Autostart AS-6205 инструкция обслуживания

H.3.10.S.3.20 DOC.1.00  CA – September 15, 2003 Manufact ured in Canada by Autostart AUTOMATI C TRANSMI SSION MULTI-CHANNEL REMOTE STARTER AN D FULL-F EATURED ALARM S YSTEM AS-6205 User Guide Transmitter Part Numb er and Module Seri al Number ....................................................... 2 Introduction ...............................[...]

Transmitter Part Number an d Module Serial Number Transmitter Part Number: ASTR-575-433 The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch. Module Serial Number: Valet Switch is located : Introduction This Module is a state-of-the-art combination of an Alarm system and a remote car starter[...]

Basic Remote Operation This system is equipped with a 5-button multi-channel two-way transmitter. It can o perate two independent identically-equipped vehicles (see Multi-Car Operation for second-car transmitter functions). The functions of the transmitte r are as follows: Note: Pressing the LOCK and UNLOCK buttons at the sa me time will activate t[...]

AS-6205 SH User Guide P. 4 x Turn the ignition key to the IGNITION ON (RUN) position. ( Do not turn the key to the START position while the engine is running. This will cause the starter motor to re-engage.) x Press the brakes to disengage the remote starter unit. You are now ready to drive off. Idle Mode This feature allows you to remove the key f[...]

P. 5 User Guide AS-6205 SH Remote Valet This feature will put your vehicle into Valet Mode using the remote transmitter instead of the Valet button as above. Note: Once the Electronic Valet i s activated, the remote start er and Alarm featur es are disabled. To put the system into Valet Mode : 1. Hold down the UNLOCK and START buttons simultaneousl[...]

AS-6205 SH User Guide P. 6 x Or press and hold the LOCK button for approximately 3 seconds until the siren starts to sound and the parking lights flash: this will lock the doors before the siren sounds. Panic Mode will automatically shut down after 1 minute. Note : To stop Panic Mode before the 1-minu te delay, press the LOCK or UNLOCK button until[...]

P. 7 User Guide AS-6205 SH Shock Delete The shock sensor can be temporarily disabled. To temporarily disable shock and warn-away sense : x Press the TRUNK button and, within 3 seconds, x Press the STOP button. Shock senses will now be ignored until the next disarming of the system. User-selectable Options The system was designed with flexibility an[...]

AS-6205 SH User Guide P. 8 Passive or Active Arming By default, the system is configured to Passive Arming Mode . In Passive Arming Mode, the Starter Kill and the Alarm will automatically arm 30 seconds after the last door is closed. The system will not arm itself if a door is left open. Important note: When the system re-arms automatic ally or if [...]

P. 9 User Guide AS-6205 SH Ignition Re-Lock When the Ignition-Controlled Door Locks option is enabled and the ignition is ON , should any door be unlocked and opened, all the doors will be re-locked next time the brake pedal is pressed. Secure Lock This is an added security feature. If your system was installed with the Secure Lock option, it will [...]

x Press TRUNK + LOCK button simultaneously: .................. LOCK x Press TRUNK + UNLOCK : ................................................... UNLOCK x Press TRUNK + START : .................................................... START x Press TRUNK + STOP : ....................................................... STOP x Press TRUNK + LOCK + UNLOCK :[...]

Parking Lights Flash Rate (Normal Operation) Flashes Description 1 x Doors locked, Starter Kill armed. x End of Run Time. x TRUNK button pressed x START signal received by the Module. x Cold Weather Mode cancelled. x Cannot start after maximum number of attempts is reached. 2 x Run Time cancell ed. x Remote start atte mpt cancelled by remote. x Doo[...]