Husqvarna 6026PW manual

English Oper ator’ s ma nual Please read the operator’ s manual carefull y and mak e sure y ou understand the instructions before using the machine. 5525PW , 6026PW , 9030PW , 1335PW For customer assistance contact us at our website: www .usa.husqvar na.com IN466800A V 3/06[...]

English — 1 CONTENTS Contents CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 KEY TO SYMBOLS . . . . . . . . . . . . . . . . . . . . .2 Symbols in the Operator’ s Manual . . . . . . . . .2 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . .3 Dear Cust[...]

2 — English Safety Guidelines This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. T o help recognize this information, observe the following symbols. W arning indicates a potentially hazardous situation which, if not avoided, COULD result in dea[...]

English — 3 INTRODUCTION Dear Customer , Congratulations on your choice to buy a Husqvarna product! Husqvarna is based on a tradition that dates back to 1689, when the Swedish King Charles XI ordered the construction of a factory on the banks of the Husqvarna River , for production of muskets. The location was logical, since waterpower was harnes[...]

4 — English WHA T IS WHA T? 1 Serial Number/Product Decal 2 T ip Holder with Spray Tips 3 Detergent T ank (5525PW , 6026PW) 4 Injection T ube (not shown) 5 Gun with trigger 6 Lance 7 Inlet Connection for High Pressure Hose (not shown on 9030PW/1335PW) 8 Inlet Connection for Garden Hose (not shown on 9030PW/1335PW) 9 Engine Oil Fill 10 Engine swit[...]

English — 5 FREQUENTL Y ASKED QUESTIONS How do I start my pr essur e washer? 1. Make sure you have gas and oil in the engine. 2. T urn the water on, then squeeze the trigger on the gun to make sure the water will flow smoothly out of the nozzle or tip. 3. Put the engine throttle control in the “Fast/Start” position. Set the fuel valve to “O[...]

6 — English SAFETY GUIDELINES Important Safety Instructions SA VE THESE INSTRUCTIONS The engine exhaust from this product contains chemicals known to the State of California to cause cancer , birth defects or other repr oductive harm. When using this product, basic precautions should AL WA YS be followed, including the following: • Read all ins[...]

English — 7 SAFETY GUIDELINES • Use only the nozzle supplied with this machine. • NEVER leave the wand unattended while the machine is running. • NEVER tamper with the engine governor or attempt to alter factory settings. Altering factory settings could damage the unit and will void the warranty . • AL WA YS hold gun and wand firmly when [...]

8 — English 2. On models 5525W and 6026W connect clear plastic hose to hose barb on detergent tank (See Figure 2). On models 1335PW and 9030PW connect to brass barb on pump (See Figure 3). 3. Secure garden hose (not included) to the inlet connection on pump (See Figures 4 and 5). PRE-OPERA TION UNP ACKING Remove the equipment and all parts from t[...]

English — 9 4. Connect the high pressure hose to the pump outlet (See Figure 5). 5. Attach the lance with nozzle to the gun (See Figure 6). 6. Install quick connect tip by pulling back on collar and pressing in tip. Release collar , make sure it completely returns to its forward position and tip is secure (See Figure 7). For models 5525PW and 602[...]

10 — English PRE-OPERA TION TRIGGER SAFETY LA TCH In the engaged position, the trigger safety latch prevents the gun from being triggered accidentally . Pull the latch up to engage it (See Figure 10). AL WA YS engage the trigger safety latch when the unit is not in use. Figure 10 - T rigger lock T rigger lock (not engaged) T rigger lock (engaged)[...]

English — 11 OPERA TION 1. Surface Preparation AL WA YS engage the trigger safety latch when unit is not in use. The following cleaning procedure will help you organize your cleaning task and ensures that you will achieve the best results in the shortest amount of time. Remember to use the spraying / cleaning techniques mentioned in the following[...]

12 — English OPERA TION 3. Initial High Pressur e Rinse After the engine starts, trigger the gun 3 to 5 times to get any trapped air out of the system. After the spray becomes constant, you may need to adjust the pressure (see pages 13 and 14 for cleaning techniques). PRESSURE ADJUSTMENT Models 9030PW and 1335PW have a pressure adjustment knob lo[...]

English — 13 OPERA TION ANGLE TO THE CLEANING SURF ACE When spraying water against a surface, you can generate maximum impact by striking the surface head on. However , this type of impact can cause dirt particles to embed in the surface and can prevent the desired cleaning action. Spray water against a surface at a 45 degree angle to achieve the[...]

14 — English OPERA TION On particularly tough stains, use a brush in combination with detergents and high pressure rinsing. 1. Follow manufacturer’ s label directions for mixing correct concentrations of soap/detergents. The soap detergent to water ratio through the pump is approximately 10% (1 to 10). 2. Insert the filter end of the clear plas[...]

English — 15 OPERA TION 8. Storage LONG TERM STORAGE INSTRUCTIONS (MORE THAN 30 DA YS IN STORAGE) 1. Remove fuel from the tank and run the pressure washer in a normal operating mode until the engine stops from a lack of fuel. Normal operating mode means actually spraying water from the gun while the engine is running. Alternate method – Add fue[...]

16 — English MAINTENANCE Observe regular maintenance intervals to ensure maximum performance and life from the pressure washer . Refer to the schedule for recommended maintenance. If you operate the pressure washer in dusty conditions, perform maintenance checks more often. ENGINE OIL CHANGING INSTRUCTIONS Before tipping the engine or equipment t[...]

