Uniden 2165 manual

DSS 2155/ 2165 Digital Spread Spectrum provides the longest range, the clearest sound and the best privacy . GUIDE QUICK ST AR T[...]

This symbol indicates important operating and servicing instructions. PRECAUTIONS INST ALLA TION & SAFETY Choosing the best location for your DSS2155/DSS2165 When choosing a location for your phone there are a number of appliances the phone should not be near , and areas you should avoid. A VOID - T elevision sets and other electronic appliance[...]

This page is a very condensed version of the Owners Manual. It is designed to allow you to get your phone installed and operating as quickly a s possible - however it does not attempt to explain any of the advanced featur es of the DSS2155/DSS2165 . Start Her e! Quick Start Guide (ii) Raise the antenna. plug the AC Adaptor into AC Adaptor cord AC A[...]

Quick Start Guide Installing the Batteries in the Handset/s Press the battery cover and slide it off. DSS2165 only - Place the handsets on either the Base Unit or the Charge Cradle and charge them uninterrupted for 12 hours. NOTE Connect the battery plug to the socket at the rear of the battery compartment. Make sure the plug is the right way round[...]

redial/P select delete/ page 1 2 3 4 5 7 6 8 9 * 0 # pqrs ghi abc def mno jkl wxy tuv talk cid memory flash/ reg vol 28/09 12:30 01 JIM ST ATEN 02 9599 3355 rocket/ C.wait Setting Up the Answering System T o Turn the Answering System On Press - the pre-recorded greeting will play and your system is ready to accept calls. ans on/off T o Record Y our[...]

ans on/off time/3-way in use/ charge mute T o Delete Messages Delete one message: Press during a message. The system beeps and begins to play the next message. Delete all messages: After reviewing all messages - press and hold more than 4 seconds. A tone sounds indicating messages have been deleted. Quick Start Guide Initial Settings Ring Time - th[...]

CONTENTS OF YOUR OWNERS MANUAL 1 CONTENTS Installation & Safety Quick Start Guide Installing the Base Unit Installing the Handset Batteries Making a Call Setting up the Answering System Using the Answering System Contents Controls & Functions W elcome Features Setting Up your T elephone Accessories Included in Y our Package Installing the B[...]

redial/P select delete/ page 1 2 3 4 5 7 6 8 9 * 0 # pqrs ghi abc def mno jkl wxy tuv talk cid memory flash/ reg vol 28/09 12:30 01 JIM ST ATEN 02 9599 3355 rocket/ C.wait CONTROLS & FUNCTIONS 2 Headset jack Belt clip slot Battery compartment Memory key T alk key Rocket/C.wait key Handset aerial Handset speaker Display screen 1 2 3 4 5 6 7 8 9 [...]

20 21 22 Rear of Base Unit 23 24 20 21 22 23 24 25 26 27 28 29 30 31 32 33 Aerial T elephone Line input AC Adaptor input Registration button Ringer Off/On V oice memo key Message display V olume control keys Delete key Play key T ime/3-way Answer On/Off key Mute Redial/Pause key Page/Int’com key C.wait key Speaker key Hands free microphone Flash [...]

WELCOME Congratulations on your purchase of the Uniden DSS2155/DSS2165 digital cordless telephone. This phone is designed for reliability , long life and outstanding performance utilising the latest in 900 MHz Digital Spread Spectrum T echnology . TO YOUR NEW PHONE INTRODUCTION FEA TURES l l l l l l l l l l l l 900MHz Digital Spread Spectrum T echn[...]

Rechar geable Battery DSS2155 (1) DSS2165 (2) AC Adaptor DSS2155 (1) DSS2165 (2) Belt Clip DSS2155 (1) DSS2165 (2) ACCESSORIES INCLUDED IN YOUR P ACKAGE If any of these items are missing or damaged, contact your place of purchase. To get the most from your phone, please read this Owner ’ s Manual thoroughly . Be sure to complete and mail the prod[...]

When the battery charge becomes low If the phone is not in use, Low Battery flashes and the keys will not operate. If the phone is in use, Low Battery flashes and the Handset beeps. Complete your conversation as quickly as possible and return the Handset to the base unit for charging. Use only the genuine Uniden Battery supplied with your phone. Re[...]

7 USING YOUR PHONE MAKING AND RECEIVING CALLS T o answer a call (phone ringing) Basic phone operation T o make a call When Handset On Base When Handset Off Base button Using the Base T o hang up Return the Handset to the base (Auto Standby) or Press . 0 # tone oper C.wait speaker DIGITAL SPREAD SPECTRUM 900MHz volume voice memo greeting speaker in [...]

During a call, you can transfer the call to another optional handset (maximum 7 handsets). 1. Press . 2. Press [ handset No. ] . The Handset number is shown on the right side of the display . 3. Press 4. Called second Handset rings. 5. Press on the second Handset and Call T ransfer is completed. NOTE CALL TRANSFER If the called handset is not answe[...]

9 Redial from the Base Unit 1. T o call the last number dialed from the Base Unit, press . 2. Press - the last number dialed will be redialed. 3. T o hang up, press . REDIAL 3 95983577 3rd ‘most recent number dialed’ is displayed. Press again 4. Press and the number will be dialed. Redial from talk mode 1. Press . 2. Press - the last number dia[...]

