AEG F88712VI0P инструкция обслуживания

EN User Manual Dishwasher FAVORIT 88712VI0P[...]

CONTENTS 1. SAFETY INFORMATION................................................................................................. 3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................[...]

1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety • This appliance can[...]

• Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. • Do not keep the appliance door open without supervision to prevent to fall on it. • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • Do not use water spray and steam to clean[...]

WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. ?[...]

5 Rating plate 6 Salt container 7 Air vent 8 Rinse aid dispenser 9 Detergent dispenser 10 Lower basket 11 Upper basket 12 Cutlery drawer 3.1 TimeBeam The TimeBeam is a display that shows on the floor below the appliance door. • When the programme starts, the programme duration comes on. • When the programme is completed, 0:00 and CLEAN come on.[...]

5. PROGRAMMES Programme Degree of soil Type of load Programme phases Options P1 1) • Normal soil • Crockery and cutlery • Prewash • Wash 50 °C • Rinses • Dry • ExtraHygiene • TimeSaver • Multitab P2 2) • All • Crockery, cut- lery, pots and pans • Prewash • Wash from 45 °C to 70 °C • Rinses • Dry • Multitab P3 3) ?[...]

Programme Degree of soil Type of load Programme phases Options P8 7) • Normal soil • Crockery and cutlery • Prewash • Wash 50 °C • Rinses • Dry • Multitab 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard programme for test institute[...]

Programme 1) Water (l) Energy (kWh) Duration (min) P8 9 - 10 1.0 - 1.2 219 - 229 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes For all the necessary information for test performance, send an email to: info.test@d[...]

German de- grees (°dH) French degrees (°fH) mmol/l Clarke de- grees Water softener lev- el 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 [...]

6.4 Use of rinse aid and multi- tablets The factory setting of the rinse aid dispenser is with the dispenser activated. This means that the rinse aid dispenser always releases rinse aid. It is possible to deactivate the rinse aid dispenser, in this case the dispenser will not release rinse aid only if the option Multitab is activated. If the dispen[...]

• The indicator continues to flash. • The display shows a number and the letter C. Each number refers to a different colour. – = TimeBeam deactivated. 3. Press again and again to change the colour. • You can see the different colours on the kitchen floor. 4. Press the on/off button to confirm the setting. 7. OPTIONS Desired options must be [...]

We recommend the ''sanitisation'' of the appliance before and after a long absence (e.g. holidays). How to activate ExtraHygiene Press , the related indicator comes on If the option is not applicable to the programme, the related indicator does not come on or it flashes quickly for a few seconds and then goes off. The display sh[...]

8.2 How to fill the rinse aid dispenser A B C CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Open the lid ( C ). 2. Fill the dispenser ( B ) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Close the lid. Make sure that th[...]

Starting a programme 1. Keep the appliance door ajar. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. 3. Press repeatedly until the display shows the number of the programme you want to start. The display will show the programme number for approximately 3 seconds and then show the p[...]

• When loading the appliance, make sure that the dishes can be completely reached and washed by the water released from the spray arm nozzles. Make sure that items do not touch or cover each other. • You can use dishwasher detergent, rinse aid and salt separately or you can use the multi-tablets (e.g. ''3in1'', ''4[...]

• The spray arms are not clogged. • There is dishwasher salt and rinse aid (unless you use multi- tablets). • The position of the items in the baskets is correct. • The programme is applicable for the type of load and for the degree of soil. • The correct quantity of detergent is used. 10.6 Unloading the baskets 1. Let the tableware cool [...]

5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter ( A ). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters ( B ) and ( C ). 8. Put back the filter ( B ) in the flat filter ( A ). Turn it clockwise until it locks. CAUTION! An incorrect[...]

12. TROUBLESHOOTING If the appliance does not start or it stops during operation. Before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems, the display shows an alarm code. Problem and alarm code Possible solution You cannot activate the ap- pli[...]

Problem Possible solution There are stains and dry water drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Ad- just the rinse aid selector to a higher position. • The quality of the rinse aid can be the cause. The dishes are wet. • The programme does not have a drying phase or has a drying phase with low tem[...]

ENGLISH 21[...]

www.aeg.com 22[...]

ENGLISH 23[...]

www.aeg.com/shop 117893850-A-472014[...]