Uniden FP102 manual

FP102 Hands Free Speaker Phone with Pre-Programmed 5+15 Memory Operating Guide Feature • Phone Series FP102-OM.qxd 7/12/98 09:26 Page 1[...]

2 INTRODUCTION Congratulations on the purchase of your Uniden FP102 T elephone. The FP102 has been designed and engineered to exacting standards for reliability , long life and outstanding performance. T o obtain the full benefit from your new telephone, please read this Operating Guide thoroughly . For your future reference, please fill in the pan[...]

3 CONTENTS CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Important Notes . . . . . . . . . . . . . . . . . . . .[...]

4 CONTENTS CONTENTS Receiving a T elephone Call . . . . . . . . . . . . . . . . . . . . . . . .18 Accessing Call W aiting (New Zealand Model only) . . . . . . .18 Accessing Call W aiting (Australian Model only) . . . . . . . . . .19 Mute . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19 Placing a Call on Hold . . .[...]

5 IMPORT ANT INFORMA TION When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall o[...]

6 9. Unplug this product and refer servicing to qualified service personnel under the following conditions: A. If liquid has been spilled into the product. B. If the product has been exposed to rain or water . C. If the product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the op[...]

7 P ARTS CHECKLIST (F or New Zealand Model) P ARTS CHECKLIST 2 x Wall Mounting Screws and Wall Plugs Operating Guide T elephone Line Cord Wall Mounting Bracket FP102 Hands Free Speaker Phone with Pre-Programmed 5+15 Memory Operating Guide Feature • Phone Series Base Unit Handset Curly Cord Memory Storage Card FP102-OM.qxd 7/12/98 09:26 Page 7[...]

8 P ARTS CHECKLIST P ARTS CHECKLIST (F or Australian Model) T elephone Line Cord and Plug Operating Guide Wall Mounting Bracket Base Unit Handset Curly Cord 2 x Wall Mounting Screws and Wall Plugs FP102 Hands Free Speaker Phone with Pre-Programmed 5+15 Memory Operating Guide Feature • Phone Series Memory Storage Card FP102-OM.qxd 7/12/98 09:27 Pa[...]

9 FEA TURES FEA TURES • Pre-Programmed Feature Buttons Instant access to some of T elecom’ s / T elstra’ s most popular network service features* have been factory programmed into this telephone for your convenience. * Some of these services will require subscription. • 15 One T ouch Speed Dial Buttons Y our most important numbers can be pr[...]

10 • Last Number Redial If the number you are dialing is engaged, simply end the call. Then pickup the handset and press the redial button. The telephone will automatically redial the last number called. • Hearing Aid Compatible Inductive transducer coil handsets provide hearing aid compatibility . • Status LED Dual coloured LED provides visu[...]

11 FUNCTIONS FUNCTIONS 6 3 7 2 1 4 5 AUSTRALIAN MODELS 1. Button 2. Button 3. Button 4. Button 5. Button 6. One T ouch Speed Dial Buttons 7. Memory Storage Card 6 3 7 2 1 4 5 NOTE: If required the Memory Storage Card can be turned over to give 20 One T ouch memory buttons, as shown below NEW ZEALAND MODELS 1. Button 2. Button 3. Button 4. Button 5.[...]

12 FUNCTIONS FUNCTIONS 8 13 9 10 15 16 17 18 19 20 21 23 8. Button 9. Button 10. Button 11. Button 12. Handset Retainer T ab 13. Button 14. T elephone Number Card 15. Numeric Keypad 16. call LED 14 22 17. status LED 18. Button 19. Button 20. Not used 21. tone Slide Switch 22. speaker V olume Slide Switch 23. T elephone Line Jack 24. ringer V olume [...]

• Never install telephone wiring during a lightning storm. • Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected. • Use caution when installing or modifying telephone lines. CAUTION 13 INST ALLA TION INST ALLA TION HANDSET CORD CONNECTION Plug one end of the Handset Cord (curly) into the Handse[...]

INST ALLA TION INST ALLA TION W ALL MOUNTING Y ou can mount your phone directly on a wall. Before mounting your phone, consider the following: • Select a location away from electrical cables, pipes or other items behind the mounting location that could cause a hazard when inserting screws into the wall. • Make sure the wall material is capable [...]

MEMOR Y DIAL NUMBERS 20 one touch speed dial numbers can be stored into the memory of your telephone. STORING ONE-TOUCH SPEED DIAL MEMORIES 1. T o program One-T ouch Memories ( ~ ). a. Pickup the Handset or press the button. b. Press the button. c. Enter telephone number that you want to program. d. Press the button. e. Press the speed dial button [...]

