Miele DA 186 manual

Operating and installation instructions Range hood DA 186, DA 188, DA 189 To avoid the risk of personal injury or damage to the appliance, it is essential that you read these operating instructions before installation and use. M.-Nr. 07 837 910 e n-C A[...]

Caring for the environment ..........................................3 IMPORTANT SAFETY INSTRUCTIONS .................................4 Guide to the appliance / Operation ...................................8 Operation .........................................................9 Operation .......................................................1 0 Clea[...]

Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. To prevent suffocation of children, ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of their reach. Disposal of an old appliance Old[...]

READ AND SAVE THESE INSTRUCTIONS Keep these operating instructions in a safe place and pass them on to any future user. Read these Instructions carefully before installing or using the Ventilation System. ~ This appliance is intended for residential use only. Use the appliance only for its intended purpose. ~ This appliance complies with current sa[...]

~ d) Before connecting the appliance to the power supply make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent appliance damage. If in doubt consult a qualified electrician. ~ e) Installation work and repairs should only be performed by a qualified tec[...]

, WARNING TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A COOKTOP GREASE FIRE, OBSERVE THE FOLLOWING* ~ a) SMOTHER FLAMES with a close fitting lid, cookie sheet, or metal tray then turn off the burner. BE CAREFUL TO PREVENT BURNS . If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. ~ b) NEVER PICK UP A FLAMING[...]

Installation , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. ~ b) Sufficient air is needed for combustion and exhausting of gase[...]

Guide to the appliance / Operation 8[...]

a Recirculation grille (for recirculation mode only) b Exhaust connection c Installation bracket d Folding vapour canopy for installation of a cabinet door e Deodorizing filter (accessory available to order for recirculation mode operation) f Cooktop lighting g Grease filter h Control panel Operation Switching the fan on ^ Open the vapour canopy. T[...]

The range hood operates ...i na i r extraction mode: The air is drawn in and cleaned by the grease filters and then directed outside. If your air extraction system does not have a non-return flap, one is provided with the range hood. A non-return flap in the ventilation system ensures that when the range hood is shut off no unwanted exchange can oc[...]

, WARNING. TO REDUCE THE RISK OF ELECTRIC SHOCK OBSERVE THE FOLLOWING: Before servicing and repairing the range hood, disconnect it from the household electrical supply, – by switching off the house panel circuit breaker or – by completely unscrewing screw-type fuses from the house fuse panel Housing The surfaces and control panel are sensitive[...]

Washing the grease filter by hand ^ Clean the grease filters with a dish brush dipped in a mixture of warm water and a mild dish liquid. Do not use undiluted or concentrated dish liquid. Do not use the following: – lime removers, – scouring powder, scouring liquid, or any corrosive all-purpose cleaner. – oven spray, Washing grease filters in [...]

Odor Filters If the range hood is set up for recalculation operation, two DKF 14-1 charcoal filters must be added to the grease filters. ^ Open the vapour canopy. ^ Remove the grease filters. ^ Take the charcoal filters out of their packaging. ^ Position the charcoal filters on either side of the fan and twist them into their holders. ^ Put the gre[...]

Changing lamps , WARNING TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY TO PERSONS OBSERVE THE FOLLOWING: Disconnect the exhaust hood from the power supply as follows: – shut off the circuit breaker at the house panel, or – fully unscrew the fuse from the house fuse panel. The halogen lights become very hot when in use. They can cause burns eve[...]

For faults you cannot correct yourself, please contact the Miele Factory Repair Service. The telephone number for the Factory Repair Service is listed on the back cover of these operating instructions. Customer service will require the model designation and serial number of your range hood. These can be found on the data plate, visible when the gre[...]

DA 186 DA 188 DA 189 * Cabinet panel dimensions Air extraction connection C 4 3 / 4 " (120 mm). Appliance dimensions 16[...]

Distance between cooktop and hood Do not install this exhaust hood over cooktops burning solid fuel. Provided a larger distance is not given by the manufacturer of the cooktop, follow the minimum safety distances between a cooktop and the bottom of the hood: Miele Cooktops Non-Miele Cooktops Electric Cooktops 24" (610 mm) Electric Barbeques an[...]

Before installation, read the information on "IMPORTANT SAFETY INSTRUCTIONS". Under certain conditions there is a risk of carbon monoxide poisoning, especially if you operate the range hood simultaneously with an open fireplace. Installing the cabinet door ^ Open the vapour canopy. ^ Pull the sliding catch forward to release the canopy an[...]

Adjusting depth ^ The depth of the unit ("T" in the diagram) can be adjusted from 10 13 / 16 "t o1 4 3 / 16 " (275 to 360 mm) by means of the adjustable brackets.. ^ Slightly loosen the screws holding the brackets. ^ Pull the brackets out to the desired depth "T". ^ Tighten the screws again. ^ To align the depth on the[...]

^ Make a cutting line 13" (330 mm) below the the top edge marking. ^ Find the studs to the left and right of the appliance location by tapping the wall or using a stud finder. ^ Mark a vertical cutting line along the center of each stud. Be careful not to damage any wiring or plumbing that may be located behind the wall. Make sure that the pow[...]

^ For Recirculation the reducing collar with the non-return flap must be removed by unscrewing the screws and installing the recirculation grille. ^ Using a screw driver, pry out one of the covers for feeding through the power cable. ^ Hang the range hood in position using the adjustable brackets. ^ Position the vapour canopy with the cabinet front[...]

The movement of the vapour canopy can be adjusted. This may be necessary, for instance, if a heavy cabinet panel is mounted. In the front of the lower edge of the unit, two openings (right and left) give access to two adjustment screws. ^ Remove both cover caps. ^ Using a Philips screwdriver, adjust both sides evenly: - clockwise: the folding mecha[...]

Securing the appliance to neighbouring wall units or fitting side panels ^ Remove the vapour canopy. ^ With grease filters removed, secure the range hood, or fit the side panels, using two screws per side. For the lower screws, first remove the screw caps, and replace them afterwards. ^ Replace the vapour canopy. ^ For air extraction mode: – Fit [...]

All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer can not be held responsible for unauthorized work. Ensure that power to the appliance is OFF while installation or repair[...]

, WARNING Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl space[...]

– If the exhaust is ducted through an outside wall, a Miele Telescopic Wall Vent can be used. – If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before conne[...]

Total connected load ..........2 6 0W Fan motor .................2 2 0W Cooktop lighting ..........2x2 0W Power supply voltage ......... 1 2 0V Cycles (Hz) ................~6 0H z Fuse rating (amps) .............1 5A Technical data 27[...]

Alteration rights reserved / 2810 M.-Nr. 07 837 910 / 00[...]