10 STORING PHONE NUMBERS AND NAMES The pause feature is useful for long distance calling, credit card dialing, or sequences that require a pause between digits. With the Handset Memory Dialing allows you to dial a number using just a few key strokes. Y ou can store up to 59 phone numbers in the memory . Since each step must be completed within 10 s[...]

1 1 Memory Dialling from Standby 1. Press once, the handset displays your programmed memory locations. 2. Press and or enter a two-digit number to select the memory location you would like to dial. 3. Press - the displayed number is dialed. MAKING CALLS WITH MEMOR Y DIALLING 01 FRED 02 JOHN SMITH 03 KA Y JONES T ALK LOUD 1 0295993355 Use and to tog[...]

EDITING A STORED NAME AND PHONE NUMBER 1. Press and hold until MEMOR Y ST ORE is displayed. 2. Press and or enter a two-digit number to select the memory location you would like to edit. 3. Press - the screen displays the memory location number you have selected. 4. Press or to select ‘Edit Memory’, then press . 5. Press , , or to edit the name[...]

When the phone is in the standby mode, simply press . The number stored in the Rocket Dial memory location is instantly dialed. 13 P AGING P AGING BASE When an incoming call is received during paging from the Base, paging is cancelled and the telephone is switched to the incoming call. Handset to Handset paging is not cancelled. P AGING/INTERCOM NO[...]

INTERCOM 2 way radio feature (using an optional handset) 2 way communications between the Handsets using the intercom feature, can be achieved without the base anywhere, anytime. 0 [ handset No. ] 7 ( ( 1 14 If additional Handsets have been registered to the base, all Handsets will beep when paged. NOTE 3 W A Y CONVERSA TION Between one Handset, th[...]

Registration Process Follow this process for each additional Handset (DSS2105) that needs to be registered to the Main Base or for registering your Main Handset. 1. Remove the Handset from its charger 2. Press flash/reg on the Handset (Fig 1). 3. For Handset DSS2155 - Press the number 2 (Fig.2) to register as Handset 2 (Handset numbers 2-7 are avai[...]

Y ou must subscribe to the Caller ID service from your local telephone company to use these features. When the telephone rings, the Caller ID feature allows you to view the caller ’ s name and phone number on the display before you answer the phone. The handset displays the phone number of the incoming call, the name, time and the number of calls[...]

1. Press - the summary screen is displayed. The screen shows the number of new messages and total messages. 2. Press to display the latest Caller ID message. 3. Press to see the next message, or press to see the previous message. 4. Press again to return to standby . Deleting a Caller ID message 1. Press - display the message to be deleted from the[...]

Using the Caller ID List Calling a party from the Caller ID list Y ou can place a call from the Caller ID list. The DSS2155/DSS2165 stores up to 60 messages. 1. Press - select the phone number that you want to dial by pressing or . 2. Press - the displayed phone number will be dialled automatically . Storing Caller ID messages in Memory dialing The[...]

T urning the answering system on/off: 1. T o turn the answering system on, press . The current greeting message will be played. 2. T o turn the answering system off, press . “Answering System Off” is announced. Setting Up Y our Answering System Setting your gr eeting: When you receive a call, the answering system automatically play s either a p[...]

Announce only feature: The announce only feature plays an outgoing message, but it will not allow the caller to leave a message. Move the REC TIME switch to the ANN position. The message counter LED displays when the system is on standby . Pre-recorded outgoing message for Announce only feature is: “Hello, no one is available to take your call.?[...]

Deleting Messages Deleting individual messages: 1. Press to review your message. 2. If you decide to delete a message, press anytime during the message. The system beeps and immediately goes to the next message. Deleting all messages: Press and hold while the system is in standby . A tone sounds when all messages are deleted. If there are any messa[...]

Setting the Date and T ime 1. Press for 2 seconds until a confirmation beep sounds and the current day is announced. 2. Press or to select the required day . 3. Press to store the selected day . The current hour is then announced. 4. Press or to select the required hour . 5. Press to store the selected hour . The current minute is then announced. 6[...]

Remote access away from home: Y ou can operate your answering system from a remote location using any touch-tone telephone. Use this function to check for recorded messages, play or delete messages, record a new outgoing message - or - monitor sounds in the room. 1. Call your telephone number . 2. While the greeting message is played, press and you[...]

24 Disconnect some telephones. Re-register the handset - see page 15. T alk flashes No dial tone TROUBLE SHOOTING[...]

W ARRANTY UNIDEN NEW ZEALAND LIMITED SER VICE DIVISION One Y ear Limited Warranty Important: Evidence of original purchase is required for warranty service. W arrantor: Uniden Australia Pty Limited A.B.N. 58 001 865 498 Uniden New Zealand Limited ELEMENT OF W ARRANTY : Uniden warrants to the original retail owner for the duration of this warranty ,[...]

© 2003 Uniden Australia Pty Limited Uniden New Zealand Limited FOR PURCHASING A UNIDEN PHONE! THANK YOU[...]