Toshiba SG-1701 manual

OWNER , S MANUAL SG - 17 0 1 The FIRST thing to do after unpacking your new cordless telephone is: CHARGE THE BATTERY ! Please read and follow the few instructions on PAGE 6 BEFORE YOU DO ANYTHING ELSE. 2.4GHz DIGITAL SPREAD SPECTRUM CORDLESS TELEPHONE[...]

1 IMPORT ANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wa[...]

2 13. Do not use the telephone in the vicinity of a gas leak. CAUTION: TO REDUCE THE RISK OF FIRE OR INJUR Y TO PERSONS BY THE BA TTERY , READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the appropriate type and size battery pack specified in the instruction manual provided for this product. 2. Do not dispose of the battery pack in a fire. The cell [...]

3 SER VICE REQUIREMENTS If the cordless telephone should malfunction, or need changes or modifications, all repairs will be performed by an authorized T oshiba Service Station. This unit has been registered with the FCC for direct connection to the telephone network. Under the FCC program, no customer is authorized to repair this unit. This applies[...]

4 INTRODUCTION T oshiba America Consumer Products, Inc. takes pride in presenting the telephone, one of the finest digital spread spectrum cordless telephones available. Intelligent design, superb craftsmanship, and the latest technological advances have been combined to provide you with a telephone that is easy to operate and will provide you with[...]

5 INST ALLA TION 1. SETTING UP THE BASE UNIT For use on a desk or counter top follow the instructions below . DESKTOP MOUNTING: Snap the bracket's tab into the notches on the base. • USE ONL Y WITH Supplied AC ADAPT OR (T AC-2981; power source AC 120V , 60Hz/DC 9V). • The AC adaptor must remain connected at all times. (It is normal for the[...]

6 Red Black 2. CHARGE THE BA TTER Y P ACK Note Use only the supplied battery pack (TRB-1981; power source 800 mAh, 3.6V). q Remove the battery compartment cover on the back of the handset by sliding it down. w Plug the battery pack cord into the connector in the battery compartment in correct polarity . It fits in only one way . e Place the battery[...]

7 After the battery pack is fully charged; Operation Approx. battery life While in use (T alk mode) up to 6 hours While not in use (Standby mode) up to 10 days When T ALK/BA TT LOW LED blinks, all handset buttons are disabled and the battery needs to be charged. If this occurs during a call, you hear short beeps. Finish the call as soon as possible[...]

8 Wall mount template IMPORTANT: Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone. Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard. CUT CUT • • • Route the cords [...]

9 LOCA TIONS OF CONTROLS HANDSET CONTROLS BASE UNIT CONTROLS T -P (T one-Pulse) Switch Antenna Charging Contacts REDIAL button DC IN 9V jack LINE Modular jack Antenna PAGE button Charging Contacts IN USE/CHARGE LED Speed Dial Index Card (back) Write down numbers stored in memory . Rechargeable Battery Pack (back) TALK button TONE button FLASH butto[...]

10 Please see “LOCA TIONS OF CONTROLS” for the location of each button used for the following operations. TONE/PULSE SETTING Set the TONE/PULSE switch on the back of the base unit to TONE and make a trial call. If the call does not connect, set the T ONE/PULSE to PULSE. MAKING A CALL 1. MAKING A CALL q Press TALK . w Listen for the dialtone. e [...]

11 3. INTERFERENCE OR ST A TIC If you hear noise during a call, press CHANNEL to select another channel. The T ALK/BA TT LOW LED blinks during changing a channel. 4. CHANGING THE RINGER VOLUME Press / to select one of four ringer tone and volume combinations during standby mode. Each time you press / , the setting will change. 5. CHANGING THE HANDS[...]

12 8. SENDING T ONE SIGNAL (for Pulse service user) Even if you have Pulse service (the T one-Pulse switch is set to Pulse), you can use this phone with banking and other phone services requiring touch tone signals. q Dial the service number and wait for the connection. w Press TONE , then enter the numbers required. Y ou will hear the tones on the[...]

13 USING A HEADSET (option) For purchase of an optional accessory , please call 1-877-644-7373. Y ou can talk with hands-free convenience using an optional headset (part #. RC008260) that has a 3/32-inch(2.5mm) plug. T o connect the headset, open the rubber cover on the left side of the handset, then insert the headset ’ s plug into the jack. Wit[...]

14 USING A BEL T CLIP (option) Y ou can attach an optional Belt Clip (part #. RC009263) to the handset in order to carry it on your belt. Attaching the Belt Clip to the Handset Insert the Belt Clip tabs into the holes on each side of the handset until they click. Note Be sure to insert the tab properly into each hole to prevent the belt clip from f[...]

15 MEMOR Y DIALING Y ou can store up to 10 telephone numbers in memory . Notes In memory dialing operation, • If more than 20 seconds elapse between pressing buttons, the operation will be canceled and you must start over again. • If you press a wrong button, an error tone sounds and the handset returns to standby mode. • If a call comes in, [...]

16 2. DIALING A ST ORED NUMBER q Pick up the handset and press TALK . The T ALK/BA TT LOW LED lights. w Press MEM . e Enter the memory address (0 to 9). The stored number will be dialed. Note If you enter a memory address which does not have any stored number , error beeps sound. 3. ERASING A ST ORED TELEPHONE NUMBER q Pick up the handset. (Do not [...]

17 ACCESSORIES SUPPLIED ACCESSORIES Rechargeable Battery pack (1) TRB-1981 Part #. RC009814 AC Adaptor (1) T AC-2981 Part #. RC009792 T elephone Cord (1) Part #. RC008231 Owner ’ s Manual (1) Part #. RC009815 Speed Dial Index (1) Part #. RC009264 Bracket (1) Part #. RC009262 OPTIONAL ACCESSORIES Headset (1) Part #. RC008260 Belt Clip (1) Part #. [...]

18 PROBLEM T ALK/BA TT LOW LED blinks. The handset does not ring or receive a page. CHARGE LED does not light when the handset is placed on the base. Noise or interference. The unit does not operate properly . When the handset is returned to the base unit with the volume level set at Max, a momentary squeal or howling sound may sometimes be heard. [...]

UCZZ01737BZ RC009815 Printed in China © 2001 TOSHIBA AMERICA CONSUMER PRODUCTS. INC. (3) Within the continental U.S.A., if you should find a defective product within the warranty period please call 1- 877-644-7373. (4) W arranties extend only to defects in materials or workmanship as limited above and do not extend to any product or parts which ha[...]