Omron BP762 manual

7 series Plus Blood Pressur e Monitor with C omF it TM C uff Model BP762 INSTRUCTION MANU AL ENGLISH HEM-7220-ZCS_A_M_e_sp_100510.qxd 10/5/10 10:24 AM Page 1 ES P AÑO L[...]

2 Before Using the Monitor Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Operating the Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Ris[...]

3 Thank you for purchasing the Omron ® 7 series Plus BP762 Automatic Blood Pressure Monitor with ComFit TM Cuff. INTRODUCTION Fill in for future referenc e. DA TE PURCHASED: __________________ SERIAL NUMBER: ____________________ Y our new blood pressure monitor uses the oscillometric method of blood pressure measurement. This means the monitor det[...]

4 T o assur e the corr ect use of the pr oduct basic safety measur es should always be followed including the warnings and cautions listed in this instruction manual. W ARNING Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury . SAFETY SYMBOLS USED IN THIS INSTRUCTION MANUAL CAUTION Indicates [...]

OPERA TING THE DEVICE (continued) This device is intended for use in measuring blood pressure and pulse rate in the adult population. Do not use this device on infants or persons who cannot express their intentions. Read the Special Conditions section (page 29) of the instruction manual if your systolic pressure is known to be more than 220 mmHg. I[...]

RISK OF ELECTRICAL SHOCK Do not plug or unplug the power cord into the electrical outlet with wet hands. Do not overload power outlets. Plug the device into the appropriate voltage outlet. CARE AND MAINTENANCE Do not subject the monitor to strong shocks, such as dropping the unit on the floor . Do not submerge the device or any of the components in[...]

7 BEFORE T AKING A MEASUREMENT T o ensure a reliable reading follow these recommendations: 1. A void eating, drinking alcohol, smoking, exercising, and bathing for 30 minutes prior to taking a measurement. Rest for at least 15 minutes prior to taking the measurement. 2. Stress raises blood pressure. A void taking measurements during stressful times[...]

8 KNOW Y OUR UNIT Main Unit: Air Jack Battery Compar tment Start/Stop Button USER ID Selection Switch Memor y ( ) Button Display AC Adapt er Jack Operating Instructions Up/Down ( / ) Buttons SET Button HEM-7220-ZCS_A_M_e_sp_100510.qxd 10/5/10 10:24 AM Page 8[...]

KNOW Y OUR UNIT 9 Componen ts: Arm Cuff Air T ube Air Plug (Connects to Air Jack) AC A dapter Storage Case Housing Cord 7 series Plus Blood Pressure Monitor with ComFit TM Cuff Model BP762 INSTRUCTION MANUAL ESPAÑOL ENGLISH Quick Start Guide Instruction Manual HEM-7220-ZCS_A_M_e_sp_100510.qxd 10/5/10 10:24 AM Page 9[...]

10 UNIT DISPLA Y Diastolic Blood Pressure Systolic Blood Pr essure Movement Symbol Pulse Display / Memory Number Date/Time Display Low Battery Indicator Deflation Symbol Heartbeat Symbol Av erage V alue Symbol Memory Symbol USER ID Symbol (A/B) Blood Pressure L evel Indicator Cuff Wrap Guide Irregular Heartbeat Symbol HEM-7220-ZCS_A_M_e_sp_100510.q[...]

11 IRREGULAR HEAR TBEA T SYMBOL ( ) When the monitor detects an irregular rhythm two or more times during the measurement, the Irregular Heartbeat Symbol ( ) will appear on the display with the measurement values. An irregular heartbeat rhythm is defined as a rhythm that varies by less than 25% from the average rhythm or 25% more than the average r[...]

Internationally recognized guidelines for upper limit of normal home blood pressure readings are as follows: Home Guideline for Upper Limit of Normal BP Systolic Blood Pressure 135 mmHg Diastolic Blood Pressure 85 mmHg This is a general guideline because blood pressure depends on age and morbidity . A lower home blood pressure goal may be recommend[...]

IMPORT ANT SAFET Y INSTRUCTIONS SA VE THESE INSTRUCTIONS NO TES: • Use only the authorized Omron AC Adapter that came with this monitor . • W e recommend you install the batteries even if the AC Adapter is used. If no batteries are installed, you may need to reset the date and time if the AC Adapter is disconnected. The measurement results will[...]

