Tyco Electronics 1938L manual

T ouchmonitor User Guide 1938L 19” LCD Open-Frame Touchmonitor[...]

User Guide 19 " LCD OPEN-FRAME TOUCHMONITOR 1938L Fa mily 3000 Serie s Revision A P/N E48151 1[...]

Copyright © 2008 T yco Electronics. All Rights Reserved. No part of this publication may be reproduced, tra nsmitted, tra nscribed, stored in a retrieval system, or tra nslated into a ny la nguage or computer la nguage, in a ny form or by a ny mea ns, including, but not li mited to, electronic, magnetic, optical, chemical, ma nual, or otherwise wi[...]

T able of Contents Chapter 1 Introduction 7 Product Description 7 Precautions ................................................................ 7 About the Product ...................................................... 8 Chapter 2 Installation and Setup 9 Unpacking Your Touchmonitor ................................... 9 Touch Interface Connection ..[...]

C H A P T E R 1 I NTRODUCTION Product De scription Y our new touchmonitor combines the reli a ble performa nce of touch technology with the latest a dva nce s in (LCD) display design. This combination of f eatures creates a natural flow of information between a user a nd your touchmonitor . This LCD monitor incorporate s a 19” color a ctive matri[...]

About the Product Y our LCD open-fra me touchmonitor is a 19” W XGA TFT color display with the f ollowing features: • The internal microprocessor digitally controls auto-sca nning for horizontal sca n frequencies between 31.5 KHz a nd 80 KHz, a nd vertical sca n frequencies between 56.3 Hz a nd 75.0 Hz. In ea ch frequency mode, the microprocess[...]

C H A P T E R 2 I NST ALLA TION AND S ETUP This cha pter discusses how to install your LCD touchmonitor a nd the driver software. U n pa cking Y our T ouchmonitor Check that the following 9 ite ms are present a nd in good condition: LCD touchmonitor V ideo cable USB ca ble Serial ca ble D VI-D Cable T ouch T ools CD + Quick Install Guide Strain Rel[...]

T ouch Interfa ce Conne ction Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and touchmonitor are turned off. 1. Connect one end of the power a d a pter to the monitor a nd the other end to the connector of the power cord. 2. Connect one end of e ither the touchscr een seri al (RS232) ca bl e or the touchs[...]

Product Overview Front View Re ar View 2-1 1[...]

In stalling the Driver Software Elo T ouchSystems provide s driver software that allows your touchmonitor to work with your computer . Drivers are located on the enclosed CD-ROM for the f ollowing operating syste ms: • W indows XP • W indows 2000 • W indows Me • W indows 98 • W indows 95 • W indows NT 4.0 The latest versions of drivers [...]

In stalling the Serial T ouch Driver In stalling the Serial T ouch Driver for Windows XP , Windows 2000, Me, 95/98 a nd NT 4.0 NOTE: For Windows 2000 and NT 4.0 you must have administrator access rights to install the driver. T o install W indows 2000 a nd W indows XP , you must use the "update driver" method; you will not find a setup.ex[...]

In stalling the Serial T ouch Driver f or MS-DOS a nd Windows 3.1 Y ou must have a DOS mouse driver (MOUSE.COM) installed f or your mouse if you wish to continue using your mouse along with your touchmonitor in DOS. T o install W indows 3.x a nd MS-DOS from W indows 95/98, follow the directions below: 1 . Insert the CD-ROM in your computer’s CD-R[...]

In stalling the USB T ouch Driver Installing the USB Touch Driver for Windows XP, Windows 2000, Me, 95/98 and NT 4.0 T o install W indows 2000 a nd W indows XP , you must use the "update driver" method; you will not find a setup.exe file within the downloa d. NOTE: For Windows 2000 you must have administrator access rights to install the [...]

In stalling APR USB T ouch Driver f or W indows XP Insert the Elo APR CD-ROM in your computer’s CD-ROM driver . Follow the directions on the screen to complete the APR 2.0 driver setup for your version of W indows. 1. Click Start > Run. 2. Click the Browse button to locate the SW6001 17.exe progra m on the CD-ROM. 3. Click Open , then OK to ru[...]

