Autostart AS-6250V инструкция обслуживания

ONE -WAY A UTO MATIC /MAN UAL TRANSMIS SION REMOTE ST ARTER WIT H FULL ALARM SYSTEM DOC. 1.00 - AS-6250v - - August 28, 2007 - - MO - Assembled in Canada AS-6250v User Guide WARNING It is the responsibility of the vehicle op erator to ensure their vehicl e is parked in a saf e and responsibl e manner. 1. a) Manual transmission : Wh en leaving the v[...]

P. 2 User Guide Table of Contents Transmitter Part Number and Module Ser ial Number ............................................................... 3 Introducti on ....................................................... 3 Basic Remote Oper ation .................................. 4 Remote-startin g Your Vehicle ......................... 4 Setting Y[...]

User Guide P. 3 Transmitter Part Number an d Module Serial Number Transmitter Part Number: The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch. Module Serial Number: Valet Switch is located (if installed): Intr od uc tion This Module is a state-of-the-art combination of an Alarm system and [...]

P. 4 User Guide Basic Remote Operation This system is equipped with a 5-button mult i-channel transmitter. It can operate two in- dependent identically-equipped vehicles (see Multi-Car Operation for second-car transmitter functions). The functions o f the transmitter are as follo ws: Note: Pressing the LOCK and UNLOCK buttons a t the same time will[...]

User Guide P. 5 quickly an d remain lit . Skip to step 4. 3. Within 20 sec. of engaging the parking brake, press and hold LOCK , UNLOCK or START/STOP on the transmitter. The parking lights will fl ash 3 times quickly and remain lit. - 4. Remove the key: the engi ne will continue running. 5. Exit the vehicle and close all doors, hood and trunk. 6. P[...]

P. 6 User Guide delivery or at a convenience store, lock your vehicle and leave it running for the le ngth of a run cycle while you are away. To leave the vehicle in Idle Mode if your vehic le has an automatic transmission : 1. With the engine running, press the LOCK or UNLOCK button (to unlock the doors) or the START button on the remote control u[...]

User Guide P. 7 Igniti on V alet The system can be placed in Val et Mode to disable the remote starting capabilitie s. If the vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being accidentally started by remote control. To ENTER Valet Mode 1. With the key in the Ignition switch, turn the key to the O[...]

P. 8 User Guide 4. Flash twice again. Panic Mode Safety feature: Activate Panic Mode in an emergency situation. In an emergency situation, you can activate Panic Mode using th e LOCK or UNLOCK or STOP button. This will: Shut down the engine, Unlock the doors (if UNLOCK is pressed) Or lock the door (if LOCK is pressed), Disarm the Starter Kill and A[...]

User Guide P. 9 Priority Door Access This safety feature lets you unlock only the driver’s door when you press the UNLOCK button on the transmitter, and then UNLOCK the rest of the vehicle doors if the UNLOCK button is pressed for a second time within 3 seconds. Chirp Delete To temporarily disable the siren’s chirp confirmations upon arming and[...]

P. 10 User Guide Remote Door Locks If your system was installed with the Remote Door Locks opti on, you will have the convenience of remote keyless entry. To UNLOCK your doors and DISARM the system: 1. Press and hold the UNLOCK button for approx. 1 sec. 2. The parking lights will flash twice and the LED will go out to co nfirm that the doors have b[...]

User Guide P. 11 Open Zone Noti fication (the system will warn for doors opened up to 10 seconds after arming). No Chirp (the vehicle will not chirp under any circumstance). Open Zone No tifi cation (Off by default. ) This feature will warn the user when a Door is left open: upon the arming of the Module, a 10-sec. notification delay will take plac[...]

P. 12 User Guide If your vehicle has an automatic transmission , proceed as follows to set the system in Turbo Mode : 1. With the engine already running, press the LOCK button on the transmitter until the parking lights come ON . 2. Remove the ignition key from the ignition sw itch. The engine will go on running. 3. Exit the vehicle and close the d[...]

User Guide P. 13 Mul t i-Ca r O p er at ion This option allows the owner of two vehicles, both equipped with identica l systems, to control both systems with only one remote transmitter. To control the second vehicle, simultaneously press the TRUNK button and the button of the function you wish to use: Press TRUNK + LOCK button simultaneously: LOCK[...]

P. 14 User Guide Parking Lights Flash Ra te (Normal Operation) Flashes Description 1 • Doors locked, Alarm and starter kill armed. • Run time has expired. • TRUNK button pressed. • Start signal received by the module. • Cold weather mode cancelled. 2 • Remote start attempt cancelled by remote. • Doors unlocked, starter kill disarmed. [...]

User Guide P. 15 LIMITED LIFETIME WARRANTY REMOTE STARTERS: As the manufacturer, 43 66859 Canada Inc. (“Autos tar t”) warrants to the origin al consumer purchaser only ( nontransferable ) t hat the remote s tarter module (c ontrol box) shall be free f rom defects i n materials a nd workmans hip for as long as the orig inal consumer purchaser co[...]