Audiovox X10 инструкция обслуживания

128-7546 1 of 16 -1- Released 9-15-05. Xpr e s s ® Sat ellit e R adio R e ce iv e r XMB10 B o om B o x Us e r G uide[...]

128-7546 2 of 16 -2- CONTENTS Congratulatio ns ........................................................................................ 3 FCC Regulations ...................................................................................... 4 Cautions and W arnings ............................................................................ 4 Conte[...]

128-7546 3 of 16 -3- Congratulations Thank you for purchasing the Audiovox Xpress XM ® Satellite Radio Boom Box. Y ou are one step closer to experienc- ing the latest innovation in XM ® Satellite Radio. XM ® Satellite Radio will revolutionize your in-home or On-the-Go entertainment. XM ® features over 150 digital channels — 100% commercial-fr[...]

128-7546 4 of 16 -4- FCC Regulations This unit complies with the interference limits relative to a Class B digital device, applicable under Part 15 of the FCC Rules regarding installation in a residential environment. If the unit is not installed in accordance with these instructions, it could cause harmful interference to audio or television recep[...]

128-7546 5 of 16 -5- Setting Up and Installing Y our Kit NOTE: The XM ® signal can be received and pro- cessed virtually anywhere as long as there are no obvious satellite signal obstructions such as high terrain, trees, overhangs, etc. In placing the antenna, therefore, these factors must be taken into account . Boom Box XMB10 Controls The Xpress[...]

128-7546 6 of 16 -6- is also located on the front panel. When the Xpress ® Receiver is installed in the boom box, the 1. PHONES Jack: Accepts a stereo headphone jack to provide private listening capability for the Boom Box. 2. AUX Jack: Accepts an audio input signal from an external audio device. When using the AUX audio input, turn the Receiver o[...]

128-7546 7 of 16 -7- 1. Turn the Boom Box upside down to access the battery compartment. 2. Push the battery cover latches forward and flip up the battery compartment cover to the open position. 3. Insert eight (8) C-Cell batteries observing battery polarity as shown; then close the cover . 3. Installing the Receiver in the XMB10 Install the receiv[...]

128-7546 8 of 16 -8- b. After making sure the connectors and guide pin hole are properly lined up, gently lower the Xpress into the mounting plate, and press down on the Xpress to mate the connectors together . The raised detent on the mounting plate will enter the notch on the rear of the Receiver , indicating the Xpress is properly seated. The re[...]

128-7546 9 of 16 -9- 5. Installing the Antenna For best reception, the supplied antenna should be placed near a window if in the house or , if outdoors, in an open area and as high as possible; some repositioning may be required to achieve optimum results. The following guidelines are recommended: a. In a major city , where XM ground repeaters are [...]

128-7546 10 of 16 -10- T o mount the antenna: a. Plug the antenna into the ANT connector on the back of the XMB10. b. Leave the antenna in place on the Boom Box, or remove the antenna from its mount, uncoil the antenna cable, and place it at the preferred location inside or outside the home. If the Xpress Receiver display indicates “NO SIGNAL,”[...]

128-7546 11 of 16 -11- cable; use protective grommets wherever rough openings are encountered. d. If the antenna is mounted outside, route the cable from the antenna position to the interior of the home, working the cable through the basement, under a window sill, etc.; make adjustments and take up slack whenever necessary . e. If outdoors, either [...]

128-7546 12 of 16 -12- Specifications Nominal Output Power per Channel 5.0 Watts Rms T otal Harmonic Distortion (THD) 0.3% at 1 Watt Frequency Response 30Hz to 20kHz Signal-to-Noise Ratio > 65dB Maximum Speaker Impedance 8 Ohms Nominal Headphone Output Impedance 32 Ohms Headphone Output Level 800 mV (Maximum) Headphone Connector Type 3.5 mm Ster[...]

128-7546 13 of 16 -13- Maintenance Periodic Inspection The XMB10 Boom Box should be inspected periodically for external damage. At least once every 30 days of use, perform the following checks: 1. Inspect the Receiver connector for loose, bent or broken pins, misalignment, etc.; make sure the Xpress Receiver connector is intact and exhibits no appa[...]

128-7546 14 of 16 -14- Troubleshooting System does not turn on XMB10 does not operate using batteries Intermittent operation ANTENNA error message NO SIGNAL message No sound from XMB10 speakers Receiver power is set to off Batteries not installed or installed incorrectly As long as the AC power connector is at- tached to the rear panel, operation i[...]

128-7546 15 of 16 -15- AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purc hase, such defect(s) will be repaired or replaced with new o[...]

128-7546 16 of 16 -16- 128-7546 © 2005 Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, New York 11788[...]