Beckett AFII инструкция обслуживания

RESIDENTIAL BURNERS Potential for Fire, Smoke and Asphyxiation Hazards T o the Homeowner or Equipment Owner: Please read and carefully follow all instructions provided in this manual regarding your responsibilities in caring for your heating equipment. Contact a professional, quali fi ed service agency for installation, start-up or service work. S[...]

2[...]

3 AFII Burner Manual T o the Owner : Thank you for purchasing a Beckett burner for use with your heating appliance. Please pay attention to the Safety W arnings contained within this instruction manual. Keep this manual for your records and provide it to your quali fi ed service agency for use in professionally setting up and maintaining your oil [...]

4 Gener al Inf or ma tion Section: General Information Hazard De fi nitions Within the boundaries of the hazard warning, there will be information presented describing consequences if the warning is not heeded and instructions on how to avoid the hazard. Indicates a hazardous situation, which, if not avoided, will result in death or serious injury[...]

5 AFII Burner Manual Inspect/Pr epar e Installa tion Site Clearances to Burner and Appliance Provide space around burner and appliance for ease of service and maintenance. Check the minimum clearances against those shown by the appliance manufacturer and by applicable building codes. Combustion Chamber and Burner Retro fi tting V erify that the co[...]

6 HB 6 slot HC 9 slot HD 6 slot HE 9 slot Any accumulation of soot or debris in chimney offsets should be removed Any obstructions such as a protruding joint or a piece of broken tile wedged in the chimney should be removed. No other appliance connection should be made to the same fl ue pipe. The fl ue pipe should have an upward pitch toward the [...]

7 AFII Burner Manual the burner or provide a sealed enclosure for the burner and supply it with its own combustion air supply . Direct/Sidewall V enting Application When sidewall venting appliances, carefully follow appliance and power venter instructions for installation and wiring. AFII burners are equipped with a removable air inlet to allow use[...]

8 On the outside of the home use a 90° elbow pointed downward with a 1/4 ” mesh screen over its opening. The air inlet elbow must be located above the snow line and in such a way as to prevent leaves and/or other debris from blocking the air fl ow . Such debris will prevent proper operation of the burner . Refer to local codes for proper locati[...]

9 AFII Burner Manual Figure 6. – Mounting Burner in Appliance 3 G P H 1 5 0 - 2 0 0 P S I 3 4 5 0 R P M 4 G P H GPH 1 0 0 - 1 5 0 10 0-15 0 P S I PS I 3 4 5 0 3450 R P M R P M B Y - P A S S IN L E T A 2 E A -6 5 2 0 A2EA-6520 N O.2 & L I G H T E R F U E L E x c l u s i v e l y f o r B e c k e t t N O. 2 F U E L Ma d e b y S u n te c Mad eby S[...]

10 Bur ner Controls GeniSys Model 7505 Control Wiring Figure 7 - 7505 Control Features Thermostat / Operating and Limit Control Compatible Welded Relay Protection Limited Recycle Limited Reset 3 Status Lights V alve-On Delay / Motor-Off Delay (Field programmable with 52067 GeniSys Display) 15 Second Lockout T ime Interrupted or Intermittent Duty Ig[...]

11 AFII Burner Manual the igniter remains on for 10 additional seconds to ensure fl ame stability . Run : The fl ame is sustained until the call for heat is satis fi ed. The burner is then sent to Motor-Off Delay , if applicable, or it is shut down and sent to Standby . Recycle : If the fl ame is lost while the burner is fi ring, the control s[...]

12 Figure 8a. – Interrupted ignition, valve-on delay only (no motor-off delay) Figure 8b. – Interrupted ignition, valve-on delay and motor-off delay SAFETY AND OPERA TING LIMITS LIMIT L1 L2 (VL V) VA LV E L2 MOTOR L2 (MTR) L2 (IGN) IGNITER CAD CELL MOTOR IGNITER W R 80 70 60 50 50 70 80 60 OIL V AL VE CAD CELL THERMOST A T TR TW TR-TW JUMPER TR[...]

13 AFII Burner Manual RECYCLE. If the fl ame is lost while the burner is fi ring, the control shuts down the burner , enters a 60 second recycle delay , and then repeats the above ignition sequence. If fl ame is lost three times in a row , the control locks out to prevent cycling with repetitious fl ame loss due to poor combustion. BURNER MOTOR[...]

14 Star t Up Bur ner and Set Combustion Set the thermostat substantially above room temperature. Close the line voltage switch to start the burner . If the burner does not start immediately you may have to reset the safety switch of the burner primary control. Priming the Pump Prepare the burner for priming by attaching a clear plastic hose over th[...]

15 AFII Burner Manual P erfor m Regular Maintenenance The following guidelines are provided for routine maintenance. Replace the oil supply line fi lter . The line fi lter cartridge must be replaced to avoid contamination of the fuel unit and nozzle. Inspect the oil supply system. All fi ttings should be leak-tight. The supply lines should be fr[...]

16 T able 4 - Nozzle Flow Rate by Size Nozzle fl ow rate U. S. gallons per hour of No. 2 fuel oil when pump pressure (psig) is: Nozzle size (rated at 100 psig) 125 psi 140 psi (factory std.) 150 psi 175 psi 200 psi 0.40 0.45 0.47 0.49 0.53 0.56 0.50 0.56 0.59 0.61 0.66 0.71 0.60 0.67 0.71 0.74 0.79 0.85 0.65 0.73 0.77 0.80 0.86 0.92 0.75 0.84 0.89[...]

17 AFII Burner Manual Figure 10a. HLX Air Tube SK9639 Figure 1 1a. Electrode Settings-HLX Air T ube Combinations 1-1/2” 15/32” 3/32” 5/32” 1/4” 5/32” Nozzle face to back of head S top Screw Do NOT overtighten Clamp Screw Figure 1 1b. Electrode Settings-FBX Air T ube Combinations SK9461 SK8263 Figure 12. – Blower Wheel Replacement Figu[...]

18 HLX Firing Rate Stop Screw AFII 85 AFII 100 AFII 150 0 0.40-0.65 0.5-0.65 0.75-1.00 1 - 0.6-0.75 0.85-1.10 2 - 0.65-0.80 0.95-1.15 3 0.60-0.75 0.65-0.90 0.95-1.20 4 - 0.75-0.95 1.10-1.25 5 0.70-0.85 0.85-1.00 1.15-1.35 6 - 0.95-1.10 1.15-1.40 7 - - 1.25-1.50 8 - - 1.30-1.50 HLX Air Dial Setting Firing Rate @ 140 psig AFII 85 AFII 100 AFII 150 0.[...]

19 AFII Burner Manual For best performance specify genuine Beckett replacement parts Item Description Kit No. 14 Housing ass’y: AFII 85 & 100 AFII 150 51584U 51476U 15 Motor: 1/7 hp, 3450 rpm, 1 15V/60Hz 21444U 16 Nozzle adapter 213 17 Nozzle Line Electrode Head ass’y Specify* 18 Replaces R7184A - Interrupted Ignition 7505A Replaces R7184B [...]

USA: P .O. Box 1289 ● Elyria, Ohio 44036 Canada: R.W . Beckett Canada, Ltd. ● Unit #3, 430 Laird Road ● Guelph, Ontario N1G 3X7 www .beckettcorp.com Part Number 6104 BAFII R03, Printed in the U.S.A. 05/10 The R. W . BECKETT CORPORA TION (“Beckett”) warrants to persons who purchase its “Products” from Beckett for resale, or for incorpo[...]