TO CONNECT THE AC ADAPTER ① Insert the AC Adapter Plug into the AC Adapter Jack on the back side of the monitor as illustrated. ② Plug the AC Adapter into a 120V AC outlet (60 cycles). TO DISCONNECT THE AC ADAPTER ① Hold the Housing to remove the AC Adapter from the electrical outlet. ② Remove the AC Adapter plug from the monitor . W ARNING[...]

1. Remove the battery cover by pulling the hook up while pushing it in the direction of the arrow . 2. Install 4 “AA” size batteries so the + (positive) and - (negative) polarities match the polarities of the battery compartment as indicated. 3. Replace the battery cover . BA T TERY INST ALLA TION 15 Battery Cover HEM-7220-ZCS_A_M_e_sp_100510.q[...]

BA TTERY REPLACEMENT When the Low Battery Indicator appears on the display screen turn the monitor off and remove all the batteries. Replace with four new batteries at the same time. Longlife alkaline batteries are recommended. CAUTION If battery fluid should get in your eyes, immediately rinse with plenty of clean water . Contact a physician immed[...]

17 Set the monitor to the current date and time before taking a measurement for the first time. If the date and time are not set correctly , the measurement values stored in the memory and the average values may not be correct. If the date and time are not set, “-:--” appears during or after measurement. The Blood Pressure Monitor automatically[...]

1. TO ST ART THE SETTING Press the SET button to adjust the date and time. The year flashes on the display . 2. SETTING THE YEAR The year can be set between 2010 and 2040. When the display reaches 2040, it will return to 2010. Press the Up button ( ) to advance by one year . Press the SET button to set the current year . The month flashes on the di[...]

19 SET TING THE DA TE AND TIME 3. SETTING THE MONTH Press the Up button ( ) to advance by one month. Press the SET button to set the current month. The day flashes on the display . 4. SETTING THE DA Y Press the Up button ( ) to advance by one day . Press the SET button to set the current day . The hour flashes on the display . HEM-7220-ZCS_A_M_e_sp[...]

20 5. SETTING THE HOUR The time is set using AM or PM. Press the Up button ( ) to advance by one hour . Press the SET button to set the current hour . The minute flashes on the display . 6. SETTING THE MINUTE Press the Up button ( ) to advance by one minute. Press the SET button to set the minute setting. 7. TO TURN THE MONIT OR OFF Press the ST AR[...]

CAUTION Read all of the information in the instruction manual and any other literature in the box before operating the unit. CAUTION This device is intended for use in measuring blood pressure and pulse rate in the adult population. Do not use this device on infants or persons who cannot express their intentions. APPL YING THE CUFF ON THE LEFT ARM [...]

22 3. Hold the thumb grip on the cuff securely with your right hand. 4. T urn the palm of your left hand upward. 5. Apply the cuff to your left upper arm so the blue stripe is on the inside of your arm and aligned with your middle finger . The air tube runs down the inside of your arm. The bottom of the cuf f should be approximately 1/2" above[...]

23 6. W rap the cuff firmly in place around your arm using the cloth fastener . APPL YING THE ARM CUFF HEM-7220-ZCS_A_M_e_sp_100510.qxd 10/5/10 10:24 AM Page 23[...]

APPL YING THE CUFF ON THE RIGHT ARM When taking a measurement using the right arm use this instruction for Step 5 on page 22. Apply the cuff to your right upper arm so the thumb grip is centered on the inside of your inner arm. The bottom of the cuf f should be approximately 1/2'' above your elbow . NO TE: Be careful not to rest your arm [...]

The monitor automatically determines your ideal inflation level. In rare circumstances when a higher inflation may be necessary , the monitor automatically re-inflates the cuff up to 30 mmHg higher than the initial inflation and restarts the measurement. W ARNING Contact your physician for specific information about your blood pressure. Self-diagno[...]

1. Press the ST AR T/STOP button to turn the monitor on. All symbols appear on the display . 2. Select your USER ID (A or B). 3. Sit on a chair with your feet flat on the floor . Place your left arm on a table so the cuff is level with your heart. T AKING A MEASUREMENT 26 HEM-7220-ZCS_A_M_e_sp_100510.qxd 10/5/10 10:24 AM Page 26[...]

4. Press the ST AR T/STOP button. The cuff starts to inflate automatically . As the cuff inflates, the monitor automatically determines your ideal inflation level. This monitor detects the pulse during inflation. Do not move your arm and remain still until the entire measurement process is completed. NO TE: T o stop the inflation or measurement, pr[...]

