Philips PCA103CD manual

PHILIPS CD-ROM Drive User’s Manual PCA103CD PCA123CD[...]

Table of Contents Chapter 1 INTRODUCTION ............................. 1 1.1 Features ...................................... 1 1.2 Package Contents .............................. 2 1.3 System Requirements ........................... 2 Chapter 2 INSTALLING YOUR DRIVE .................... 3 2.1 Installing the CD-ROM Drive ................... 3 2.2 Le[...]

i Copyrights And Liabilities Copyright 1996 by Philips Electronics N.V. All rights reserved. No part of this publication may be reproduced or transmitted in any form by any means for any purpose without the prior written permission of Philips Electronics N.V. The information in this manual is subject to change without notice and does not represent [...]

ii and product names are trademarks and registered trademarks of their respective owners. Printed in Taiwan[...]

iii FCC Notice (USA) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if [...]

iv Notice 3: This product complies with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating Electromagnetic Compatibility (89/336/EEC). For the evaluation regarding the electromagnetic compatibility, the following standards were applied: EN 50 082-1, IEC 801-2, IEC 801-3, IEC 801-4 EN 50 [...]

v Klass 1 laser apparat (EN 60825: 1991) Additional remarks: VAROITUS - Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän turyallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle. Varning - Om apparaten används pä annat sätt än i denna bruksanvisning specificerats, kan anv[...]

vi Important Safety Notice 1. Follow all warnings and instructions marked on the product. 2. Danger: Invisible laser radiation when open. Avoid direct exposure to beam. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Slots and openings in the cabinet and [...]

vii 2. GEVAAR: Bij het demonteren van dit produkt kunt u worden blootgesteld aan onzichtbare laserstraling. Vermijd directe blootstelling aan laserstraling. 3. Trek de stekker van de PC uit het stopcontact voordat u dit produkt schoonmaakt. Gebruik geen vloeibaar reinigingsmiddel of spuitbussen. Gebruik voor het schoonmaken alleen een vochtige doek[...]

vii i 2. Danger : Cet appareil émet des radiations laser invisibles lorsqu'il est ouvert. Veillez à éviter toute exposition directe aux rayons laser. 3. Débranchez votre ordinateur avant de procéder au nettoyage de l'appareil. N'utilisez pas de produit liquide ou d'aérosol de nettoyage. Utilisez plutôt un chiffon propre e[...]

ix 2. Gefahr: Im geöffneten Zustand kann unsichtbare Laserstrahlung entweichen. Vermeiden Sie den direkten Kontakt mit Laserstrahlen. 3. Ziehen Sie den Netzstecker Ihres PC aus der Steckdose, bevor Sie dieses Produkt reinigen. Verwenden Sie keine flüssigen Reinigungsmittel oder Reinigungssprays. Reinigen Sie das Produkt, falls notwendig, mit eine[...]

x Precauzioni Importanti 1. Seguire tutte le istruzioni e precauzioni indicate sul prodotto. 2. Pericolo! Quando l’unità è aperta, c’è una radiazione laser invisibile. Evitare l’esposizione ai raggi laser. 3. Disinserire la spina del PC dalla presa di corrente prima di effettuare operazioni di pulizia sul prodotto. Quando lo si vuole pulir[...]

xi Importante Advertencia de Seguridad 1. Tenga en cuenta todas las advertencias e instrucciones marcadas en el producto. 2. Peligro: Radiación láser invisible al estar abierto. Evite quedar expuesto directamente a rayos láser. 3. Desenchufe su PC de la toma de corriente antes de limpiar este producto. No use detergentes líquidos o detergentes [...]

1 1 Congratulations! You have just made a very important upgrade for your PC. With your new Philips 10X or 12X CD-ROM drive, you can now take advantage of the vast host of multimedia software available today at a higher performance than ever. Whether you are interested in the Encyclopedia Britanica, educational games, using your computer as a digit[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 1 2 movies), Karaoke-CD, CD Extra (CD+), I-trax CD and Photo-CD (both single and multi-session) Front-panel Stop/Eject, audio Play/Skip track control Compatibility with Windows 3.1, Windows 95 and OS/2 Note: The use of the IDE/ATAPI interface means that you can use your PC’s existing IDE interface to set [...]

1 3 Please read this manual thoroughly before installing or using your new CD-ROM drive.[...]

2 3 This chapter guides you through the installation of your new CD-ROM drive. To install the drive, your PC must have a free IDE interface connector, or you must buy an IDE controller card from a computer retailer. (An Enhanced IDE controller card is required if your PC already has a one-port IDE controller). See Appendix A for a brief introductio[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 2 4 Figure 2-1 Inserting the CD-ROM Drive 5. Plug a free power connector inside your PC into the socket on the back of the CD-ROM drive. Digital Audio 39 40 1 2 HOST Interface Power 5V G G 12V Analog C S M S L A ABCDE ABCDE Audio Cable IDE Cabel Power Cabel Red Red Figure 2-2 Back Panel Connections Note: Fi[...]

I NSTALLING Y OUR D RIVE 2 5 audio) connector, labeled “Audio.” The unlabeled jumpers on both models are for factory testing only. 6. Plug a free IDE connector inside your PC into the drive’s socket. The cable’s colored edge must be aligned with the Pin 1 position. Note: If you have a sound card that has an IDE port, you can either connect [...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 2 6 8. (Optional connection for advanced PCA123CD users only ) Use an audio cable with two 2-pin Molex connectors to connect an audio output device that accepts digital audio input to the drive’s “ ” connector. The digital audio connector provides purer sound output than the analog audio connector. 9.[...]

