Precor CLIER 835 manual

As sembling and Maintaining the 835 Climber Prec or Incorporated 20031 142nd A venue NE P .O . Bo x 7202 W oodinville, W A USA 98072 -4002 CLM P AG/ OM 300714-2 41 rev E W arranty #36286- 114 14 F ebruary 2011[...]

[...]

[...]

Edition Inf ormation ASSEMBL ING AND MAI NTAININ G THE 835 CLI MBER P/N 300714 - 241 rev E Copyri ght © Febru ary 2 011 Pre cor In corpo rate d. All righ ts reserved. Specificati ons subject to change without no ti ce. Trademark Not e Precor, AMT, and EFX are registered trademarks and Preva is a trademark of Preco r Incorpora ted. Othe r names in [...]

Important S af ety Instructi ons Read the following precaut ions thoroughly before you begin assembly, and save them afterward for future ref erence. Safety Precautions Always follow basic safet y precautions when using this equipment to reduce the chance of injury, fire, or damage. Other sections in this m anual provide more details of safety feat[...]

4 Assembling and M aintaining the 8 35 Climber  Use the power adapter provided with the equipment. Plug the power adapte r into an appro priate, gro unded power outlet a s marked on the equipmen t.  Care should be taken whe n mounting or dismounting the equipme nt.  Read, understand, and test the emergency stop procedures before use.  K[...]

Important Saf ety Instructions 5  If you plan to move t he equipment, obtain hel p and use proper lifting techniques. ref er to the "Moving the Equipment" section of the assembly and maintenanc e guide.  Use the equipment only for its intended purpose as described in this manual. Do not use accessory attachments th at are no t recom[...]

6 Assembling and M aintaining the 8 35 Climber Hazardous Mat erials and Prop er Disposal The ba tteries wit hin self - power ed equipment contai n materials that are consider ed hazardous to the environment . Federal law requires proper disposal of these batteries. If you plan to dispose of your equipment, contact Pre cor Commercial Products Cust o[...]

Important Saf ety Instructions 7 Radio F requenc y Inter ference ( RFI) The RFID module conform s to the following national standards defining acceptable limit s for radio frequency interference (RFI). Federal Communications Commission, Part 15 This equipment has been t ested and found to com ply with the limits for a Class A digital device, pur su[...]

8 Assembling and M aintaining the 8 35 Climber European Applications CE compliance is claimed to the following directives:  1999/ 5/EC R&TTE Dir ective  200 6/95/EC LVD Dir ective  2002/95/EC RoHS Directive Directive compliance has been ver ified to the following standard s:  EN 55022  EN 300 330 - 1 V1.5.1  EN 300 330 - 2 V1.[...]

Important Saf ety Instructions 9 Radio F requenc y Inter ference ( RFI) This Precor exercise equip ment conforms to the follo wing national standards defining acceptable limits for r ad io frequency interference (RFI). Federal Communications Commission, Part 15 This equipment has been t ested and found to comply wit h the limits for a Class A digit[...]

10 Assembling and M aintaining the 8 35 Climber Electrical Recom mendations: All Equ ipment Excluding Trea dmills Note : This is a recommendation only. NEC (National Electric Code) guidelines or local r egion electric codes must be followed. For equipment fitt ed with a P80 console or Personal Viewi ng System (PVS) screen a se parate power connecti[...]

T able of Cont ents Import ant Safety In structi ons ................................................... 3 Safety Pre caution s ................................................................................. 3 Educating Users .................................................................................... 5 Hazardous Mater ials and Proper Dis[...]

12 Assembling and Maintaining the 835 Climb er Self - P owered Featu res ............................................................. 31 Informational Displays Pr ior to Shu tdown ................................... 32 Symptoms of a Low Battery ............................................................. 32 Using the Optional Power A dapter .....[...]

Chapter 1 Assembling the Climber Thank you for choosing Pr ecor. For proper installation, please read this guide thoroughly and fol low the assembly instructions. If you do not assemble the climber according to these guidelines, you could void the Precor Limited Warranty. Unpacki ng the Equi pment Ask for help from two or more people to unpack and [...]

14 Assembling and Maintainin g the 835 Climb er Impo rtan t : When wr ench tighteni ng, the he ad of the f as tener should be flush with the product. If it is not , cross - threadi ng has occurre d. Do not a ttempt to rew ork the asse mbly as more damage to the equipme nt will occur . Contact C ustomer Support. Refe r t o Obtaining Service .  If[...]

