Regency U41-NG3 manual

WARNING: If the information in these instructions are not followed exactly , a fire or explosion may result causing property damage , personal injury or loss of life. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors an d liquids in the vicinity of this or any other appliance. Installation and service must be performed by a qua[...]

2 Regency U41-3 ULTIMATE Gas Fireplace Insert Note: Oversize faceplate 44-1/4" x 31-1/8" Extra Oversize Faceplate 50-1/4" x 35-1/8" TO THE NEW OWNER Congratulations! You are the owner of a state-of-the-art Gas Insert by FIREPLACE PRODUCTS INTERNATIONAL LTD. The Regency ULTIMATE Gas Fireplace Series of hand crafted appliances has[...]

3 Regency U41-3 ULTIMATE Gas Fireplace Insert T ABLE OF CONTENTS REGENCY UL TIMA TE GAS FIREPLACE INSERT SAFETY LABEL Safety Labels ............................................ 4 INSTALLATION REQUIREMENTS For your safety ................................................ 5 Gas Pipe Testing ............................................. 5 Specification[...]

4 Regency U41-3 ULTIMATE Gas Fireplace Insert This is a copy of the label that accompanies each Regency ULTIMATE Gas Insert. We have printed a copy of the contents here for your review. The safety label is located on the right side door panel. NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a differenc[...]

5 Regency U41-3 ULTIMATE Gas Fireplace Insert Fireplace Trim Kit, Part # 610-940, is available. If the factory built fireplace height is too low for your Insert, you may remove the smoke shelf, baffle plate, and damper plate from the factory built fireplace if removable without cutting or torching, as long as these items are saved and are re-instal[...]

6 Regency U41-3 ULTIMATE Gas Fireplace Insert cord is hooked up to the fan switch and blower. Plug 3 wire cord into a suitable receptacle. Do not cut the ground terminal off under any circumstances. When connected with 120 volts, the appliance must be electrically grounded in accordance with local codes, with a current version of CSA C22.1 (in Cana[...]

7 Regency U41-3 ULTIMATE Gas Fireplace Insert Burner Inlet Orifice Sizes: Natural Gas Burner #3 3 Max. Input Rating - Natural Gas 34,000 btu/h Min. Input Rating - Natural Gas 18,000 btu/h Output Capacity with blower Off Natural Gas 24,786 Max. Output Capacity with blower On Natural Gas 26,146 System Data For 0 to 2000 feet altitude Burner Inlet Ori[...]

8 Regency U41-3 ULTIMATE Gas Fireplace Insert DRAFT HOOD CONNECTION 1) Attach the vent to the flue collar on the detachable draft hood. The flue collar of the appliance will fit inside a standard vent and may be fastened directly to the vent by sheet metal screw or a B-Vent, single wall vent connector. 2) Before pushing the appliance into position [...]

9 Regency U41-3 ULTIMATE Gas Fireplace Insert INST ALLA TION 9 for spillage test.) Before installing vent system ensure that the damper plate is locked into the open position and secure to prevent the damper plate from falling down and crushing the liner. GAS PRESSURE TEST The unit is preset to give the correct gas input at the specified manifold p[...]

10 Regency U41-3 ULTIMATE Gas Fireplace Insert INST ALLA TION 3) Using the trim clips provided, join the left side gold trim (the one with the ON/OFF switch and variable speed FAN switch) to the top gold trim. See diagram 2. Repeat this step for right side. 8 ) Fan Switch wires : Connect the plug end from the fan switches to the matching plug from [...]

11 Regency U41-3 ULTIMATE Gas Fireplace Insert DOOR INST ALLA TION (Packaged Sep arately) 1) Open the two side doors. 2) Slide the door onto the two hinge pins making sure the two pieces are flush to- gether. See diagram 1. Diagram 1 Diagram 3 Diagram 2 Diagram 4 Diagram 2 Diagram 1 Diagram 3 LOG INST ALLA TION Note: D o not force logs down. INST A[...]

