Oricom PMR1200 manual

Operating Instructions PMR1200 40 Channel UHF 2 Way Citizen Band Radio ®[...]

®[...]

3 T able of contents Safety Information and Warnings ................................... 4 Getting Started .............................................................. 8 Oricom PMR1200 instructions...................................... 12 Operation ..................................................................... 13 UHF channels and frequenci[...]

4 Safety Information and Warnings Safety Information and W arnings WARNING Information on Safe Operation Read This Information Before Using Y our Oricom Radio. Radio Antenna Do not use any radio that has a damaged antenna. If a damaged antenna comes in contact with the skin, a minor burn may result. Unauthorized antennas, modifications, or attachme[...]

5 Safety Information and Warnings WARNING Potentially Explosive Atmospheres T urn your radio OFF when in any area with a potentially explosive atmosphere. Sparks in such areas could cause an explosion or re resulting in injury or even death. NOTE: Areas with potentially explosive atmospheres are often, but not always clearly marked. They include[...]

6 Safety Information and Warnings WARNING Radio Operation and EME Exposure Unauthorized antennas, modifications, or attachments could damage the radio and violate compliance. Do NOT hold the antenna when the radio is “IN USE.” Holding the antenna reduces the effective range. Do not use the radio if the antenna is damaged. If a damaged antenna m[...]

7 Safety Information and Warnings WARNING Medical Devices - Pacemakers The Advanced Medical T echnology Association recommends that a minimum separation of 6 inches (15cm) be maintained between a handheld wireless radio and a pacemaker . These recommendations are consistent with the independent research by and recommendations of the U.S. Food and D[...]

8 Getting Started Installation Removing the Belt Clip Pull the Belt Clip latch forward (away from the unit) While pulling the Belt Clip latch, push up the Belt Clip as shown in Figure1. Installing the Belt Clip Slide the Belt clip into the slot as shown in Figure2. A “click” indicates the Belt clip is locked into position. Installing the Batter[...]

9 Getting Started Charging the battery pack a. Insert the small plug in the end of the mains adaptor into the Power -in Connection Jack at the back of the desktop charger . b. Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on the socket set to OFF . c. Switch ON the main socket. The radio must be charged using the mains ada[...]

10 Getting Started Battery meter The battery meter is located in the left corner of the LCD screen. It appears like a battery with three bars inside. These indicate the amount of power available. When the battery level reaches it minimum level, the unit will emit two beep tones and automatically it will power off. Y our PMR1200 can detect the batte[...]

11 Getting Started Battery life Y our radio has a built in power saver to make the batteries last longer . But when you are not using the units, turn them OFF to conserve batter y power . For in vehicle charging the accessory kit SM5100 contains 2 car chargers and 2 shoulder speaker mics. These can be purchased from your re-seller or online at www [...]

12 Oricom PMR1200 instructions Oricom PMR1200 2 W ay CB Radio Antenna Speaker MIC (Microphone) LCD Screen - Displays the current channel selection and other radio symbols. PTT (PUSH to TALK) button - Press and hold to transmit. UP/DOWN Buttons - Press to change channels, volume, and to select settings during programming. PWR(POWER) Button - Press a[...]

13 Operation Operation T urning the Unit ON/OFF T o T urn ON; a. Press and hold the POWER button until the LCD screen turns ON and displays the current channel. T o switch OFF; b. Press and hold the POWER button until the LCD screen turns blank. Changing Channels The PMR1200 has 40 available channels, to communicate with other radio’ s, it must h[...]

14 Operation T o turn the sub-channel function off , simply set the sub- channel to 0 (zero). Y ou can then communicate with other radio’ s setting to the same channel who also turns off the sub-channel operation (or whose unit does not have the sub-channel feature). a. Press the MENU button twice, the current CTCSS sub- channel number ashes o[...]