Assembling the Climb er 15 Required Tools Before beginning the installation, make sure you have the follo wing too ls avai lab le:  Wire tie cutter  Phill ips scr ewdriver  One ¹₂ - inch combination wrench (open - end or box - end)  SAE Standard socket set  Standard set of hex keys Assembling th e Climber A fish tap e (a thin m[...]

16 Assembling and Maintainin g the 835 Climb er 4. Insert the han dlebar flange onto the screws protruding through the handrail clamp). Rotate the handlebar to align it with the si de screw holes. CAUTIO N : Hold the handlebar upright until it is securely fastened in s tep 6 . Figure 3 : Threading the heart ra te cable and movin g the handlebar in [...]

Assembling the Climb er 17 7. Slide the plastic top cove r onto the uprigh t support. Impo rtan t : The cor rect orie ntation of t he plastic to p cover is shown in the following il lustration. 8. Retrieve the cable assembl y from the console container and remove any packaging ties. Feed the cable assembly through the opening in the console mount, [...]

18 Assembling and Maintainin g the 835 Clim ber 9. Ask your assistant to hold the upright support while y ou attach it to the base frame using four hex head sc rews and four washers. U sing a ¹₂ - inch b ox wrench or open - end wrench, tighten the four fastene rs in alternating order until all four are ful ly secured. Figure 6 : Secur ing the[...]

Assembling the Climb er 19 12. Slide the rubber grommet onto the plastic top cover, as shown in the following illu stration. Apply pressure to s nap it into place. Figure 7 : Sliding the gromm et into pla ce[...]

20 Assembling an d Maintaining the 8 35 Climber Attaching the Handra ils Use the following procedu re to install the external handrails on the climber. To attac h the handra ils: 1. Slide a lower han drail boot onto each handrail. Figure 8 : Adding the handrail boot 2. Insert the lower handrails onto the base pegs, then sl ide the upper portions of[...]

Assembling the Climb er 21 3. Secure the lower handrails using four buttonhead screws and a ⁵₃₂ - inch hex key. Fully tighten the fasteners. 4. Using a ¹₂ - inch soc ket wrench, tighten the t wo nuts beneath the upper handrail clamp unti l the handrails cannot be pulled out of t he clamp. 5. Position the two lower han drail boots so [...]

22 Assembling an d Maintaining the 8 35 Climber 8. Clean the foot steps, p lasti c covers and upright supp ort with a soft cloth or wipe m oistened with an approp riate cleaning solution. For mo re information about which cleaners to use, refer to Daily Cle aning . 9. Level the climber as described in the section Making Sure the Unit Is Stable . Im[...]

Chapter 2 Installing the Console To make installation easier, all Precor Experience Series consoles use the same mo unting hardware and connect or locations whenever possib le. The installation sequence for any of them is as follows:  Threading the cable assembly  Connecting cables  Completing the installation (tight ening the mounting scr[...]

24 Assembling and Main taining the 83 5 Climber 3. Rest the console on the c onsole mount so that the no tch on the bottom of the cons ole ’ s back pla te rests on the rectangular hook at the bottom of the console mount , as shown in the following fi gure. Figure 12 : Console positioning on base unit 4. T ilt the console forward unti l it stops. [...]

Installing the Con sole 25 Connecting Cables (P30) After the console has been seated, separate the individual cables out of the end of th e cable assembly and atta ch them to the appropriate circuit c onnectors ins ide the console. Refer to the following diagram a nd table to identify the cables and connectors. Figure 13 : Cable connections , P30 c[...]

26 Assembling an d Maintaining the 8 35 Climber Completing the Consol e Installation Before you complete the f inal installation steps, doub le - check the connections you have made. Make sure that a ll cables are fully and securely connecte d, and that any unneeded cables are tied back properly. To com pl ete the ins tallation: 1. Feed extra cable[...]

Chapter 3 Maintenanc e To keep t he equipment functi oning properly, perform the minor maintenance tasks in t his section at the int ervals shown on the maintenanc e checklist. Failure to main tain the equipment as described in this section could void the Precor Limited War ranty. DANGER To red uce the risk of electrical shock, a lways disconnec t [...]

