Lenovo 2278-06E manual

i Edition 1 This publication could contain technical inaccuracies or typographical errors. Changes are made periodically to the information herein, these changes will be made in later editions. IBM may make improvements and/or changes in the product(s) and/or programs(s) at any time. It is possible that this publication may contain reference to, or[...]

Packing List The product package should include the following items: 1. Monitor 2. Owner ’s Manual 3. Power Cord 4. Swivel Base 5. Diskette ii CB775-english 99.7.55:9 PM ˘ ` i i[...]

iii T able of Contents Introduction Features ..........................................................................................................A1 Precautions Workplace preparation ....................................................................................A2 Working Practices .........................................................[...]

A1 Introduction Thank you for purchasing a high resolution monitor . It will give you high resolution performance and convenient reliable operation in a variety of video operating modes. Features The monitor is a 15 inches (13.8 inches viewable ) intelligent, microprocessor based monitor compatible with most analog RGB (Red, Green, Blue) display st[...]

A2 Precautions Danger T o avoid shock hazard: • Do not remove the covers. • Do not operate this product unless the stand is attached. • Do not connect or disconnect this product during an electrical storm. • The power cord plug must be connected to a properly wired and grounded power outlet. • Any equipment to which this product will be a[...]

A3 Working Practices Rest T ake regular breaks. V ary your posture, and stand up and stretch occasionally as prolonged use of computer workstations can be tiring. Back Y ou should sit back in the chair and use the back rest. Hands Use a light touch on the keyboard, keeping your hands and fingers relaxed. Allow a space in front of the keyboard to re[...]

A4 Power Source: 1. Make sure the power cord is the correct type that required in your area. 2. This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area ( No user adjustment is required. ) 3. Connect the power cord into your monitor ’s power input socket, and then plug the other end into a [...]

Tilt/Swivel Base T urn Off the equipment and all attached options. Carefully set the monitor face-down with the underside facing you. Installation 1. Align the hooks on the tilt/swivel stand with the matching slots in the base of the monitor . 2. Insert the hooks into slots. 3. Slide the tilt/swivel stand toward the front of the monitor until the l[...]

A6 Signal Cable D-15P Connecting the Monitor On the back of the monitor are two plug-in connections; one for the AC power cord, and the other for the signal cable from the video card. Power off both the monitor and PC. Connect the 15 pin VGA connector of the supplied signal cable to the output VGA video connector on the PC and the matching input co[...]

A7 Location and Function of Controls Location and Function of Controls Front View AC Power Socket D-Sub Signal Cable ID Label Power Indicator Rear View Power Button Digital Control Panel OSD Button CB775-english 99.7.55:9 PM ˘ ` A 7[...]

A8 Control Panel Function Front Panel Controls OSD Button Use this button to enter or exit the on screen display . Use this button to enter a selection in the on screen display . Use these buttons to choose or adjust items in the on screen display . SET Button Buttons The power indicator light is shown in the power button. This indicator lights up [...]

A9 Making adjustments to the image size, position and operating parameters of the monitor are quick and easy with the On Screen Display Control system, using only the Enter button and Adjustment Control buttons. A quick example is given below to familiarize you with the use of the controls. Following this section is an outline of the available adju[...]

A10 On Screen Display(OSD) Selection and Adjustment Y ou were introduced to the procedure of selection and adjusting an item using the OSD system. Listed below are the icons, icon names, and icon descriptions of the items that are shown on the Menu. OSD Adjust Description BRIGHTNESS CONTRAST 66 92 COLOR PRESET TEMP RED GREEN BLUE 6550K 9300K POSITI[...]

A1 1 OSD Adjust Description SIZE 49 64 SHAPE VIDEO LEVEL 0.7V DDC ON LANGUAGE ENGLISH OSD POSITION SETUP V ertical Size T o adjust image height. Horizontal Size T o adjust image width. Side Pincushion T o correct the bowing in and out of the image. Side pincushion balance T o correct the balance of both sides bowling. T rapezoid T o correct geometr[...]

A12 OSD Adjust Description T o manually demagnetize the screen which may show some image or color incorrectly . DEGAUSS ON RECALL OFF MOIRE H: 0/V : 0 54.4kHz/60.0Hz USER MODE SPECIAL DEGAUSS If the monitor is operating in a factory preset mode, this control will reset the image to the factory preset mode. If the monitor is operating in a user mode[...]