12 Regency U41-3 ULTIMATE Gas Fireplace Insert 14 GA. 16 GA. 18 GA. 20 GA. 22 GA. 50 Ft. 32 Ft. 20 Ft. 12 Ft. 9 Ft. Recommended Maximum Lead Length (Two-Wire) When Using Wall Thermostat (CP-2 System) Wire Size Max. Length INST ALLA TION Thermostat Wire Table OPTIONAL W ALL THERMOST A T A wall thermostat may be installed if desired. Connect the wire[...]

13 Regency U41-3 ULTIMATE Gas Fireplace Insert WIRING DIAGRAM CAUTION: Label all wires prior to disconnection when servicing con- trols. Wiring errors can cause im- proper and dangerous operation. WARNING: Electrical Grounding Instructions This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and [...]

14 Regency U41-3 ULTIMATE Gas Fireplace Insert OPERA TING INSTRUCTIONS OPERA TING INSTRUCTIONS Before operating this appliance, proceed through the following check list. 1) Read and understand these Instructions before operating this appliance. 2) Check to see that all wiring is correct and enclosed to prevent possible shock. 3) Check to ensure the[...]

15 Regency U41-3 ULTIMATE Gas Fireplace Insert COPY OF THE LIGHTING PLA TE INSTRUCTIONS LIGHTING INSTRUCTIONS 2 ) Wait five (5) minutes to clear out any gas. If you then smell gas STOP! follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step. 3 ) Turn knob on gas control counterclockwise to “PIL[...]

16 Regency U41-3 ULTIMATE Gas Fireplace Insert MAINTENANCE NORMAL OPERA TING SOUNDS OF GAS APPLIANCES It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance. Listed below are some examples. All are normal operating so[...]

17 Regency U41-3 ULTIMATE Gas Fireplace Insert Installing Glass 1) Install both center and side glass onto extrusions as per diagram. 2) Place glass assembly into door frame. 3) Install retainers by placing 1 drop of glue where previously glued and put in place. 4) Install side retainers. 5) Install door catch plate. 6) Install the 24 nuts loosely,[...]

18 Regency U41-3 ULTIMATE Gas Fireplace Insert MAINTENANCE CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. IMPORTANT Disconnect power supply before servicing WARNING: Electrical Grounding Instructions This appliance is equipped with a three pronged (grounding) plug f[...]

19 Regency U41-3 ULTIMATE Gas Fireplace Insert P ARTS LIST MAIN ASSEMBL Y Part # Description Part # Description 27) 910-142 Thermodisc - Fan Auto/On/Off 28 ) * Thermodisc Bracket 30) 610-175 Rear Panel 31) 591-187 Firebox Baffle Plate 908-727 Manual *Not available as a replacement part. 1 ) 611-525 B ottom Louver Assy 2 ) 653-535/02 Top Louver Assy[...]

20 Regency U41-3 ULTIMATE Gas Fireplace Insert P ARTS LIST BURNER & LOGS Part # Description 52) 910-190 Piezo Ignitor and nut 56) 910-426 Knob - Flame Hi/Low Extension 613-524/P Valve Assembly -NG 613-526/P Valve Assembly - LP 60) 910-028 Valve - RS - NG 910-029 Valve - RS - LP 904-688 Orifice - #32 NG 904-641 Orifice - #50 LP 71 ) * Log Stand [...]

21 Regency U41-3 ULTIMATE Gas Fireplace Insert FACEPLA TE & TRIM Part # Description Part # Description 103) * Faceplate - Extra Oversize - Side Left Assy 613-538 Trim Pkg. - Extra Oversize -Black 104) * Trim - Extra Oversize - Right 105) * Tr im - Ex tr a O ve rs iz e - T op 106) * Trim - Extra Oversize - Left 663-911 Zero Clearance Faceplate 6[...]

22 Regency U41-3 ULTIMATE Gas Fireplace Insert NOTES _____________________________________________________________________________________ ____________________________________________________________ __________________________________________________________ ____________________________________________________________ ______________________________[...]

23 Regency U41-3 ULTIMATE Gas Fireplace Insert W ARRANTY Regency Fireplace Products, are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our door. Regency Industries Ltd. is pleased to extend this limited lifetime warranty to the original pur[...]

Installer: Please complete the following information Dealer Name & Address: ______________________________________________ __________________________________________________________________ Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: [...]