28 Assembling and Ma intaining the 83 5 Climber Alternatively, you can clean the equipment with Athletix fitness equipment cleaning wi pes (for more information, v isit www.a thletixpr oducts.com ) CAUTIO N Vacuum the floor underneat h the equipment frequently to prevent the accumulation of dust and dirt that can in terfere with its operation. Use [...]

Maintenance 29 Moving the Equipment The equipment is very heavy. If you plan to move it to a new location, obtain the help of an adult assistant and use prope r lifting techniques. If the eq uipment includes roller wh eels on one end, use the wheels to reduce the load on you rself and your assistant. To mov e the clim ber: 1. Disconnect, unplug, an[...]

30 Assembling and Main taining the 83 5 Climber[...]

Chapter 4 Self - Po w er ed F eatur es Impo rtan t : This chapter of t he manual describes Precor fitness equipment that can operate without being connec ted to AC power. This includes units equippe d with P40 or P20 con soles. H owever, P8 0 consoles must be con nected to AC power through their power supplies to oper ate. For this reason, this cha[...]

32 Assembling and Maintain ing the 835 Clim ber Informational Displays Prior to Shutdown The equipment saves its battery charge by moving into a shutdown mode. If the use r does not maintain the mi nimum rate of moti on, a 30 - secon d shutdown process begins. In this mode, the conso le displays a countdown indicat or and ignores all keypresses. If[...]

Self - Powered Featu res 33 Using the Opti onal Power Adapte r After connecting the powe r adapter to the equipment , plug the opposite end into the a ppr opriat e powe r sou rce ( 120 V o r 240 V). CAUTION: When the o ptional power adap ter is in u se, mak e sure that the power supply cord d oes n ot create a s afety haz ard. Keep it out of the wa[...]

34 Assembling and Mainta ining the 83 5 Climber Replacing th e Battery The equipment ’ s batter y is built to last for a long time. However, if you feel that the battery may need repla cing, check with an authorized s ervice technician. Refer to Obtaining Service . CAUTION: T he batte ry stor ed inside th e equip ment con tains hazardous mater ia[...]

Chapter 5 Commer cial C ar di o v a scular E quipment Limit ed W arr anty PLEASE READ THESE WARRA NTY TERMS AND CONDITIONS C AREFULLY BEFORE USING YOUR PREC OR INCORPORATED PROD UCT. BY USING THE EQUIPMENT, YOU ARE CONSENTING TO BE BOUND B Y THE FOLLOWING WARRANTY TERMS AND CONDITIONS . Limite d War ranty . Precor I ncorp orated w arrant s all new [...]

36 Assembling and Mainta ining the 83 5 Climber Opti ons / Accesso ries Many op tions or a cces sories h ave c omponents that ar e conn ected interna lly or mou nted inside the elec tronic co nsole . The follow ing guide lines determ ine the wa rranty f or the se compone nts. If the inte rnal c ompone nts are instal led by t he fac tory or by an a [...]

Commercial Cardiovascular Equipment Limited W arranty 37 This Li mited Warr an ty sh all not ap ply to: 1. So ftware versi on upgrad es. 2. Softwa re def ects t hat do not m aterially and ne gative ly aff ect the norm al perf orm ance of the p roduct und er norm al co nditions of use . 3. Consuma ble goods or cos meti c items of the pr oduct, the e[...]

38 Assembling and Main taining the 83 5 Climber EXCLUSION OF CONSEQUENTIAL AND INCIDENTAL DAMAGES. PRECOR AND/OR ITS S UPPLIERS SHALL HAVE NO OBLIGATION OR LIABI LITY, WHETHE R ARISING IN CO NTRACT (INCL UDING WARR ANTY), TOR T (INCLUDIN G ACTIVE, PA SSIVE, OR IMPUTED NEGLIGENCE AND STRIC T LIABILITY), OR OTHERWISE, FOR DAMAGE TO THE EQUIPMENT, PRO[...]

Commercial Cardiovascular Equipment Limited W arranty 39[...]

40 Assembling and Main taining the 83 5 Climber[...]

[...]

As sembling and Maintaining the 835 Climber Prec or Incorporated 20031 142nd A venue NE P .O . Bo x 7202 W oodinville, W A USA 98072 -4002 CLM P AG/ OM 300714-2 41 rev E W arranty #36286- 114 14 F ebruary 2011[...]