Planar pjt155r manual

[...]

1 Contents Preface ......................................................................................................................... 2 Installation ................................................................................................................. 4 Unpacking ....................................................................[...]

2 Preface This manual is designed to assist users in setting up and usin g the LCD Monitor. Information in this document has been carefull y checked for accuracy; however, no guar antee is given to the corre ctness of the contents. The information in this document is subject to change without notice. This do cument contains proprietary information [...]

3 Important Safety Instructions Please read the following ins tructions carefully. Th is manual should be retained for future use. 1. To clean the LCD Monitor screen: -- Power off the LCD Monitor and unplug the AC Cord. -- Spray a non-solvent cleaning solution onto a rag. -- Gently clean the screen with dampened rag. 2. Do not place the LCD Monitor[...]

4 Installation Unpacking Before unpacking the LCD Monitor, prepare a suitable wor kspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Make sure that the LCD Monitor has enough space around it for sufficient airflow. Though the LCD Monitor uses very li ttle power, some ventilation is needed to ensure t[...]

5 Viewing Angle Adjustment The LCD Monitor is designed to allow users to have a comfortable viewing angle. The viewing angl e can be adjusted from -2°to +90°.(See fig. 1-1) F i g u r e 1 - 1 Warning Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor[...]

6 Connecting the AC Power 1. Connect the power cord to the LCD Monitor.(See Fig. 1-5) 2. Connect the powe r cord to an AC power source. Connecting the Audio Cable 1. Connect the audio cable to the “LINE OUT “ jack on your PC's audio card or to the front panel' s “AUDIO OUT” jack of your CD ROM drive. (See Fig. 1-6) 2. Connect the [...]

7 Display Controls User Controls A brief description and the location of all LC D Monitor functions controls and indicators: Figure 2-1 1 Power LED will be Green when the monitor is on, Yellow when in power saving mode, and Dark when the monitor is off. Press this button to turn on and turn off the monitor. 2 Function select (clockwise) 3 Function [...]

8 Function Description Icon Function Function Description Brightness 101 scales of brightness are availa ble to choose from (0 to 100). Contrast 101 scales of contrast are available to choose from (0 to 100). H. Position This function let's you adjust the display's horizontal position. V. Position This function let's you adjust the d[...]

9 OSD Lock Out Function When monitor is in normal display, you ca n enable the “OSD Lock Out” function. Option 1 : OSD lock – all 4 buttons are locked except the “POWER” button. Press and hold the , and buttons for same time 3 seconds to lock the buttons. The monitor will show an “OSD Lock Out” messa ge for 5~10 seconds and the messag[...]

10 Technical Information Specifications LCD Panel Size 15" (38.1 cm) Display Type Active matrix color TFT LCD Resolution 1024 x 768 Display Dot 1024 x (RGB) x 768 Display Area (mm) 304.128 x 228.096 (H x V) Display Color 16.7M (RGB 6 bits+Hi-FRC data) Lamp Voltage (typical) 560 Vrms Lamp Current (typical) 8.0 mA rms. Video Input Signal Input I[...]

11 Power Management Mode Power Consumption* AC Input LED Color DPM ON 25W maximum 240 VAC GREEN DPM OFF 2W maximum 240 VAC Yellow DC switch off 1W maximum 240 VAC Dark Meeting VESA DPM requirements measured from AC Input end of AC power cord. Sync Input Analogue Signal Separate TTL compatib le horizontal and vertical synchronization Polarity Positi[...]

12 Standard Timing Table If the selected timing is NOT included in table below, th is LCD monitor will use the most suitable available timing. SYNC TOTAL ACTIVE SYNC FRONT BACK PIXE L TIMING FH(kHZ) FV(HZ) POLARITY (DOT/ LINE) (DOT/ LINE) WIDTH (DOT/LINE) PORCH (DOT/LINE) PORCH (DOT/LINE) FOREQ (MHZ) 640x350 31.469 + 800 640 96 16 48 25.175 VGA-350[...]

13 Troubleshooting This LCD Monitor has been pre-adjusted using factor y standard VGA timings. Due to the output timing differences among various VGA cards in the market, users may initial ly experien ce an unstable or unclear displa y whenever a new display mode or new VGA card is selected. Attention This LCD Monitor Supports Multiple VGA Modes. R[...]

14 Touch Screen Driver Installation The PJT155R/ PJT175R/ PJT195RW is available with USB connection. The touch software is located on the enclosed CD-ROM for these operating systems: Windows® 7, VISTA, XP, 2000, ME, 98, NT4.0, CE, XP Embedded, Linux, Apple® Mac OS Please Note: The PJT155R/ PJT175R/ PJT195RW is Microsoft® Windows® HID (Human Int[...]

15 PJT155R/ PJT175R/ PJT195RW Install Instructions If you are using a PC running Wind ows® 7, VISTA, XP, 2000, ME, 98, NT4.0, follow the instructions below: 1. Power on the PC. 2. Be sure the USB cable is connected from the PC to the LCD display. 3. Download the driver online and execute. 4. Follow the step-by-step instructions as shown on the pop[...]

16 Product Registration and Technical Support Register Your Planar Products Today Thank you choosing Planar. To assure you receiv e all the benefits of your Planar product and services, re gister your Planar product today. Visit our website to register your product at http://www.planar.com/support /product_registration.html Cables, Replacement Lamp[...]

Customer Service 24x7 Online T echnical Suppor t: http://ww w .planar .com/suppor t 1195 NW Compton Drive Beaverton, OR 97006-1992 T el: 1-866-PLANAR1 (866-752-6271), or +1 503-748-5799 outside the United States, Hours: 24 hours a day , 7 days a week 2012 Planar Systems , Inc. Planar is a register ed trademark of Planar Systems , Inc. Other brands [...]