15 Operation T ransmitting (sending speech) The unit is continuously in the Receive mode when the unit is turned ON and not transmitting. When a signal is received on the current channel, “ RX ” icon will be displayed on the LCD screen and the receiver LED will light up. a. Press and hold the PTT (push to talk) button to transmit your voice. ?[...]

16 Operation a . Press the MENU button 4 times, “ VOX ” icon will be displayed and “ OFF ” ashes on the LCD screen. b . Press the UP button to set the VOX sensitivity into maximum level (the maximum level is “3 ”.) T o deactivate the VOX function, press the DOWN button until “OF” appears on the LCD Screen. c. Press the PTT button[...]

17 Operation Call alert Y our radio can alert you to incoming signal by emitting an audible call tone. Call-Ring tone Y ou can send a Call-ring tone to other radio users to give an alert that you want to communicate with them. Press the CALL button Y ou will hear a ring tone for about two seconds; “ TX ” icon appears on the LCD screen. Any othe[...]

18 Operation Setting the Key T one ON or OFF This feature allows your radio unit to emit a conrmation tone after pressing each button. a . Press the MENU button 10 times, the “ ON ” icon is ashing on the LCD Screen. b. Press the UP or DOWN button to select Key tone On/Off. c. Press the PTT button to conrm your setting. Setting the Dual[...]

19 Operation http://www .oricom.com.au/support/repeater or visit http://www .tropinet.com/uhf-repeaters/ For example, if you wish to access a repeater station in your area which operates on channel 2 you only need to set the Duplex access on this Channel. So, if you are in the range of a local repeater which transmits on channel 2, after setting yo[...]

20 Auxiliary Features Key Lock The Key Lock feature allows the user to disable the UP , DOWN and MENU buttons so that the PMR1200 settings could not be changed accidentally . a . T o activate the key Lock feature, press and hold the MENU button until key lock “ ” icon appears on the LCD Screen. b. T o deactivate the key Lock feature, press and [...]

21 Operation LCD Screen Back Light Every time the Power/Vol button is activated (except PTT and CALL button), the LCD Screen back light will illuminate for 5 seconds. Microphone/Earphone/Charge Jack Y our radio is equipped with an auxiliary microphone, earphone, and charge jack located at the opposite side of the PTT button.[...]

22 Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 No licence is required to own or operate this radio in Australia and New Zealand. The Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 contains the technical parameters, operating requirements, conditions of licence and relevant standards for Citizen Band (C[...]

23 15 476.775 Simplex 16 476.800 Simplex 17 476.825 Simplex 18 476.850 Simplex 19 476.875 Simplex 20 476.900 Simplex 21 476.925 Simplex 22 476.950 No Use 23 476.975 No Use 24 477.000 Simplex 25 477.025 Simplex 26 477.050 Simplex 27 477.075 Simplex 28 477.100 Simplex 29 477.125 Simplex 30 477.150 Simplex 31 477.175 Duplex TX/Simplex 32 477.200 Duple[...]

24 Warranty information (Australia) Oricom makes no other warranties or conditions, express or implied, including as to merchantability and fitness for a particular purpose, except as stated in this Warranty . Any implied warranties that may be imposed by law are limited in duration to the Warranty Period. Oricom warrants that the product is free f[...]

25 Warranty information (Australia) repair the defective product. All component parts removed under this Warranty become the property of Oricom. In the unlikely event that your Oricom product has a recurring failure, Oricom, at its discretion, may elect to provide you with a replacement product of its choosing that is at least equivalent to your pr[...]

26 Customer Support Customer Support If you suspect your product is not functioning to specication, before making a warranty claim please use the following resources. - T roubleshooting Guide in this user guide - Online Frequently Asked Questions - www.oricom.com.au - Email our customer support team on support@oricom.com.au - Contact Oricom Cust[...]

®[...]

Australia Oricom International Pty Ltd Locked Bag 658 South Windsor, NSW 2756 Customer Support Email: support@oricom.com.au Web: www.oricom.com.au Phone: 1300 889 785 Fax: (02) 4574 8898 ®[...]