Jet DC-650A manual

Operating Instructions and Parts Manual Dust Collector Model: DC-650A/C/ARC/CRC DC-650ARC shown DC-650C shown WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60123 Part No. M-708640 Ph.: 800-274-6848 Revision G1 12/04 www.wmhtoolgroup.com Copyright © WMH Tool Group This Manual is Bookmarked[...]

2 This manual has been pre pared for the owner and operato r s of the JET DC-650 Series Dust Collectors. I ts purpose, aside from machine operatio n, is to prom ote safety using accepted operatin g and maintenance procedures. To obtain maximum life and efficiency from your du st collector and to aid in using it safely, please read this manual thoro[...]

3 Table of Contents Warranty and Service ........................................................................................................... ................................ 2 Table of Contents .............................................................................................................. .................................... [...]

4 Warnings 1. Read and understand the entire o wners manual before attempting assembly or operation. 2. Read and un derstand the warnings posted on the machi ne and in this manual. Failure to co mply with all of these warnings may cause serious inju ry. 3. Replace the warning labels if they become obscu red or removed. 4. This du st collector is de[...]

5 blahblahblah 20. Make your workshop child proof with padlocks , master switc hes or by removing starter keys. 21. Give your work undivided attention. Loo king arou nd, carrying on a conversation a nd “horse-play” are careless acts that can result in seriou s injury. 22. Do not use the dust colle ctor for anything except wood dust. Materials s[...]

6 Introduction This manual is provided by JET covering the safe operation and maintenan ce procedures for models DC-650 Series Dust Collectors. This manual contains in structions on installation, safety pre cautions, general operating procedures, maintenance in structions and par ts breakdown. Thi s machine has been designe d and constructed to pro[...]

7 Unpacking 1. Remove all contents fr om the shipping carton. 2. Report any damage to your distributor. 3. Do not discard any shipping material until after the dust collector has been assembl ed and is running properly. Contents of the Shipping Carton DC-650A Conten ts 1 – Base 1 – Owner's Manual 1 – Warranty Card 1 – Motor Assembly 1 [...]

8 Assembly The dust collector must be disconnected from the po wer source during assembly . Failure to comply may result in serious injury! Motor Housing and Support Canister 1. Place the impeller housing (A, Fig. 1) on the floor with the motor (B, Fig. 1) facing upwards as shown. 2. Attach the fan (C, Fig. 1) to the motor shaft (D, Fig. 1). Allow [...]

9 Filter Bag Installation – DC-650A/ARC 1. Thread an M6 hex nut onto the filter bag support rod, followed by an M6 fl at washer and M6 lock washer (A, Fig. 5). Thread the support rod (B, Fig. 5) into the motor/fan housin g and tighten nut against the housing. 2. Place the retaining strap (C, Fig. 5) through the loops on the filter bag and hang th[...]

10 Canister Installation – DC-650C/CRC 1. Place the canister filter so that it fits snugly over the housing and tighten the four knobs (A, Fig. 7). 2. Mount handle (B, Fig. 7) to the arm (C, Fig. 7) with a M8 flat washer (D, Fig. 7), M8 lock washer (E, Fig. 7), and a M8 hex nut (F, Fig. 7). 3. Thread a M10 hex nut (G, Fig. 7) onto the threaded ro[...]

11 Electrical Connections All electrical connections must be done by a qualified electrician. All adjustments or repairs must be done with the dust collector disco nnected from the power source, unplugged. Failu re to comply may result in serious injury! The DC-650 series dust collectors are rated at 115/230V, Prewired 115V . Use a pl ug and outlet[...]

12 Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury! Cleaning the Filter Bag – DC-650A/ARC Wearing a particle mask/respirator for protection against fin e dust particles during cleaning is highly recommended. During first use and after c[...]

13 Parts Replacement Parts Replacement parts are li sted in the Parts List on the following pages. To orde r parts or reach our service department, call 1-800-274-68 48 between 7:00 a.m. and 6: 00 p.m. (CST), Monday thro ugh Friday. Having the Model Number and Se rial Number of your machine availabl e when you call will allow us to serve you quickl[...]

14 Index No. Part No. Description Size Qty 35 ............. 331010 ..................... Shaft ....................................................................................................................... 1 36 ............. 331043 ..................... Scraper .............................................................................. [...]

15 Parts Breakdown for DC-650C/ CRC Models for DC-650A/AR C Models[...]

16 Remote Control Breakdown for DC-650ARC/CRC Index No. Part No. Description Size Qty ................. DC650RC-100 ......... Rec eiver As sembly (Ite ms 1-11) ............................................................ ................ 1 1 ............... DCRC-101 ............... Label .............................................................[...]

17 Wiring Diagrams DC-650A/C Models 115V 230V[...]

18 DC-650ARC/CRC Models[...]

19 Notes[...]

20 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.co m[...]