-thatcher blade attachments on your mower . Such at- tachments are hazardous, will damage your mower and could void your warranty . • Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and [...]

9 MAINTENANCE Check f or Loose F asteners Clean / Inspect Grass Catcher * Check Tires Check Driv e Wheels *** Clean Lawn Mo wer **** Clean under Drive Co ver *** Check Driv e Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Batter y ** Check Engine Oil le vel Change Engine Oil Clean Air Filter Inspect Muffler Replac[...]

10 ➁ ENGINE OIL ➀ HANDLE BRACK ET MOUNT ING PINS ➀ REAR DOOR HINGE ➀ MULCHER DOOR HINGE PIN ➀ WHEEL ADJUSTER (ON EACH WHEEL) LUBRICA TION CHART ➀ SPRA Y LUBRICANT ➁ SEE “ENGINE” IN MAINTENANCE SECTION • At least once a year , replace the spark plug, clean or replace air fi lter element and check blade for wear. A new spark plug[...]

11 MAINTENANCE TO REPLACE BLADE (See Fig. 1 1) 1. Position the blade adapter on the engine crank shaft. Be sure key in adapter and crankshaft key way are aligned. 2. Position blade on the blade adapter aligning the two (2) holes in the blade with the raised lugs on the adapter . 3. Be sure the trailing edge of blade (opposite sharp edge) is up towa[...]

12 CAUTION: T o avoid serious injury , before performing any service or adjustments: 1. Release control bar and stop engine. 2. Make sure the blade and all moving parts have completely stopped. 3. Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug. 6. W ait one minute to allow oil to settle. Use guage on [...]

13 ENGINE Maintenance, re pair , or re placement of the emission con- trol de vices and sys tems, which are be ing done at the customers expense, may be performed by any non-road engine repair es tablishment or individual. W arranty repairs must be performed by an authorized engine man ufacturer's service outlet. ENGINE SPEED Y our engine spee[...]

14 ST ORAGE ENGINE Maintenance, re pair , or re placement of the emission con- trol de vices and sys tems, which are be ing done at the customers expense, may be performed by any non-road engine repair es tablishment or individual. W arranty repairs must be performed by an authorized engine man ufacturer's service outlet. FUEL SYSTEM IMPORT AN[...]

15 TROUBLESHOOTING POINTS Does not start 1. Dirty air fi lter. 1. Clean/replace air fi lter . 2. Out of fuel. 2. Fill fuel tank. 3. Stale fuel. 3. Empty fuel tank and refi ll tank with fresh, clean gasoline. 4. Water in fuel. 4. Empty fuel tank and refi ll tank with fresh, clean gasoline. 5. Spark plug wire is disconnected. 5. Connect wire to p[...]

16 ROT AR Y LA WN MOWER - - MODEL NUMBER 5521CHV (96143000106) - PRODUCT NUMBER 961 43 00-01[...]

17 ROT AR Y LA WN MOWER - - MODEL NUMBER 5521CHV (96143000106) - PRODUCT NUMBER 961 43 00-01 1 532 19 64-03 Upper Handle, with Foam Grip 2 532 15 34-18 Lower Handle 3 532 19 70-19 Control Bar 4 532 18 35-67 Engine Zone Control Cable 5 532 19 15-74 Handle Bolt 6 532 19 18-56 Handle Knob 7 532 05 17-93 Hairpin Cotter 8 532 06 64-26 Wire Tie 9 532 40 [...]

18 ROT AR Y LA WN MOWER - - MODEL NUMBER 5521CHV (96143000106) - PRODUCT NUMBER 961 43 00-01[...]

19 1 532 40 73-16 Drive Control Assembly 2 532 41 16-73 Cover, Drive Control, Upper 3 532 40 62-62 Pulley 4 532 19 00-39 Lever, Drive Control 5 532 41 16-64 Cover, Drive Control, Lower 6 532 18 16-98 Screw 7 532 40 07-23 Mounting Bracket, Drive Control 9 532 40 62-59 Cable, Drive Control 10 532 18 93-78 Decal, Drive Control 1 1 532 41 10-81 Wheel &[...]

SECTION 1: LIMITED W ARRANTY Husqvarna Forest & Garden Company (“Husqvarna”) warrants Husqvarna product to the original purchaser to be free from defects in material and workmanship from the date of purchase for the “W arranty Period” of the product as set forth below: Lifetime W arranty (Parts and Labor): All tiller tines and trimmer s[...]