English — 17 MAINTENANCE CHECKING PUMP OIL AND PUMP OIL CHANGING Checking oil level: Most pumps have either a sight glass or a dipstick (or both) to check the pump oil level. The correct oil level is at the center of the sight glass (center of red dot). The sight glass is usually located on the back side of the pump [See Figure 19 (B)]. For model[...]

18 — English MAINTENANCE SCHEDULE Each use After first 5 hours of operation After first 50 hours of operation Every 25 hours of operation Every 50 hours of operation Each 100 hours of operation or every 3 months Every 500 hours of operation (5 months) • Check water inlet screen and filter . • Check engine and pump oil levels. Fill as necessar[...]

English — 19 TECHNICAL AND CONSUMER INFORMA TION Engine Oil T ype SAE 10W-30 SA E 30 W (Above 60 ° F/15.7° C) Engine Oil Capacity 5525PW - Honda GCV160 - 18.6 fl. oz. (0.550 L) 6030PW - Subaru EX17 - 20 fl. oz. (0.591 L) 9030PW - Subaru EX27 - 37 fl. oz. (1.09 L) 1335PW - Honda GX390 - 37 fl. oz. (1.09 L) Engine Fuel Capacity 5525PW - Honda GCV[...]

20 — English TROUBLESHOOTING CHAR T T roubleshooting Chart - Gasoline Power ed Pressure W ashers Only Symptom Possible Cause(s) Corrective Action(s) Engine will not start or is hard to start Engine misses or lacks power Low pressure and/or pump runs rough Water leakage from under pump manifold Water in pump crankcase (milky oil) Frequent or prema[...]

English — 21 TROUBLESHOOTING CHAR T Symptom Possible Cause(s) Corrective Action(s) Oil leakage between the engine and the pump Fluctuating pressure Pressure drops after period of normal use Pump noisy / pump runs rough Pressure washer will not spray detergent W orn oil seals and/or o-ring 1. Low engine oil 2. Pump valve worn, dirty or stuck 3. Pu[...]

NOTES 22 — English[...]

English — 23 5525PW 531 30 75-38 Detergent T ube (not shown) * T ips sold separately; contact your dealer to purchase 531 30 74-62 531 30 74-97 531 30 74-84 531 30 75-35 531 30 74-69 531 30 74-96 531 30 75-36 531 30 75-41 (x4) 531 30 75-41 (x2) 531 30 81-14 531 30 75-43 (x4) 531 30 75-28 531 30 75-31 531 30 75-30 531 30 75-32 531 30 74-61 (x1) 53[...]

24 — English 6026PW 531 30 74-93 531 30 74-63 531 30 74-88 531 30 74-89 531 30 75-44 531 30 74-87 531 30 74-68 531 30 74-86 531 30 75-36 531 30 75-41 (x4) 531 30 75-41 (x2) 531 30 75-42 (x5) 531 30 75-45 (x4) 531 30 75-34 531 30 74-92 531 30 75-33 531 30 75-40 (x2) 531 30 75-32 531 30 74-61 (x1) 531 30 75-39 (x1) 531 30 75-37 531 30 74-94 531 30 [...]

English — 25 9030PW and 1335PW 531 30-74-67 531 30 74-88 531 30 74-89 531 30 74-87 531 30 74-86 531 30 74-68 531 30 75-44 531 30 74-77 (Soap) 531 30 74-73 (0°) 531 30 74-74 (15°) 531 30 74-75 (25°) 531 30 74-76 (40°) 531 30 74-66 (x1) 531 30 74-64 (9030PW) 531 30 74-65 (1335PW) 531 30 75-46 531 30 74-95 531 30 74-91 531 30 75-47 531 30 75-39 [...]

26 — English Pump for 5525PW 531 30 75-29 Pump Assembly Complete 531 30 75-04 P/O 531 30 75-06 (x1) 531 30 75-01(x6) 531 30 75-02 (x6) 531 30 75-03 (x3) 531 30 75-05 531 30 75-07 (x3) 531 30 75-03 (x3) 531 30 75-66 531 30 75-02 (x6) P/O 531 30 75-01 (x3) 531 30 74-99 P/O 531 30 75-01 (x3) 531 30 75-11 (x3) 531 30 75-00 (x3) P/O 531 30 75-10 531 3[...]

English — 27 Pump for 6026PW 531 30 75-12 Pump Assembly Complete 531 30 75-77 (x3) 531 30 75-78 531 30 75-88 531 30 75-79 531 30 75-80 531 30 75-81 531 30 75-82 (x3) 531 30 75-83 531 30 75-84 531 30 75-87 531 30 75-14 (x1) 531 30 75-51 (x3) 531 30 75-13 531 30 75-53 (x3) 531 30 75-52 (x3) 531 30 75-66 531 30 75-15 (3/8" TRV) 531 30 75-91 (1/[...]

28 — English Pump for 9030PW and 1335PW 531 30 75-17 Pump Assembly Complete P/O 531 30 75-61 (x1) P/O 531 30 75-92 (x1) P/O 531 30 75-61 (x1) P/O 531 30 75-61 (x1) P/O 531 30 75-61 (x1) P/O 531 30 75-92 (x1) 531 30 75-76 P/O 531 30 75-92 (x1) P/O 531 30 75-61 (x1) P/O 531 30 75-92 (x1) P/O 531 30 75-64 P/O 531 30 75-65 (x4) 531 30 75-19 P/O 531 3[...]

English Oper ator’ s ma nual Please read the operator’ s manual carefull y and make sure y ou understand the instructions before using the machine. 5525PW , 6026PW , 9030PW , 1335PW For customer assistance contact us at our website: www .usa.husqvar na.com IN466800A V 3/06[...]