3M 8800 Series инструкция обслуживания

Detection System Model 8800 Series Owner's Manual 3M Library Systems 3M Center, Building 225-4N-14 St. Paul, Minnesota 55144-1000 www.3M.com/library 78-8126-7954-2, Rev. A Copyright © 2004 3M IPC. All rights reserved.[...]

[...]

Table of Contents Safety Information .................................................................................... 1 Intended Use ...................................................................................................................................1 Safety messages containe d in this manual ......................................[...]

[...]

Safety Information Read, understand, and follow all safety information co ntained in these instructions prior to using your 3M ™ Detection System Model 8800 Series. Retain these instructions for future reference. Intended Use The system is intended for use in detecti ng books and other media items that have not been checked out by library pa tron[...]

Label Locations 8800 _ OM _ 001 E. ED 24 E. ED 24 I.T . LIST 4P .T . LIST 4P N1 108 3 Model 8801DM 100-240V~ 50/60 Hz 1 A 3M Library Systems S t. Paul, M innesot a 55144 Syste ms S t. Paul, M innesot a 55144 S/N: 881XXXX FCC ID: DGF-SSD8800 Canada:____ _____ Figure 1. 3M™ Detection System Model 8800 Serie s Label Locations 2 [...]

EMC, USA, and Canada Compliance FCC Radio Frequency Rules and Regulations This equipment has been tested a nd found to comply with the limits for a Class A device, pursuant to Part 15 of the F CC Rules. These limits are designed to provide reasonable protection agai nst ha rmful interference when the equipm ent is operated in a commercial environm [...]

Introduction The global leader in library systems products 3M pioneered the concept of electronic protection of library materia ls more than 35 years ago. We are still leading the way. Today, thousands of libraries around the world use 3M detection systems to prote ct their valuable collections, and more libraries trust 3M t han all other library d[...]

Hands-on practice After reviewing this manual, your st aff will benefit from actual hands-on experience with the detection system produ cts they are expected to use. We suggest you start by demonstrating t he proper technique s for each tagging procedure. You may wish to conduc t the actual practice as follows: 1 Make sure that all the other 3M Li [...]

Alarm Scenario 1 The library staff does not unsecure a tagged item when ch ecking out the patron's materials, or the patron a ccidentally removes tagged materials from the library . After asking the patron to return to t he counter, a typical resp onse might be, "Excuse me, did I forget to check out one of your items?" or "Did y[...]

System Specifications Detection zone The primary zone of detection between the panels ext ends just above the surface of the floor to 72 in. (1.82 m) above the floor. The electroni c coverage in this area is not 100%; howe ver , the rate of detection is effective to deter the loss of protected material s. It is also important to watch for suspiciou[...]

System Operation Turning your system on and off Power is applied and removed with a ke y switch located on Panel A. Two keys are suppli ed with the system. Remove the key while the system is operating to prevent patrons from turning off the system. If the key is not available and power must be removed, unplug the power cord or tu rn off the circuit[...]

Resetting the patron counter To keep track of the total count, record the number on the patron counter before resetting th e detection system. To reset the patron counter: 1 Locate the reset button ac cess h ole on the outside of Panel A. 2 Straighten a small paperclip. 3 Gently push the paperclip straight into the access hole approximately 1 in. ([...]

Adjusting audible alarm an d patron counter display You can adjust the volume of the alarm by turning the control on top of Panel B.  Turning the control clockwise incre ases the volume. The following settings can be adju sted to your preference during installation or servi ce by 3M technicians:  Duration of alarm beeps  Repetition rate of[...]

Detection System Alarm Log Alarm Date Time Patron Count Reported By Alarm Reason* (1) $ Value of Recovered Materials Description of Recovered Materials *Alarm Reason 1 . Test 2 . Upon Entering 3 . Failure to Un-Secure 4 . Undetermined 5 . Real alarm  11[...]

12  Requesting Service Before you call for service, please have the following information available:  The name, address, and phone nu mber of your facility.  Model number and serial number of the equipm ent (located on label above power cord).  Description of the problem. For exam pl e: poor or no detection, system alarms for no apparen[...]