KitchenAid 9743822 manual

I itChenAid ® HOME APPLIANCES APPAREILSI_LECTROM_:NAGERS www.kitchenaid.com _---------._ Quick Reference Section Introduction Page 2 Product dlmenslons 3 Bullt-ln opening dlmenslons 3 Electrical requlremonts 4 Water requlrements 4 Draln requlrements 4 Installation steps 5 - Need assistance? Back cover The KitchenAid Consumer Assistance Center is[...]

In_on s_s cont fmm _ s If connecting dishwasher with power supply cord, check that power supply is dlsconne_ed. Electrical ShockHazard Plug Into a grounded 3 prong outlet. Do not removegroundprong. Do not use an adapter. Do not use an extanslon cord. Failure to followthese Instructions can result In death, fire, or electrical shock. • Usepower su[...]

® A. electric drill B. Phillips screwdriver C. flat-blade screwdriver D. 2 adjustable wrenches E. pliers F. measuring tape or ruler G. pipe wrench H. hole cutters (1/2", 3/4", t-ln") 1. tubing cutter J. wire stripper K. utility knife L. 1 1/32" and 1/4" nut driver or hex socket M. 2 twist-on wire connectors for 16-gange wi[...]

/ (6xem) 34"(S6._) Unshaded area must be free of pipes, wires and drain hose. Power supply cord or cable should not be kinked or pinched betwom dishwasher and cab'met. Leveling legs and wheels adjust to fit 34-inch (86.4cm) to 35-inch (88.9cm) cabinet opening height. If levelinglegs and wheels are removed from dishwasher, 33-13/16 inches [...]

• The hot water line to the dishwasher must provide between 20-125 psi (138-862 kPa) water pressure. • The hot water heater should be set to deliver 120°F (49°C) minimum water temperature to the dishwasher for best results. • A 3/8" minimum O.D. copper tubing inlet line is recommended. • Dishwasher inlet valve has 3/8" N.P.T. in[...]

Direct wire method Local codes may permitusing armored or non-metallic sheathed, copper wire(A) (withground wire) to connect dishwasher to unction box. 5. Cut a 3/4"(l.gcm) hole in la_, side or floor of cabinet(B) for direct wiring. Right side is easiestlocation. Wood cabinet: Sand hole until smooth. Metal cabinet: Coverhole withgrommet (Part [...]

Adjust the frout leveling legs (E) the number of turns listed in the chart. The dishwasher should be installed as level as possible from front to back. Put the spring-type drain hose clamp (F) over the drain connector (G). Push drain hose (H) onto drain connector. Usepliers to open clamp and slide clamp over drain hose and drain connector. Check th[...]

Altemate Connection Methods No Air Gap If local codes permit, the dishwasher drainhose may be connected direcOy to awaste tee or waste dispo . Drain hose (A) to waste tee (B) Cut drain end of drain hose as shown (C). Do Not cot fibbed section to shorten drain hose (D). Secure drain hose to waste tee with spring- or screw-type clamp (E). If spring-t[...]

• Install a U.L-listed/t_-certilied strain relief(F) to the terminal box. Run power supply wire through strain relief, ff using conduit, use a U.L.-listed/CA_-cer tiffed conduit connncmr. Run conduit through connector. • Connect the whitewire (G) from the power supplywire to the whitewire in the terminal box with twist-on wire connector. • Co[...]

• Connect the white wire (Q) from the powersupply cord to the white wirein the terminal box with twist-on wireconnector. • Connect the black _ (R) fromthe power supply cord to the black wire in the terminal box with twist-on wire connector. i If the ground connector (S) looks like this: • Loosen front nut (T) on ground connector located on th[...]

O Open door about 3 inches (7.6cm) and check for equal spacing (C) between inner door and tub sides. If spacing is not equal, loosen bracket screws and shifttub. Tighten bracket screws. Remove newstraper or towel from dishwasher. Open and close door several times. Thedoor should open and close easily. If door doses too quickly or falls open, adjust[...]

access and lower panelto dishw_her so that the bottom edge of the lower panelcontacts the floor. Your installation is now complete. Keep Installation Instructions and Use and Care Guide close to dishwasher for easy reference.[...]

n Your safety and the safety of others is very Important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and others. All safety messages will be preceded by the safety alert sy[...]

Introduction cont. from page2 MODELS A MODI_LIES KUDC Series Stifle KUDC 24-1/4" (61.6 ore) 10UDI25 Series 61,6 cta (24-1/4 po) Sl_de KIJDI25 All Others 25-1/4" (64.1 an) TOllS lea anwes 64,1 can (25-1/4 po) * does not include insulation bhmket * ne comprend pas l'isolant 35-7.'8" (_) a_. A* 91- 24" (61cm)* -- 19-3/4&q[...]

O} Ill It is the customer's responsibility:. To contact a qualified electrician. To assure that the electrical installation is adequate and in conformance with all national and local codes and ordinances. Dishwasher must be connected to theproper electricalvoltage and flequency as specified on the model/serial rating plate.The model/serial rat[...]

/ 24,,'''_ (61_m) ElectricalShock Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. Failure to do so can result in death or electrical shock. 1. Disconnect the power supply. 2. Put on gloves and safety glasses. Electrical 3. Pick one method to follow ("Direct wire" or &q[...]

Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. Excessive Weight Hazard Use two or more people to move and Install dishwasher. Failure to do so can result in back or other injury. Keep cardboard shipping base or hardboard under dishwasher until it is ins[...]

(I r ! I'1 Connect drainhose to an air gap or waste tee using one of the recommended or alternate methods. Recommended Connection Methods Install Air Gap Kit (Part No. 300096) (A) according to kit instructions. If a different air gap is used, it should be checked to make sure it allows for the same air flow. Drain hose (B) to air gap (A) to wa[...]

o Apply Teflon tape to 90 ° elbow fitting (A) and connect fitting directly to water inletvalve (B). Attach water supply line (C) to fitting. Do Not allow the water pipe or tubing to contact the motor or dishwasher legs (D). Turn on watersupply and check for leaks. Check electrical requirements. Be sure you have correct electrical supply and recomm[...]

Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. Open dishwasher door and removeall shippingmaterials. Remove bottom rzck Place newspaper (A) or towel over bottom of dishwasher to prevent screws from falling into pump area when securing dishwasher to coun[...]

Check that all parts have been installed (except access and lower panels) and no steps were skipped. _ Check that you have all the tools you used. Read the Use and Care Guidethat came with your dishwasher. ,,Reconnec, t, power supply to dishwasher. Set the dishwasher to run the 'Normal' cycle. Start dishwasher and allow it to run for 2 mi[...]

The KltchenAid Consumer Assistance Center is open 24 hoursa day, 7 days a week. Call1o(800) 422-1230. Thecall is freewithin the continental United Sta_. In Canada, call 1-(800) 461-5681 for English and 1-(800) 461-5703 for French. Call the KitchenAid Consumer Assistance Center when you: • Have questions about dishwasher installationor operation. [...]