Jotul GF 200 DV manual

WARNING: IF THE INFORMA TION IN THESE INSTR UC- TIONS ARE NO T FOLLOWED EXA CTL Y , A FIRE OR EXPLOSION MA Y RESUL T CAUSING PROP- ERTY D AMAGE, PERSONAL INJUR Y OR LOSS OF LIFE. FOR Y OUR SAFETY : DO NO T ST ORE OR USE GASOLINE OR OTHER FLAMMABLE V APORS AND LIQ UIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. INST ALLA TION: INST ALLA TION AN[...]

2 W elc ome to J ø tul... C ongratulations on the purchase of your new Jøtul GF 200 D V Lillehammer - a direct vented gas heater especially designed and approv ed f or installation in to a v ariety of configurations wher e close clear ance to combustibles is r equired. W e at Jøtul are glad you’ve made the decision to w arm your hearth with a [...]

3 T able of Contents Specifica tions .................................................. 3 General Inf ormation ...................................... 5 Saf ety Information ......................................... 6 Hearth Protection Requirements ................ 6 Clear ance Requiremen ts ............................... 7 Mantel and T rim Clear an[...]

4 Jøtul GF 200 D V Lillehammer Specifica tions Figur e 1. Dimensional V iews - GF 200 DV Lillehammer GF 200 DV Lillehammer Options • Fuel C onversion Kit - NG .............................. 155349 • Fuel C onversion Kit - LP ............................... 155350 • High Altitude C onv ersion Kit - NG ........... 154371 • High Altitude C on[...]

5 DO NO T OPERA TE THE LILLEHAMMER GAS STO V E WITH THE GLASS FRONT REMO VED, CRACKED OR BR OKEN. REPLACEMENT OF THE GLASS SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON. ONL Y REMOVE GLASS FOR ROUTINE SERVICE. ALWA Y S HANDLE GLASS CAREFULL Y . SEE THE MAINTENANCE CHAPTER FOR INSTRUCTIONS ON REPLA CING THE GLASS P ANEL. Gener al Informat[...]

6 Loca ting the Stov e In selecting the location, the aesthetic and func- tional use of the appliance are primary concerns. Howev er , proper v enting systems and access to the fuel supply are also important issues. Due to the high surface temper atures of the Lillehammer , one must also consider the proximity of traffic wa ys , furniture, draperie[...]

7 Clear ance to C ombustibles Minimum Stov e Clearance R ear 0” (0mm) Ceiling 17” (432mm) Corner 2” (51mm) Right Side 2” (51mm) Lef t Side *10” (255mm) * Necessary f or complete access to pull out required Ligh ting Instructions Plate. Minimum V ent Pipe Clearance Horizontal runs: Off the top of the pipe - 2” (26mm) Off the sides and bo[...]

8 Install the Exhaust Restric tor Pla te 1. R emove the T op Pla te to access the Glass Panel. 2. R elease the Glass P anel latches and lift the panel str aigh t up of f of the fireb ox . 2. Ca refully r emo ve the L og Set pieces from the fir ebox. 2. Use a 1/4” nut driver to remo ve the two lower sheet metal screws located inside the firebox be[...]

9 35 Ft. (10.67 m) 30 Ft. (9.14 m) 25 Ft. (7.62 m) 20 Ft. (6.10 m) 15 Ft. (4.57 m) 5 Ft. (1.52 m) 1 Ft. (.30 m) 10 Ft. (3.05 m) 10 Ft. (3.05 m) 5 Ft. (1.52 m) VERTICAL RUN HORIZONT AL RUN F igure 7 . Install the Air Inlet R estrictor Plate. Rear W all of F irebox Air Deflector R emove this screw only Air In take R estric tor Plate T able 1. V ertic[...]

10 Co-linear Hearthmount Installa tion The Jøtul GF 200 D V Lillehammer may be v ented through a masonry fireplace using Simpson Dura- V ent Chimney Liner Conv ersion Kit 923GK. When installed in the manner described below , this system can impro ve the performance of the appliance in cold climate situations, as well as simplif y the vent installa[...]

11 Masonr y or Pre fabricated Chimne y Co nv ersion The GF200 DV Lillehammer is approv ed for use with Simpson Dura-v ent Chimney Kit #934 in a masonry chimney or a pr efabrica ted solid fuel listed chimney . These installation requirements must be followed: 1. In masonry chimney , a fireclay liner or listed steel liner , must be pr esent the entir[...]

12 Horiz ontal V enting (Horizontal T ermination) • The maximum horizon tal run made directly off the rear of the stove into a standard horiz ontal cap (#984 or #985) must be no more than a 9” section of Simpson Dur a-ven t (#907B). See F igure 12-1. • The maximum horizon tal run made directly off the r ear of the stove into a 14” snorkel c[...]

13 W all Shield Installation When horiz ontally v enting direc tly of f the rear of the stove, install the decorativ e W all Shield #129349, (included in the stove), to c over the top of the venting hole in the w all. See Figure 14. 1. R emov e the top four 1/4” he x head screw from the rear shroud of the stov e. 2. Align the holes in the wall sh[...]