T AKING A MEASUREMENT 28 6. When the measurement is complete, the arm cuf f completely deflates. Y our blood pressure and pulse rate are displayed. 7. Press the ST AR T/STOP button to turn the monitor off. NO TE: The monitor will automatically turn off after two minutes. W ARNING Contact your physician for specific information about your blood pres[...]

SPECIAL CONDITIONS CAUTION Inflating to a higher pressure than necessary may result in bruising where the cuff is applied. If your systolic pressure is known to be more than 220 mmHg, press and hold the ST AR T/STOP button until the monitor inflates 30 to 40 mmHg higher than your expected systolic pressure. NO TES: • Do not apply more pressure th[...]

The monitor is designed to store the blood pressure and the pulse rate in the memory for two people (USER A and USER B) every time a measurement is completed. The monitor automatically stores up to 60 sets of measurement values (blood pressure and pulse rate) for each user (A and B). When 60 sets of measurement values are stored, the oldest record [...]

TO DISPLA Y THE MEASUREMENT V ALUES 1. Press the ST AR T/STOP button to turn the monitor on. 2. Select your USER ID (A or B). 3. Press the Memory button ( ). The A verage Symbol ( ) appears on the display when the average reading is shown. 4. Press the Down button ( ) to display the most recent set of measurement values on the screen. The values ar[...]

32 USING THE MEMORY FUNCTION TO DELETE ALL V ALUES STORED IN THE MEMOR Y The values stored in the memory are deleted by USER ID. Y ou cannot partially delete values stored in the memory . All values will be deleted. 1. Press the ST AR T/STOP button to turn the monitor on. 2. Select your USER ID (A or B). 3. While holding the Memory button ( ), pres[...]

33 T o keep your blood pr essur e monitor in the best condition and pr otect the unit fr om damage, follow the dir ections listed below: Keep the monitor in the storage case when not in use. Make sure the AC adapter is placed under the main unit so that it does not damage the display . A void kinking or sharply bending the AC Adapter cord. Do not f[...]

Use the unit consistent with the instruction provided in this manual. CAUTION Changes or modification not approved by Omron Healthcare will void the user warranty . Do not disassemble or attempt to repair the unit or components. CAUTION Use only Omron authorized parts and accessories. Parts and accessories not approved for use with the device may d[...]

35 ERROR INDICA TORS ERROR INDICA T ORS AND TROUBLESHOO TING TIPS Refer to “Applying the Arm Cuff”. Cuff is not applied correctly . Replace the four batteries. Refer to “Battery Installation”. Batteries are worn Air plug disconnected. Insert the plug securely . Refer to “Applying the Arm Cuff”. Arm cuff not applied correctly . Apply the[...]

36 ERROR INDICA T ORS AND TROUBLESHOO TING TIPS PROBLEM CA USES AND SOL UTIONS No power . No display appears on the unit. Replace all four batteries with new ones. Check the battery installation for proper placement of the battery polarities. Measurement values appear too high or too low . Blood pressure varies constantly . Many factors including s[...]

37 FC C ST A TEMENT NO TE: POTENTIAL FOR RADIO/TELEVISION INTERFERENCE (for U.S.A. only) This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The produ[...]

LIMITED W ARR ANT Y 38 Y our Omron ® BP762 Automatic Blood Pressure Monitor , excluding the arm cuff, is warranted to be free from defects in materials and workmanship appearing within 5 years from the date of purchase, when used in accordance with the instructions provided with the monitor . The arm cuff is warranted to be free from defects in ma[...]

39 Model: BP762 (HEM-7220-ZCS) Display: LCD Digital Display Measurement Range: Pressure: 0 to 299 mmHg, Pulse: 40 to 180/min. Accuracy/Calibration: Pressure: ±3mmHg or 2% of reading Pulse: ±5% of reading Inflation: Automatic by electric pump Deflation: Automatic pressure release valve Rapid Air Release: Automatic exhaust valve Measurement Method:[...]

Manufactured by OMRON HEAL THCARE Co., Ltd. Made in China Distributed by: Omron Healthcar e, Inc. 1200 Lakeside Drive Bannockburn, IL 60015 www .omronhealthcare.com Copyright © 2010 Omron Healthcare, Inc. HEM-7220-ZCS_A_M_e_sp_100510.qxd 10/5/10 10:24 AM Page 40[...]