C H A P T E R 3 O PERA TION About T ouchmonitor Adjustments Y our touchmonitor will not likely require a djustment. However , vari ations in video output a nd a pplication may require a djustments to your touchmonitor to optimize the quality of the display . For best perf orma nce, your touchmonitor should be operating in native re solution, 1440 x[...]

Re ar Pa nel Controls Control Function 1. Menu/Exit Display/exits the On Screen Display (OSD) menus. 2. 1. Enter contra st of the OSD. 2. Increa se value of the a djustment ite m. 3. Select item counter-clockwise. 3. 1. Enter brightness a djustment. 2. Decrea se value of the a djustment item. 3. Select item clockwise. 4. Select Selects the a djustm[...]

Controls a nd Adjustment On Screen Display (OSD) Menu Functions T o Display a nd Select the OSD Functions: 1 . Pre ss the Menu key to activate the OSD menu. 2 . Use or to move through the menu. Press the Select key , the para meter will be highlighted when selected. 3 . T o quit the OSD screen at a ny time during the operation, press the Menu key .[...]

On Screen Display (OSD) Control Option s Control Descri ption Contra st Increases or decrea ses contra st. Brightness Increa ses or decrea se s brightness. V -Position Moves the screen up or down. H-Position Moves the screen left or right. Recall Defaults Returns the monitor to its default settings. RG B Press or to select 9300, 6500, 5500, 7500 a [...]

Pre set Mode s T o reduce the need f or a djustment for dif f erent mode s, the monitor has default setting mode s that are most commonly used a s given in the ta ble below . If a ny of these display modes are detected, the monitor automatically a djusts the picture size a nd centering. When no mode is matched, the user ca n store their pref erred [...]

Power M a n age ment Syste m The monitor is equi pped with the power ma nagement function which automatically reduce s the power consumption when not in use. Power Mode Consumption O n <45W Sleep < 4 W Off <2 W W e recommend utilizing a screensaver when the touchmonitor is not in use. NOTE: The monitor automatically goes through the Power [...]

C H A P T E R 4 T ROUBLESHOOTING If you are experiencing trouble with your touchmonitor , refer to the f ollowing ta ble. If the proble m persists, plea se conta ct your local dealer or our service center . Solution s to Common Proble ms Problem Suggestion(s) The monitor does not respond • Check that the monitor’s Power Switch is on. after you [...]

A-24 User Guide A P P E N D I X A N A TIVE R ESOLUTION The native re solution of a monitor is the resolution level at which the LCD pa nel is designed to perform best. For the 1938L LCD touchmonitor, the native resolution is 1440 x 900. In almost all ca ses, screen i mages look best when viewed at their native resolution. Input V ideo 19" LCD [...]

As a n example, a W XGA+ resolution LCD pa nel ha s 1440 pixels horizontally by 900 pixels vertically . Input video is also repre sented by the sa me terms. W XGA input video ha s a f ormat of 1440 pixels horizontally by 900 pixels vertically. When the input pixels contained in the video input format match the native resolution of the pa nel, there[...]

B-26 User Guide A P P E N D I X B T OUCHMONITOR S AFETY This ma nual contains inf ormation that is i mporta nt for the proper setup a nd maintena nce of your touchmonitor . Bef ore setting up a nd powering on your new touchmonitor, rea d through this ma nual, especi ally Cha pter 2 (Installation), a nd Chapter 3 (Operation). 1 T o reduce the risk o[...]

Care a nd Ha ndling of Y our T ouchmonitor The following ti ps will help keep your touchmonitor functioning at the opti mal level. • T o avoid risk of electric shock, do not disasse mble the brick supply or display unit ca binet. The unit is not user servicea ble. Re me mber to unplug the display unit from the power outlet bef ore clea ning. • [...]

C-28 User Guide A P P E N D I X C T ECHNICAL S PECIFICA TIONS[...]

T ouchmonitor Specification s Model 1938L LCD Display 19” T F T Active Matrix Pa nel Display Size 408(H) x 255(V) mm Pixel Pitch 0.284(H) x 0.284(V) mm Display Mode V GA 640 x 350 (70Hz) V GA 720 x 400 (70Hz) V GA 640 x 480 (60 / 66 / 72Hz) SGA 800 x 600 (56 / 60 / 72Hz) XGA 1024 x 768 (60 / 65 / 72Hz) SXGA 1280 x 1024 (60 / 75Hz) 1440 x 900 (60H[...]