USING YOUR FP102 USING YOUR FP102 16 P AUSE During the memory storage procedure you may enter a 4 second delay between numbers (for accessing a switchboard, or long distance service) by pressing the button on the Handset at the point in the number sequence you wish to pause. The button counts as one digit. Pressing more than once will increase the [...]

ADJUSTING THE SPEAKERPHONE VOLUME CONTROL During a SpeakerPhone conversation, adjust the speaker volume of your telephone by moving the speaker slide control until you hear the desired volume. NOTE: When the telephone is switched to Speakerphone Mode, the status LED turns green. 17 USING YOUR FP102 USING YOUR FP102 ADJUSTING THE RINGER VOLUME CONTR[...]

18 USING YOUR FP102 USING YOUR FP102 LED indicators 1. call LED indicator: Red light which flashes when the telephone is ringing. This is sometimes referred to as a ‘Visual Ringing Indicator’. 2. status LED indicator: a. Solid red light when ‘In Use’. b. Solid green light when in Speakerphone mode. c. Flashing green light when on ‘Hold’[...]

ACCESSING THE CALL W AITING SERVICE USING THE CALL W AITING BUTTON (Australian Model only) 1. While talking, you hear the call waiting signal (series of beep tones). 2. Press the button then to switch call and put the current call on hold. 3. T o switch back to original call, press the button then . MUTE Press and hold the button to turn off the Ha[...]

20 USING YOUR FP102 USING YOUR FP102 USING THE PRE-PROGRAMMED FEA TURE BUTTONS (New Zealand Model only) Instant access to some of T elecom’ s most popular network service features have been factory programmed into this telephone for your convenience. Call Minder T elecom’ s Call Minder Message Centre is available for leaving and retrieving mess[...]

21 USING YOUR FP102 USING YOUR FP102 Pick up the handset or press the button. Listen for the dial tone then press the button. The telephone will automatically dial the access code ‘161’ and will enable ‘immediate call diversion’ to the number you have assigned the divert to. W ait for the ‘confirmation tone’ (long-short-long) and then h[...]

Pick up the handset or press the button, then press the button and dial the number you wish to call. Call Back When the party you are calling is engaged or doesn’ t answer , hang up. Pick up the handset or press the button and then the button. The telephone will automatically dial the access code ‘*51’ to enable the ‘auto callback’ featur[...]

USING YOUR FP102 USING YOUR FP102 USING THE PRE-PROGRAMMED FEA TURE BUTTONS (Australian Model Only) Instant access to some of T elstra’ s most popular network service features have been factory programmed into this telephone for your convenience. Bloc k CID Each time you make a call, your telephone number is automatically forwarded to the party y[...]

USING YOUR FP102 USING YOUR FP102 Diver t Off T o cancel ‘Call Forward No Answer’ to another number . Pick up the handset or press the button. Press the button and then hang up. The telephone will automatically dial the access code ‘#61#’ and will cancel the diversion. Call Return T elstra’ s ‘Call Return’ Service lets you return the [...]

25 If you live outside the Sydney area, you will need to re-program the button as follows; Brisbane : Pick up the handset, then press Melbourne : Pick up the handset, then press Adelaide : Pick up the handset, then press Perth : Pick up the handset, then press T elstra is a registered trademark of T elstra Corporation Limited CAN 051 775 556 USING [...]

26 This page intentionally left blank. This page intentionally left blank. FP102-OM.qxd 7/12/98 09:28 Page 26[...]

TROUBLESHOOTING Problem Can’ t make or receive calls. Can’t hear the telephone ringing. Speakerphone V olume too low . One T ouch Speed Dial Numbers are not working correctly . Handset does not hang up in the wall mount position. Suggestion • Make sure you use only the line cord supplied with this telephone. • Check that both ends of the te[...]

28 Specifications for New Zealand Model Compliance PTC200 Size: 150mm(W) x 225mm(D) x 70mm(H) Weight: Approx. 536g Specifications, Features and availability of Optional Accessories shown are typical and subject to change without notice. NOTE: FOR USE OF THIS DEVICE IN NEW ZEALAND 1. The grant of a T elepermit for any item of terminal equipment indi[...]

W ARRANTY W ARRANTY One-Y ear Limited Warranty Important: Evidence of original purchase is required for warranty service. W ARRANTOR: Uniden Australia Pty Limited ACN 001 865 498 Uniden New Zealand Limited ELEMENTS OF W ARRANTY : Uniden warrants to the original retail owner for the duration of this warranty its FP102 (hereinafter referred to as the[...]

UNIDEN © 1998 Uniden Australia Pty Limited © 1998 Uniden New Zealand Limited THANK YOU FOR PURCHASING A UNIDEN PHONE! FP102-OM.qxd 7/12/98 09:28 Page 30[...]