RedMax US-1 EBZ5100Q manual

US-1 EBZ5100Q U S OWNER 'S/ OPERA T OR'S MANUAL BA CKP A CK BLO WER 848-L3N-93A1 (909) W ARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. W ARNING Before using our products, please read this manual carefully to understand the proper u[...]

US-2 EBZ5100Q SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the blower concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. No[...]

US-3 EBZ5100Q U S 1. Parts location ■ MODEL EBZ5100Q Dimensions (L x W x H) mm (in) ···············································································401x483x495 (15.8 x19.0x19.4) Dry Weight kg (lbs) ····························[...]

US-4 EBZ5100Q For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to make a mistake. (a) The port to refuel the "MIX GASOLINE" Position: Fuel tank cap (b) The direction to close the choke Position: Air cleaner (c) The direction to open the choke Position: A[...]

US-5 EBZ5100Q U S • The blower is used for blowing away leaves and other debris on the ground. When operating the blower, the operater must stand with both feet firmly on the ground. Do not operate the blower while standing on a ladder or a stand. • Under no circumstances may the design of the machine be modified without the permission of the m[...]

US-6 EBZ5100Q 5. For safe operation 2. Before starting operation, always make sure to check if any obstacles are left inside the volute case and net. The obstacles may cause damage on fan and volute case and serious injury. 3. Check to see if the shock-absorbing rubber mount has become cracked or otherwise damaged. Note that failing to replace this[...]

US-7 EBZ5100Q U S 5. For safe operation ordinances. 2. To reduce sound levels, limit the number of pieces of equipment used at any one time. 3. Operate power blowers at the lowest possible throttle speed to do the job. 4. Check your equipment before operation, especially the muffler, air intakes and air filters. ■ For protecting your body from vi[...]

US-8 EBZ5100Q 6. Set up ■ BLOWER TUBES 1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware supplied with the unit. 2. Align the protrusion and the groove provided on the tube ends and twist the tube until connection is locked up. A light lubricant may be used to ease assembly [...]

US-9 EBZ5100Q U S 7. Fuel lines or fuel tank of the engine. • Failures caused by operating engines on gasoline with octane rating lower than 89 are not covered by the RedMax Two- Stroke engine warranty. •A lternative Fuels (Not Gasoline) Alternative fuels, such as E-15 (15% ethanol), E-20 (20% ethanol), E-85 (85% ethanol) are NOT classified as [...]

US-10 EBZ5100Q 7. Fuel test standard has been discontinued by API in 1995 and it no longer exists. • Gasoline/Oil mixture Storage Recommendations Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to limit the entry of moisture and additional air (oxygen). Moisture and air cause the development o[...]

US-11 EBZ5100Q U S 8. Operation ■ CONTROL ARM •H old the upper end of the control arm in hand and, while pulling it away from the unit, rotate arm forward (anti- clockwise as the arrow direction) until it clicks. (The first position) And if you want, you can rotate arm more forward until it clicks. (The second position) Choose the arm position [...]

■ ADJUSTING IDLE SPEED • The idling speed is set for 2200 rpm at the factory. If it is necessary to adjust the idle speed, use the adjustment screw on the top side of carburetor. (1) Idling Adjustment Screw ■ STOPPING ENGINE 1. Move the throttle lever to the idling position and run the engine for a half minute. 2. Shift the ignition switch to[...]

US-13 EBZ5100Q U S Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. 9. Maintenance F13 F14 (1) (2) (3) (5) (4) F15 Make sure that the engine has stopped and is cool before performing any service to the blower. Contact with rotating blower fan o[...]

US-14 EBZ5100Q held by three bolts (F18 (2)). (Fastening Torque : 8 to 12 N·m) • Also make sure that the speak arrester and the diffuser are properly attached with four bolts (F18 (1)). (Fastening Torque : 2 to 3 N·m) • Even if one of seven bolts is loose, it may result in engine catching on fire. (1) Bolt (2) Bolt (3) Spark arrester (4) Diff[...]

US-15 EBZ5100Q U S 9. Maintenance ■ IGNITION COIL AIR GAP INSPECTION • If the gap is out of standard or when installing the coil or rotor, adjust the air gap between the ignition coil and the iron core of the rotor. Air Gap: 0.40mm (0.35 ~ 0.45mm) 0.016" (0.014 ~ 0.017") (1) Rotor (2) Ignition coil ■ SHOULDER STRAP • If the should[...]

US-16 EBZ5100Q BEFORE STORING THE BLOWER: 1. Drain a fuel tank and push the primer bulb until it becomes empty of fuel. 2 .Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider. Crank the engine several time and install the spark plug. 3. Store unit in a dry, dust free place, out of the reach of children. 10. Storage 1 1. Dispos[...]

US-17 EBZ5100Q U S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and later small off-road engine. In U.S. and Canada, new equipment that use small off-road engines must be designed, built, and equip[...]

US-18 EBZ5100Q warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. A statement in such written instructions to the effect of "repair or replace as necessary" will not reduce the period of warranty [...]