I NSTALLING Y OUR D RIVE 2 7 Windows 95 directory’s COMMAND sub-directory. You can locate this file by using the File Manager’s Search command in Windows 3.x or the Start menu’s Find command in Windows 95. If the file is missing, contact your DOS or Windows 95 distributor for a copy of it. 3. Insert the Installation diskette into a 3.5” flo[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 2 8 3. Double click the icon on the desktop and check whether the CD-ROM icon appears as in the following window: Figure 2-3 “My Computer” Peripherals 4. Double click the folder in the same window. The folder contents are displayed: Figure 2-4 The “Control Panel” Folder Contents 5. Double click the [...]

I NSTALLING Y OUR D RIVE 2 9 Figure 2-5 The “System Properties” Folder 6. Click the tab and check whether the CD-ROM drive is listed. If the CD-ROM icon is listed in both Step 3 and this step, you can stop here. Windows 95 has successfully recognized your new CD-ROM drive. Otherwise, proceed with Steps 7 and 8. 7. Install the supplied device dr[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 2 10 the instructions in Section 2.2.1 and install the supplied device driver under that DOS mode. Why couldn’t I install Windows 95 with its CD disc? Is my CD-ROM defective? No. Your CD-ROM probably had nothing to do with that problem. If you were making an upgrade from Windows 3.1 to Windows 95, you mig[...]

I NSTALLING Y OUR D RIVE 2 11 Figure 2-6 The “System Configuration” Dialog Box 2. Click the CD icon, select from the list box and click the button. Follow the screen instructions until the installation is completed. 3. Reboot your PC. 4. Double click the icon on the desktop to display the following window:[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 2 12 Figure 2-7 The “OS/2 System - Icon View” Window 5. Double click the icon and check whether the CD- ROM icon ( ) appears as in the following list of available drives: Figure 2-8 The “Drives - Icon View” Window 6. If it is listed, you can stop here. OS/2 Warp has successfully recognized your new [...]

I NSTALLING Y OUR D RIVE 2 13 8. Double click the icon. An OS/2 window appears: Figure 2-10 “OS/2 Window” 9. At the command prompt, type: 10. At the end of the opened CONFIG.SYS file, add the following line: 11. Close the file after saving it and reboot your PC. 12. Repeat Steps 4 and 5. This time the CD-ROM icon should appear as an available d[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 2 14 working properly with your IDE controller. Try the diskette version. This page is intentionally left blank.[...]

3 13 3.1 Drive Applications There are two main ways in which you will use your new CD-ROM drive. The first way is as a typical disk drive (albeit read-only). Here, data such as program files, databases, sound clips, video images, etc. is read from the CD into your PC's CPU. The other way is as a CD player. You can use your CD-ROM drive to list[...]

PHILIP S CD-ROM D RIVE U SER ’ S M ANUAL 3 14 1. Disc Tray Opens or closes for disc loading and removal 2. Headphone jack For optional connection to headphones or self-amplified speakers. 3. Headphone volume control Adjusts the volume level of sound coming out from the headphone jack 4. LED indicator Lights up when disc is first put into the tray[...]

15 A 15 Before sliding your CD-ROM drive into the 5.25” drive bay, you have to decide whether the drive is going to be a master or slave device by adjusting the and jumpers on its back. This appendix presents some basic concepts of IDE connections to help you make the decision and describes the way to set the jumpers. A.1 IDE Connections When you[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 16 A 16[...]

A M ASTER OR A S LAVE D EVICE 17 A 17 IDE controllers may contain more than one port and hence contain more than one IDE cable. Such a controller is called an enhanced IDE controller. Its ports are called the primary port, secondary port, tertiary port, etc., usually labeled by the side of the ports. Currently, most enhanced IDE controllers contain[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 16 A 18 port. As a result, if you have more than one IDE device, their assignments may look similar to the following:[...]

A M ASTER OR A S LAVE D EVICE 17 A 19 Device 1 Primary master (boot drive) Device 2 Primary slave Device 3 Secondary master Device 4 Secondary slave Device 5 Tertiary master Device 6 Tertiary slave .. .. .. Note that the primary master, if configured, must be a boot drive (normally a hard disk). Other than this, an IDE device can be configured to a[...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL 16 A 20 A.2 Setting Master and Slave Jumpers Whether your PC system regards your CD-ROM drive as a master device or a slave device depends on which of the “ ” (master) and “ ” (slave) jumpers on the back of the drive is capped. or Slave Mode Master Mode Figure A-3 Jumper Settings for Slave Mode and [...]

A M ASTER OR A S LAVE D EVICE 17 A 21[...]

B 19 Interface Drive interface type: ATAPI IDE (conforms to SFF8020 V1.2) Disc formats: Audio-CD, CD-ROM (mode 1 and mode 2) CD-ROM/XA (mode 2, form 1 and form 2) Video-CD, CD-i/FMV (CD-i movies) CD Extra (CD+), I-trax Photo-CD (single and multisession) Disc size: 80 and 120 mm Performance Data transfer rate: 1,500 KB/sec (10X), 1,800 KB/sec (12X) [...]

PHILIPS CD-ROM D RIVE U SER ’ S M ANUAL B 20 Temperature: +5 C ~ +45 C -20 C ~ +55 C +41 F ~ +113 F -4 F ~ +131 F Humidity: 20% - 80% RH, 20% - 80% RH, Physical Characteristics Dimension: 149 x 42 x 196.5 mm (W x H x D) typical Weight: 0.85 Kg Front panel: Stop/Eject button Audio Play/Skip button Emergency disc eject hole Rotary volume control kn[...]