Oricom 200 manual

Baby Monitor Secure 200 User Guide[...]

T ABLE OF CONTENTS W ARNINGS AND SAFETY INFORMA TION 1 GETTING ST ARTED 3 YOUR BABY MONITOR 5 LCD DISPLA Y OF BABY MONITOR 8 BASIC OPERA TION 9 MENU SETTINGS 14 TROUBLESHOOTING 19 PRODUCT SPECIFICA TIONS 20 GUARANTEE 21[...]

1 Do not place the cord in a high "wear and tear" location. Never use a frayed or compromised cord. Never use or place your Parent or Baby units in or near moisture or water (e.g. near bath or pool). Immersing in water can cause electric shock and even death. Power requirements In Australia this product requires an electrical supply of 22[...]

2 W ARNINGS AND SAFETY INFORMA TION Battery requirements Each parent unit requires two rechargeable Ni-MH batteries, size AAA 1.2V 800mAh (HR10/44). • Do not dispose of the batteries in a fi re, as they can explode. • Do not open, unscrew or temper with any of your baby monitor units or battery. Always carry out repairs through your authorised[...]

3 Thank you for choosing this monitor from Oricom. Your Secure 200 Baby Monitor offers the best Digital Technology. INTERFERENCE FREE FREQUENCY DECT (Digital Enhanced Cordless Telecommunications) is the most widely used worldwide digital cordless technology, offering amazingly clear sound, long range and maximum voice security. DECT operates on the[...]

4 GETTING ST AR TED 5. Press [ ] to turn the Parent Unit on. • Before fi rst use, or if it has been out of use for a long time, the Parent Unit will need to be charged for 15-16 hours. During this time, the Parent Unit will operate from the Charger pod when switched on. Note that the Parent Unit cannot be used without batteries, even if it is pl[...]

5 YOUR BABY MONITOR Baby unit (Sender) 1 Temperature Sensor Picks up the temperature in your baby's room. 2 Battery Cover For non rechargeable batteries (not supplied). 3 Night light key Press to turn On the night light. Press again to turn Off the light. 4 Power On/Off Key Press to turn ON the Baby unit. Press and hold to turn OFF. 5 Page key[...]

6 YOUR BABY MONITOR Parent unit (Receiver) 12 Battery Cover Rechargeable batteries. 13 Belt Clip 14 Volume Up/Down Keys Adjust the volume at which you hear the sounds in your Baby's room, and scroll through the menu during setting. 15 Power On/Off Key Press to turn the parent unit ON. Press and hold to turn OFF. 15 14 13 12 Left view of baby u[...]

7 YOUR BABY MONITOR 19 Noise level indicators 20 Torch key Press and hold to emit a soft beam of light from the top of the Parent Unit. 21 Talk key Press and hold to talk to your baby or partner in the baby's room via the Baby Unit. Charger Pod 22 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to i[...]

8 LCD DISPLA Y OF BABY MONITOR Baby Unit 1. Battery level indicator 2. Numbers/Characters indicator 3. Temperature indicator 4. Lullaby on/off indicator Parent Unit 1. Sensitivity indicator 2. Night light indicator 3. Battery level indicator 4. Numbers/Characters indicator 5. Temperature indicator 6. Feed time Alarm indicator 7. Lullaby on/off indi[...]

9 BASIC OPERA TION Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels. Note: If the connection between the Parent and Baby Units is broken at any time the green[...]

10 BASIC OPERA TION Baby alert! You can set your Parent Unit to give an extra warning "beep" when the noise levels in your baby's room is high and the red lights on the sound sensor are lit. This is particularly useful if the volume of your Parent Unit is turned down and you are just using the sensor lights to monitor the noise level[...]

11 BASIC OPERA TION 2. Press [ ] key t o scroll to the different lullabies, or to select [Play all?]. 3. Press [ ] key again to start or stop the lullaby. On the Parent Unit 1. Press [ ] key, then use [ / ] keys to scroll to "Lullaby". Press [ OK ] key. 2. "Play?" is shown on the display. Use [ / ] keys to scroll to "Select[...]

12 BASIC OPERA TION Talk to your Baby You can speak to your baby from the Parent Unit, perhaps to reassure them that you are on your way. Press and hold [ ] key and speak into the front of the Parent Unit. • Please note that you will not be able to hear your baby while you are speaking to them until you release [ ] key again. Customize your Baby [...]

13 BASIC OPERA TION Charging the Battery The Parent Unit will work for up to 10 hours with fully charged batteries. If a battery low alert tone is heard and the battery icon on the Parent Unit's display is fl ashing, you should put the parent unit on the Charger Pod to recharge the batteries. You can still use your Parent Unit from the Charge[...]

14 MENU SETTINGS Note: All Menu settings operations are only available on the Parent unit. During setting, press [ ] key to exit. Night light Setting You can turn on or off the night light on the baby unit via the parent unit. 1. Press [ ] key on the parent unit and use [ / ] keys to select "Night Light". The display is shown below: 2. Pr[...]

15 MENU SETTINGS 1. Press [ ] key on the parent unit and use [ / ] keys to select "Sensitivity". The display is shown below: 2. Press [ OK ] key and then use [ / ] keys to select the sensitivity level. There are 5 levels. 3. Press [ OK ] key to confirm and "Saved" is shown on the display. Sound Alert Setting You can set the soun[...]

16 MENU SETTINGS Press [ ] key on the parent unit and use [ / ] keys to select "Temperature". The display is shown below: Set desired baby room temperature range 1. Press [ OK ] key, "Set Range" is shown on the display. 2. Press [ OK ] key, use [ / ] keys to set the upper and lower temperature limits. 3. Press [ OK ] key to conf[...]

17 MENU SETTINGS Set the time 2. Press [ OK ] key and "Set time" is shown on the display. Press [ OK ] key. 3. "Year" is shown on the display. Use [ / ] keys to select the correct year. Press [ OK ] key. 4. "Month" is shown on the display. Use [ / ] keys to select the correct month. Press [ OK ] key. 5 . "Day"[...]

18 MENU SETTINGS Set the fi rst or next feed time 1. Press [OK] key, "Set Time" is shown on the display. 2. Press [ OK ] key, then follow the procedures in the Set the time of Clock Setting to set the hour and minute. Set the interval for following feeds 1. Press [ OK ] key and use [ / ] keys to select "Set Interval". 2. Press [...]

19 TROUBLESHOOTING Problem Possible cause(s) The red power lights do not turn on when you plug in the power. 1. Check if the units are properly connected to the power supply. 2. Check if the power is turned on. If not, Press [ ] to turn on the power. The green Link light on the Parent Unit is fl ashing and cannot hear the sounds from your baby&apo[...]

20 PRODUCT SPECIFICA TIONS Feature Speci fi cations Operating Frequency DECT 1.8 GHz Range Up to 300m under optimum conditions. The range is reduced in buildings (up to 50m) as a result of walls, doors etc. Power supply (Baby Unit) Input: 240 V AC 50Hz Output: 6 V DC , 200 mA, Non rechargeable batteries, baby unit (not included in the package cont[...]

21 GUARANTEE Warranty (Australia) (a) Warranty Oricom International Pty Ltd (Oricom) warrants that the product is free from defects in materials and workmanship for a period of 12 months effective from the date of purchase. This warranty in no way affects your statutory warranty under the Trade Practices Act 1974 or any other similar legislation. I[...]

Australia Oricom International Pty Ltd Locked Bag 658 South Windsor, NSW 2756 Customer Support Email: support@oricom.com.au Web: www.oricom.com.au Phone: 1300 889 785 Fax: (02) 4574 8898[...]