Meco 7900 manual

Aussie ® ® b b y y M M e e c c o o ® LP Gas Grill Assembly and Use Manual Koala T T M M For Customer Service, call 1-800-251-7558 or visit our web site at www .meco.net FOR OUTDOOR HOUSEHOLD USE ONL Y . NOT FOR COMMERCIAL USE. • Failure to follow these instructions could result in fire or explosion which could cause death, serious personal inj[...]

2 I. Assembly Instructions.......................................................2 Parts Illustrations................................................................3 Parts List............................................................................4 S tep 1) Cart Assembly .........................................................6 S tep 2) Ass[...]

3 P ARTS ILLUSTRA TIONS If you need replacement parts, refer to the Parts Illustrations and the Parts List to find the exact parts you need. If you have any questions which require help, contact Customer Service and be sure to mention the model number of your grill. (14) Hood/Bowl Assembly (13) Hood (21) Screw , ST4.0 x 10mm (19) Right Sidebrace (2[...]

(37) Heat Shield (38) Handle Spacer (39) Hood Handle (40) Flame Diffuser (41) Cooking Grid (43) Fabric Panel (45) LP Cylinder Heat Shield (44) Main Burner (46) Main Burner Electrode (47) Control Panel w/Manifold and Regulator (35) Side Burner Grid (42) W arming Rack 4 (36) Bolt, M6x75 2 pc[...]

5 0 0 3 3 . . 6 6 2 2 2 2 2 2 . . 0 0 2 2[...]

6 STEP 1) Cart Assembly: Att ach the Legs to the Bottom Shelf with M5 x 35 Bolt s threaded into the Bottom Shelf holes. Position legs with the holes exactly as indicated . VELCRO P A TCHES INSIDE FRONT FIXED LEG AND WHEEL LEG (4) LEFT FRONT WHEEL LEG T o reduce the risk of a cut injury: · Wear protective gloves when handling part s that have sharp[...]

STEP 2) Assemble Axle, Wheels & Wheel Covers: 7 Step 3) Assemble Hood/Bowl to Cart: · With Cart upright, align Bowl Bracket legs with Cart legs. (FIG . 3A) NOTE: REQUIRES 2-PERSONS · Lower Hood/Bowl to allow ends of Cart legs to insert into Bowl Bracket legs. · Press downward until leg screw holes align. · Insert M6x35 Screws and tighten wi[...]

8 Step 4) Install Drip Cup: Insert Drip Cup into Drip Cup Holder ring until the cup flange is flush with the ring and the notch in the lip of the cup fit s the vertical hanger wire. (17) Drip Cup Step 5) Assemble Sidebraces and Rear Crossbrace: · Att ach Right and Lef t Sidebraces (19 & 20) to legs with ST4.0 x 10 Screws. (FIG . 5A) Secure Bot[...]

(28) Screw, M6x15 8 pcs (28) Screw , M6X15 FIG . 6A FIG . 6B (28) Screw , M6x15 (27) Lef t Side T able (26) Right Side T able Step 6) Assemble Side T ables: Align bracket holes of Lef t and Right Side T ables with holes in Bowl Leg Brackets. Att ach Side T ables with M6X15 Screws underneath. Step 7) Assemble Side Burner V alve and Knob: · Align V [...]

10 Step 8) Assemble Side Burner Electrode and Side Burner: · Feed Electrode wire through upper lef t hole from large center hole in Side Burner Reflector . (FIG . 8A) Allow electrode to follow wire into hole and lie flat. (8B) FIG . 8A (32) Side Burner Electrode 1 pc (33) Side Burner 1 pc (23) Wingnut, M4 1 pc FIG . 8B · Insert Side Burner tube t[...]

11 (37) Heat Shield (38) Handle Spacer (38) Handle Spacer 2 pcs (37) Hood Heat Shield 1 pc (39) Hood Handle FIG . 9 (36) Bolt, M6x75 (36) Bolt, M6x75 2 pcs Step 9) Att ach Hood Handle and Shield: Open Hood. Insert M6 Bolt s through Heat Shield, Hood, through large end of Handle Sp acers and to the Handle. Tighten bolts into the Handle inserts. Do n[...]