A13 CB775-english 99.7.55:9 PM ˘ ` A 1 3 The monitor has 31 memory locations for display modes, 6 of which are factory preset to popular video modes. ■ Display Modes (Resolution) ■ User Modes The monitor can accept new video data. If the monitor detects a new video mode that has not been present before or is not one of the preset modes, it sto[...]

A14 Energy Saving Design This monitor complies with the EP A's Energy Star program, which is a program designed to have manufacturers of computer equipment build circuitry into their products to reduce power consumption during time of non-use. This monitor also goes into its energy saving mode if you exceed the monitor's operating limits,[...]

A15 Low Radiation Compliance (MPR II) This monitor meets one of the strictest guidelines available today for low radiation emissions, of fering the user extra shielding and an antistatic screen coating. These guidelines, set forth by a government agency in Sweden, limit the amount of emission allowed in the Extremely Low Frequency (ELF) and V ery L[...]

A16 T roubleshooting Self diagnostics message. The signal cable is not connected. OUT OF FREQUENCY message appears. The frequency of the sync input is outside the operating range of the monitor . *Horizontal Frequency: 30-70kHz *V ertical Frequency: 50-160Hz Use the graphics board's utility software to change the frequency setting (Refer to th[...]

Further help If you are unable to correct the problem yourself, you may seek further help as follows: Call IBM HELPCENTER. In the US call 1-800-772-2227 In Canada call 1-800-565-3344 In other countries, contact your dealer , retailer , or other IBM authorized servicer . Before calling, please have available as much of the following information as p[...]

A18 Service Unplug the monitor from the wall outlet and refer servicing to qualified service personnel when : The power cord or plug is damaged or frayed. Liquid has been spilled into the monitor . The monitor has been exposed to rain or water . The monitor does not operate normally following the operating instructions. Adjust only those controls t[...]

Specifications Sync Signal type A19 T ype Separate sync H. sync H. sync V . sync V . sync Pin Separate Sync 1 Red 2 Green 3 Blue 4 Ground 5 Self-T est 6 Red Ground 7 Green Ground 8 Blue Ground 9N C 10 Ground 1 1 Ground 12 SDA 13 Horiz.Sync 14 V ert.Sync 15 SCL 15 6 10 11 15 Signal Connector Pin Assignment CB775-english 99.7.55:9 PM ˘ ` A 1 9[...]

A20 Specifications Picture tube 15 inches (13.8 inches viewable) FST , 90˚ deflection 0.28 mm dot pitch, Non-glare, Darkface AR-ASC (Anti-Reflective Anti-Static Coating) Sync Input Horizontal Frequency : 3 0 - 70kHz (Automatic) V ertical Frequency : 50 - 160Hz (Automatic) Input Form : Separate, Positive/Negative Signal input : 15 pin D-Sub Connect[...]

Compliances Federal Communications Commission(FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and [...]

Power Cord: For your safety , IBM provides a power cord with a grounded attachment plug to use with this IBM product. T o avoid electrical shock, always use the power cord and plug with a properly grounded power outlet. IBM power cords used in the United States and Canada are listed by the Underwriters Laboratories (UL) and certified by the Canadia[...]

MPR II This product complies with Swedish National Council for Metrology (MPR) standards issued in December 1990 (MPR II) for very low frequency (VLF) and extremely low frequency (ELF). European Union (EU) Statement This product has been tested and found to comply with the limits for Class B Information T echnology Equipment according to CISPR 22/ [...]

W arranty Statement of Limited Warranty The warranties provided by IBM in this Statement of Limited W arranty apply only to Machines you originally purchase for your use, and not for resale, from IBM or your reseller . The term “Machine” means an IBM machine, its features, conversions, upgrades, elements, or accessories, or any combination of t[...]

When a type of service involves the exchange of a Machine or part, the item IBM or your reseller replaces becomes its property and the replacement becomes yours. Y ou represent that all removed items are genuine and unaltered. The replacement may not be new , but will be in good working order and at least functionally equivalent to the item replace[...]