C-30 User Guide IntelliT ouch T ouchscreen Specif ication s Positional Accura cy Sta ndard devi ation of error is less tha n 0.080 in. (2.03 mm). Equates to le ss tha n ±1%. T ouchpoint Density More tha n 100,000 touchpoints/in2 (15,500 touchpoints/cm2). T ouch Activation Force T ypically le ss tha n 3 ounces (85 gra ms). Surfa ce Durability Surfa[...]

Surfa ce Ca pa citive T ouchscreen Spe cification s Input method Finger Gla ss Thickness 0.1 18" / 3.0 mm nominal. (Glass only , not including tape, wires a nd/or solder if used) Positional Accura cy Reported touch coordinates are within 1.5% of true position (ba sed on viewing area di mensions) Resolution T ouchpoint density is ba sed on cont[...]

C-32 User Guide SecureT ouch T ouchscreen Specif ication s Input Method Finger or gloved ha nd (cloth, leather , or rubber) a ctivation Positional Accura cy Sta ndard devi ation of error is less tha n 0.080 in. (2 mm) Resolution T ouchpoint density is ba sed on controller re solution of 4096 x 4096, plus 255 levels corresponding to touch pressure T[...]

Acoustic Pulse Recognition Specification Input method Finger , finger nail, gloved ha nd, or stylus a ctivation Position a ccura cy 1% max. error Resolution a ccura cy T ouchpoint density is ba sed on controller resolution of 4096 x 4096 T ouch a ctivation for ce T ypically 2 to 3 ounces (55 to 85 gra ms) Controller Board: USB 1.1 Light tra nsmissi[...]

C-34 User Guide 19” LCD T ouchmonitor (ET1938L-XXXA-X-G) Dimensions 444mm 296mm 108mm 47.35mm[...]

R EGULA TOR Y I NFORMA TION I. Electrical Safety Information: A) Compli a nce is required with respect to the voltage, frequency , a nd current requirements indicated on the ma nufacturer’s la bel. Connection to a diff erent power source tha n those specified here in will likely result in i mproper operation, da mage to the equi pment or pose a f[...]

36 User Guide This Information T echnology Equipment (ITE) is required to have a CE M ark on the ma nufacturer’s la bel which mea ns that the equipment ha s been tested to the following Directives a nd Sta ndards: This equi pment ha s been tested to the requirements f or the CE Mark a s required by EMC Directive 89/336/EEC indicated in Europea n [...]

This cla ss B digital a pparatus meets all require ments of the Ca na di a n Interf erence-Causing Equi p- ment Regulations. Cet a ppareil numérique de la cla sse B respecte toutes les exigences du Règle ment sur le matériel brouilleur du Ca na da. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two cond[...]

W ARRANTY Except a s otherwise stated herein or in a n order a cknowledgment delivered to Buyer , Seller warra nts to Buyer that the Product shall be free of defects in materi als a nd workma nship. The warra nty for the touchmonitors a nd components of the product is regional; plea se contact your regional of fice. Seller makes no warra nty regard[...]

Installing the Serial Touch Driver for MS-DOS and Windows 3.1, 14 Installing the Serial Touch Driver for Windows XP, Windows 2000, Me, 95/98 and NT 4.0, 13 Installing the USB Touch Driver, 15 Installing the USB Touch Driver for Windows XP, Windows 2000, Me, 95/98 and NT 4.0, 15 IntelliTouch Touchscreen Specifications, 30 M Main Unit, 10 Max. Resolu[...]

S SecureTouch Touchscreen Specifications, 32 Signal Connector, 29 Solutions to Common Problems, 22 Storage Conditions, 29 Surface Capacitive Touchscrren Specifications, 31 SVGA, 24 SXGA, 24 T Technical Specifications, 28 Touch Interface Connection, 11 Touch not working, 23 Touch Panel (optional), 29 Touchmonitor Safety, 26 Touchmonitor Specificatio[...]

© 2008 Elo T ouchSystems Inc. Printed in USA Check out Elo’s Web site! www.elotouch.com Get the latest... • Product information • Specifications • News on upcoming events • Press release • Software drivers • Touchmonitor Newsletter Getting in T ouch with Elo To find out more about Elo’s extensive range of touch solutions, visit our[...]