Step 1 1) Install Warming Rack/Cooking Grid: Position W arming Rack as shown. (FIG . 1 1A) Insert legs 1 and 2 in holes on right side of grill Bowl and Hood respectively . While holding leg 3, insert leg 4 into hole on hood. Carefully position leg 3 into hole in grill Bowl and allow it to spring outward into position. Lay Cooking Grid onto the Bowl[...]

13 T o reduce the risk of serious bodily injury or death: · Use only propane gas in this LP gas grill. · Do not attempt to convert an LP unit to natural gas. · Any use or alteration of this unit not intended could be unsafe and will void your warranty . · Always use a gas appliance out doors in an open area with good ventilation to avoid breath[...]

Cylinder Ret ainer Clip Cylinder Carry Handle T o avoid pinching, keep fingers and hands near corners of Cylinder Ret ainer Clip when swinging Clip over cylinder . 4) Swing the Cylinder Ret ainer Clip over round shoulder of the LP cylinder . Exert pressure at ends of clip until it stop s at the cylinder carrying handle. Cylinder Ret ainer Clip Rot [...]

15 T o reduce the risk of serious bodily injury or death: · This outdoor cooking appliance shall be used only out doors and shall not be used in a building, garage, or any other enclosed area. Locate out door cooking appliance in an area with good ventilation on a level st able surface clear of combustible and flammable material. · Maint ain mini[...]

Side Burner fittings under Side T able 16 FIG . 14C 1. Open the Hood. 2. Import ant: Make sure all control knobs are turned “Off”. (FIG . 15A) 3. T urn the LP Gas Cylinder valve open counter clockwise until it stops. (FIG . 15B) 4. Push the left control knob in and turn counter clockwise to the High flame position. (FIG . 15C & 15D) 5. Paus[...]

17 MANUAL LIGHTING THE GRILL 1. Open the Hood. 2. Import ant: Make sure control knobs are turned “Off”. (See FIG . 15A) 3. T urn the LP Gas Cylinder valve open counter clockwise until it stops. (See FIG . 15B) 4. Insert a lit match through match-lighting hole underneath the grill bowl on the right side. (FIG . 16) 5. Push in and turn the right [...]

18 GRILL COOKING ROASTING COOKING W ARMING RACK W arming racks are a convenient way to keep cooked food warm or to warm items such as bread or rolls. When opening the hood, be alert of dripping fat from the warming rack which could then drip onto the barbecue causing a mess. Always check that your warming rack is properly fitted before use. T o red[...]

3) T urn off the gas at the LP cylinder valve by turning the handle clockwise until it stops. 4) W ait until the grill is cool before closing the hood, cleaning or putting on the cover . 5) Regularly clean your LP gas grill between uses and after extended storage periods. T o maintain the condition and extend the life of your grill, we strongly rec[...]

5) Use a pipe cleaner to clear insect nests from the inlet hole of main burner (FIG . 20C ) and side burner ventilation hole. (FIG . 20D) Open up the main burner holes and the side burner holes with a small nail or wire.Normal wear and corrosion may enlarge some holes, however , if large cracks or holes are found, replace the Burner . Use a brass w[...]

STORAGE T o reduce the risk of serious bodily injury or death: · Store your LP gas grill in a cool dry place. Do not store an LP gas cylinder in a space greater than 125 degrees Fahrenheit. Do not store an LP gas cylinder in a building ,garage or any enclosed area. · Do not store an LP gas cylinder indoors (empty or filled). Disconnect the LP gas[...]

LP gas cylinder is empty LP Excess flow valve tripped in regulator LP Coupling nut is not fully connected to regulator Obstructions in burner T ake LP gas cylinder to licensed LP gas supplier to be refilled. T urn control knobs to “off” position and turn LP gas cylinder handle clockwise until it stops. W ait five minutes. Relight LP gas grill. [...]

I I M M P P O O R R T T A A N N T T N N O O T T I I C C E E This Gas Grill must be used with a LP Gas Cylinder equipped with an OPD (Overfill Prevention Device). This is a secondary device to prevent the overfill of your LP Gas cylinder . The proper methods for the filling of your LP Gas cylinder are by weight or volume, as described in NFP A 58. P[...]

24 P/N 03.6577.00 REV 2/23/07 MECO CORPORA TION LIMITED W ARRANTY This product is warranted to the original consumer purchaser against defects in material and workmanship under normal outdoor household use and correct assembly (if assembled by the consumer-purchaser). Burner and Cooking Grid are warranted for a period of one (1) year from the date [...]