Smeg SRA20NE2 manual

21 INSTRUCTIONS FOR USE BEFORE USING THE APPLIANCE SAFEGU ARDING THE ENVIRONMENT PRECA UTIONS AND GENERAL RECOMMEND A TIONS IF THE APPLIANCE IS NOT GOING TO BE USED MAINTENANCE AND CLEANING STORING, FREEZING AND THA WING FOOD DESCRIPTION OF THE APPLIANCE “MUL TIFL OW ” AIR DISTRIBUTION GUIDE TO THE INSIDE P ARTS USING THE APPLIANCE USING THE IC[...]

22 Y our new appliance is designed exclusively for domestic use. After unpacking the appliance, make sure it is not damaged and that the door closes properly . Any damage must be reported to the dealer within 24 hours of delivery of the appliance. W ait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is [...]

23 INST ALLA TION • The appliance must be handled and installed by two or more persons. • Be careful not to damage the floors (e.g. parquet) when moving the appliance. • During installation, make sure the appliance does not damage the power cable. • Make sure the appliance is not near a heat source. • T o guarantee adequate ventilation, l[...]

24 In case of power failures of up to 24 hours Keep the doors of the appliance closed. In this way the stored food will stay cold as long as possible. For further information see chapter “Using the appliance”, section “Black-out alarm”. If the appliance is not going to be used - Disconnect the appliance from the power supply . - Remove all [...]

25 INTRODUCTION W rap food so that no water , moisture or condensate can enter; this will prevent odours or aromas going from one part to another in the refrigerator , ensuring better preservation of frozen foods. Use plastic containers with hermetic lids, aluminium trays, aluminium foil, plastic film and waterproof plastic wraps. NOTE: Never place[...]

26 REFRIGERA TOR COMP ARTMENT A. Inside light B. Inside light C. Adjustable shelf D. Shelf - drawer lid E. Crisper F . Crisper adjustment G. Meat / vegetable drawer H. Meat / vegetable drawer adjustment I. Dairy products compartment J. Door trays K. 2-litre door tray with bottle holder L. 0.75 litre door tray M. W ater filter N. “Multiflow ” (d[...]

Removing and repositioning the refrigerator compartment and freezer shelves The shelves can be positioned as required. The glass shelves are strong enough to hold bottles, milk cartons and heavy food, however , take care not to bang products on the shelves. T o remove the shelves: pull the shelf out as far as it goes, then lift and remove it. Remov[...]

28 FIRST USE Connect the appliance to the water system and power supply (refer to the Installation manual). When connecting the appliance to the power supply , the display will show the temperatures preset by the manufacturer . Note: Reaching the preset temperatures requires a variable amount of time. This time depends on several factors (times the[...]

GUIDE TO SELECTING FUNCTIONS Menu This button is used to select the different options shown in the control panel. Each time the button is pressed, a different option is highlighted. OK The OK button is used to confirm the selected function and to deactivate the acoustic signal. Stand-by This function turns off the refrigerator and freezer compartme[...]

W ater filter This symbol indicates the state of the water filter . When switching on the appliance for first use, or after replacing the filter , the filter icon shows three dashes. In time their number will decrease, depending on the use of the appliance and the natural wear of the filter charge itself . When all the dashes disappear and the icon[...]

OPTIONAL FUNCTIONS P arty mode This function is activated by pressing the menu button until the party mode symbol appears. With the symbol flashing, press OK to confirm your selection. This function enables to use the freezer compartment to cool drinks. When the function is selected, the icon is animated. 30 minutes after activation (the time neede[...]

32 First use When the ice and water dispenser is used for the first time, the first ice cubes and water coming out of the dispenser may have an unpleasant taste and should therefore be discarded. Ice maker The function is activated when the symbol is lit. Press the ice maker button to select the symbol corresponding to the type of ice required (cub[...]

33 After switching on the refrigerator , it usually takes overnight for the first ice cubes to form. When selecting crushed ice, the cubes are crushed just before being dispensed, therefore the crushed ice may come out with a slight delay . Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to i[...]

34 1. Locate the water filter cartridge cap below the freezer compartment door . Rotate the cap counterclockwise to a vertical position and pull the cap and filter cartridge out through the base grille. Note: Since there is water in the cartridge, some spilling may occur . 2. Remove the cartridge cap by sliding it off the end of the old cartridge. [...]

35 Before contacting the After-sales Service... Operation problems are often due to minor causes that can be found and fixed without using any tools. Noises from the appliance are normal, since the fans and compressors for controlling its operation switch on and off automatically . Some noises can be reduced by: • levelling the appliance and inst[...]

36 The appliance does not work: • Is the power cable plugged into a socket powered with the right voltage? • Have you checked the protection devices and fuses of your home’s electrical system? The motor seems to run too much: • Is the condenser free of dust and fluff? • Are the doors properly closed? • Are the door seals intact? • On [...]

37 If the automatic ice-maker does not work: • Has the freezer had enough time to become cold? With a new appliance this may take overnight. • Is the automatic ice-maker ON/OFF button set to ON? • Is water reaching the automatic ice-maker? Is the water cock open? The filter may be clogged or not correctly installed. Firstly , check the filter[...]

38 W arning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T .A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover ( A ) and fuse ( B ). 2. Fit replacement 13A fuse into fuse cover . 3. Ref[...]

3 INST ALLA TION BEFORE INST ALLING THE REFRIGERA TOR W A TER CONNECTION ELECTRICAL CONNECTION LEVELLING Y OUR REFRIGERA TOR INST ALLING CUSTOM DOOR P ANELS INST ALLA TION DIMENSIONS AND REQUIREMENTS REMO VING THE FREEZER DOOR (A) REMO VING THE REFRIGERA TOR DOOR (B) MOUNTING THE FREEZER DOOR (C) MOUNTING THE REFRIGERA TOR DOOR (D) HORIZONT AL ALIG[...]

4 Disconnect the appliance from the mains power supply before starting operations. • The ice maker and water circuit must be connected to a water supply of potable and/or chemically purified water . • The water connection must be carried out in compliance with local regulations. • The appliance is supplied with a water tube, 2.330 m long, alr[...]

5 The refrigerator has two front and two rear wheels at the base of the product on each side that can be adjusted (see figure A), or four wheels of which only the two front wheels can be adjusted (see figure B). If the appliance seems unsteady or you want the doors to close easier , adjust the appliance's tilt following the instructions below [...]

6 • Installing custom door panels If you wish to install custom door panels, have the panels made according to dimension drawings. • Flat panels Flat panels may be fitted in the frames (max thickness of panels: 6.35 mm). Flat panels less than 6.35 mm thick are not recommended. • Raised panels A raised panel design can be created by screwing o[...]

7[...]

8[...]

9[...]

10[...]