14 V ent T ermination Requirements Figure 15. V ent T erminal Clear ances - National Fuel Gas Code A = Clear ance abov e grade, veranda, porch , deck, or balcony : *12 inches (30 cm) minimum. B = Clear ance to window or door that may be opened: 9 inches (23 cm) minimum. W e r ec ommend 12 inches to help preven t condensation. C = Clearance to perma[...]

15 T ools Required: • 1/4” Nut driver • 7/16” and 1/2” open end wrench • T orx T -20 or slotted screwdriv er . Fuel Co nversion Kit C ontents: • 1 regulator tower labeled for Propane • 3 regulator tower screws • 1 burner orifice (#48 for NG, 3/64 for LPG) • 1 pilot orifice (#51 for NG, #30 for LPG) • Label A - to be completed [...]

16 Gas C on version Procedure See F igur e 29, page 25 for parts identification. 1. T urn off gas supply to the stove. 2 . Remov e the stov e T op Plate (3). 3. R emove the Fr ont Panel. Using a 10mm open- end wrench, loosen the two bolts holding the Fr ont Panel (1) to the side panels (2). (Note: Y ou do not hav e to remo ve these bolts.) Pull the[...]

17 C onnec t the Gas Supply The gas supply line connection is made to the valve just inside the left r ear leg. The gas supply line should be 3/8" npt with a 1/2" diameter supply , or the appr opriate siz e to pro vide sufficien t gas pres- sure to the v alve r egardless of the input setting. The use of Flexible Gas Appliance C onnectors [...]

18 Leak T est: • Mix a 50-50 solution of water and dish soap. • Light appliance- see lighting instruc tions on page 21 of this manual or on the stove’ s rating plate. • Brush or spray all joints and connections with the soapy w ater solution. If bubbles appear at an y c onnection or seam or a gas odor is detected immediately turn gas contro[...]

19 Dera ting Procedure: T o derate this unit, install the appropria te orifice as shown in the High Altitude char t. 1. Remov e the two ¼” hex head screw that holds the burner tube/log support to the bottom of the stove. 2. R emove the burner tube/log support to e xpose the main burner orifice. 3. R emove the air deflector shield around the main[...]

20 Install the Log Set The Lillehammer is equipped with a one piece log set and is packaged in bubble wrap inside the firebox. The log set must be removed fr om the pack aging and arr anged in the unit prior to start up of the gas stove. Do not handle the log set with your bar e hands. Alw a ys wear gloves to pr e ve nt skin irritation from the cer[...]

21 1 (25mm) 3/8 (8mm) Min. 1/8 (3mm) Min. Ignitor Thermopile Thermocouple Checking the System 1. Purging the Gas Line: When ligh ting the appli- ance f or the first time it will take a few mo- ments to clear the gas line of air . Once this purge is complete, the appliance will opera te as described in the lighting instructions loca ted on [...]

22 3. Burner Adjustment: The Lillehammer is equipped with a v ariable gas c ontrol v alve. that provides easy adjustment of the flame height appearance and hea t output . T o adjust the flame between the H I and LOW setting, rotate the HI / LO W knob, located in the cen ter of the valve f ace. Flame height will adjust appro ximately 1.0” to 1.5?[...]

23 W ith proper care and main tenance, your Jøtul gas stov e will pro vide you with many y ears of service. If you experience any pr oblems with Jøtul GF 200 D V , c on tact y our authorized Jøtul dealer f or assistance. Fill out the Main tenance R ecord f orm on the next page and k eep it up to date. It will provide useful inf ormation of servi[...]

24 Maintenance Rec ord Jøtul GF 200 Lillehammer Direct V ent Stov e Model: Serial Number: __________________________ Date of P ur chase: _______________________ Dealer: _________________________________ Addr ess: _______________________________ _________________________________ Phone: _________________________________ T ype of Fuel: Natural Gas __[...]

25 3 21 Illustra ted Pa r ts List GF 200 DV Lillehammer 39 40 Figure 29. 12A 20 2 24 23 22 19 4 12 11 10 13 36 C A B 37 38 D 41 43 42 1 35 5 34 15 17 18 16 14 27 26 20 2 33 28 25 29 30 31 32[...]

26 10 Glass Frame 12931692 11 Glass Gasket (7/16” tadpole) 129124 12 Glass Clip 129135 Glass Frame Assembly 154337 12A Latch K eeper 129149 13 Glass 129113 14 Log Set 129122 * Embers 129123 15 Burner T ube 129331 16 Air Divider 129320 17 Air Deflector 129109 18 Burner Orifice Holder Shield 129329 19 E xhaust Baffle 129310 20 Side Heat Shield 1293[...]

27 7. Push in gas con trol knob slightly and turn counter clockwise to “PI LO T” . 8. Push in contr ol knob all the way and hold in. Immediately ligh t the pilot by triggering the spark ignitor (push the red button repeatedly) until pilot lights. Continue to hold the c ontrol knob in for about one minute after the pilot ligh ts. R elease knob a[...]

Jøtul ASA P .O . Box 1411 N-1602 Fr edrik stad, Norway Jøtul Nor th America 400 Riverside Stre et Portland, ME 04104 137743 1.03 Stoves and fir eplaces must be installed to c onf orm to local and na tional building regulations. In preparing to install this appliance, it is important that all instructions issued with the unit are carefully r ead a[...]