Toshiba SD-R1002 manual

TOSHIBA AMERICA INFORMA TION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-R1002 CD-R W/D VD-R OM COMBO DRIVE USER MANU AL[...]

CONTENTS Introductio n .............................................................................. 1 Setup ........................................................................................ 3 Using the Com bo Drive ........................................................... 6 T roub leshoo ting .............................................[...]

1 INTR ODUCTION – SD-R1002 General Features CD-RW disc write/rewrite at 1X, 2X and 4X 3-way Disc Eject (ej ect button, software, emergency eject hole ) Average Random Access Time CD 110ms DVD-ROM 160ms Horizontal or Vertical Mount 2MB Buffer Playback interchangeability for CD-RO M and DVD-ROM discs Regionalization (RPC2 co mpliance) (DVD) BUS Int[...]

Front Panel Figure 1.SD-R1002 DVD Write able Drive Front Panel Loading Tray Load disc using tray. LEDs The LED lights green or am ber when the dr iv e is operating (LED is amber when drive is writing.) Load/Unload Button The Load/Unload button is used to o pen the disc tra y so you can install or remov e a disc. Emergency Eject Hole The emergency e[...]

3 SETUP – SD-R1002 The following steps must be performe d to properly install your drive: • Set Drive J umper Settings • Connect Audio Cable • Attach IDE BUS Cable • Attach P ow er Cable • Mount Drive Jumper Settings The mode select jumpers are 6 straight angle pi n s located on the rear of the Combo drive. By placing a jumper on the pi[...]

4 Placing Combo Drive inside your Computer Now that you have set the jumpers, you are read y to install your Combo drive inside your computer. Important Note: Disconnect power fr om your co mputer system before b eginning installation. Remove computer co ver and faceplate if required. Re fer to your co mputer systems manual for removal information.[...]

5 Audio Cable (optional) - If you have a sound card and speakers, and would like t o play audio CDs on your computer, you will need to install a CD/DVD audio ca ble. Toshiba's Combo drives use a sta ndard 4-pin audio cable that can be purchased from mo st local computer suppliers. The sound cabl e connects to your sound card at one end and the[...]

6 USING THE D VD Combo Drive – SD-R1002 Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is moun ted horizont ally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's L oading tra y b y pressing the Eject Button. 2. Place disc or into driv e's Loading tra y 3. Press Eject b utton a[...]

7 Figure 2.Inserting Disc Vertically Removing a Disc To remove a disc from the Combo drive, perform the following steps: 1. Open the Loading T r a y by pressing the Eject Button. 2. Slide disc holders a wa y from disc. 3. Grasp disc by edges , and lift out of loading tra y . 4. Press Eject Button again to close Loading T ray . Software When you pur[...]

8 Emergency Ejection CAUTION: The following procedure is intended on ly as a last resort when pressing the eject button fails to open the Loading Tray 1. T ur n computer powe r OFF by properly shutting down system. 2. Inser t a solid bar (i.e. large paper clip) into Emergency Eject hol e and push in until loading t ra y opens. Pull tray out. Figure[...]

9 TR OUBLESHOO TING – SD-R1002 Problem Solution Disc tra y cannot be opened • Chec k that there is power to drive . • Use Emergency Eject instructi ons to open tray . Drive is not recognized by system • Is the drive connected proper ly? Are all cables plugged in proper ly (e.g. P ower Cable , Interface Cab le and Audio Cables). • Are the [...]

10 SPECIFICA TIONS – SD-R1002 General Interface: ATAPI Applicable Formats - Write: Formats for Writing Disc at once, Track at once , session at once, Packet Write, in cremental write, restri cted overwrite Applicable Wr ite Disc – CD-D A, CD+(E)G, CD-MIDI, CD-ROM, CD-ROM XA, CD-I, MIXED MODE CD-R/-R W CD , CD-I Bridge (Photo-CD , Video-CD), Mul[...]

11 T ransf er Rate D VD-ROM 6,536 – 12,704KB/second CD-ROM 1,552 – 3,600KB/second (mode 1) 1,770 – 4,106KB/second (mode 2) Random Access Time DVD CD 160ms 11 0 m s Data Error Rate DV D - R O M 1 0 -15 Max CD-R OM 10 -15 Max (Mode 1) 10 -12 Max (Mode 2) Data Buff er 2MB Reliability MTBF 100,000 hours P ower ON Hours 5,436 hours/y ear ON/OFF Cy[...]

12 Power DC V oltage and Current Requirements 5V , 12V ±5% Physical Height 5.75" (146mm) Width 1.63" (41.5mm) Depth 7.60" (193mm) W eight 2.16lbs (0.98kg) Connectors DC input 4-pin P ower Suppl y Connector A T API Interf ace Connector 40 Pin I/F A T API Standard A udio Connectors 4-pin and 2-pin connector (use matching housing, P ar[...]

13 DRIVE CONNECT ORS – SD-R1002 Figure 1.SD-R1002 Combo Drive Rear Panel - Connectors Power Connector Power is supplied to your CD-RW/ DVD drive by the connection with you r computer's +5V/+12V power cable to the powe r socket at the back of drive. One side of the plug ha s chamfered edges, so the p ower connector fits only on e way CAUTION:[...]

14 Table 1.Interface Pin Assignments INTERFACE PIN ASSIGNMENT PIN NO . I/O SIGNAL NAME HOST SIGNAL NAME PIN NO . I/O SIGNAL NAME HOST SIGNAL NAME 1 I Reset Host Reset 21 O HDRQ DMA Request 2 - GND 22 - GND 3 I/O HD7 Host Data Bus BIT 7 23 I HWR-,STOP Host I/O Write 4 I/O HD8 Host Data Bus BIT 8 24 - GND 5 I/O HD6 Host Data Bus BIT 6 25 I HRD-, HDMA[...]