Bertazzoni C36600X, Z36600X инструкция обслуживания

Installation, Service and User Instructions Built-in gas cooktops BERTAZZONI DIMENSIONS: 36’’ (915 mm)(W) x 253/16’’ (640 mm)(D) Models C36500X (Z36500X) [C3W0..U4X(2 or 5)A] Models C36600X (Z36600X) [C3Y0..U4X(2 or 5)A] IMPORTANT - PLEASE READ AND FOLLOW -Before beginning installation, please read these instructions completely and carefull[...]

2 WARNING Read this instruction booklet before i nstalling and using the applia nce. The manufacturer will not be respons ible for any damage to property or to persons caused by incorrect installation or improper use of the appliance. The manufacturer reserves the right to mak e changes to i ts products when consid ered necess ary and useful, witho[...]

3 INSTALLATION MANUAL BACKGUARD INSTALLATION INSTRUCTION Please follow the follo wing installation instructions afther installing the cooktop: 1) Remove n°2 screws fixing worktop as sho wn in fig.1 2) Place front part of the backguard and attach it from bottom side with the two removed screws (point 2) as sho wn in fig .2 3) Fix the front part of [...]

4 PROXIMITY TO SIDE CABINET INSTALLATION 1. This rangetop may be installed directly adjacent to existin g 36" (91.5 cm) high base cabinets. IMPORTANT: The top grate support MUST be 3/8" (.95 cm) above the adjacent base cabinet countertOP. 2. The rangetop CANNOT be install ed directly adjacent to side walls, tall cabinets, tall applia nces[...]

5 COOKER HOOD INSTALLATION The bottom of the hood should be 2 5 ½ " (65 cm) min. to 31 ½ " (80 cm) above the countertop. Refer t o the rangehood installation instructions for additional informa tion. T hese dimensions provide for safe and efficient operation of the hood. ELECTRICAL CONNECTION This unit is manufactured for a polarized, g[...]

6 Wiring diagram For freestanding gas range model C36600X ( Z36 6 00 X ) C3Y0..U4X(2 or 5)A CAUTION : label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. For freestanding gas range model C36500X ( Z36 5 00 X ) C3W0..U4X(2 or 5)A CAUTION : [...]

7 GAS CONNECTION All gas connections must be made accordi ng to national and local codes. This gas suppl y (service) line must be the same size or greater than the inlet line of the appliance. T his range uses a 1/2" NPT (see fig. in this chapt er for details of gas connections installations) inlet. Sealant on ali pipe joints must be resistive[...]

8 REPLACEMENT PARTS Only authorized replacement parts may be used in performi ng service on the appliance. Replacem ent parts are available from factory authorized parts distributors. CONVERSIONE TO DIFFERENT TYPES OF GAS Before carrying out any maintenance work, disconnect th e appliance from the gas and electric supply. For Natural Gas fit regula[...]

9 Models C36600X (Z36 6 00 X) [C3Y0..U4X(2 or 5)A] Adapting to different types of gas Burner Position Injector Gas Pressure Max Rate Min Rate By-pass diam. [mm.] Type [i.w .c.] [BTU/h] [W] [BTU/h] [W] diam. [mm] Auxiliary Front R 0,90 NG 4” 3400 996 900 264 Regulated 0,54 LP (Propane) 11” 3400 996 900 264 0,29 Semi-Rapid Rear L & C 1,18 NG [...]

10 SERVICE & MAINTENANCE INSTRUCTIONS Service and maintenance only to be carried out by an authorised person To replace parts such as burners, valves and electric com ponents, the appliance must be open removing the worktop. Note: if the valves must be replaced, first disassemble the ignitions switches wires. It is recommended to replace the va[...]

11 USING BURNERS A diagram is etched on the control panel abo ve each knob which indicates which burner corresponds to t hat knob. Manual ignition: Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure. Turn the knob that corresponds to the burner selected counterclock wise to the MAXI MUM posi[...]

12 CLEANING THE APPLIANCE: Never use abrasive cleaners Before cleaning the appliance it should be disconnected from the po wer supply. Cleaning the work surface: periodically cl ean the burner heads, the cast iron pan suppor ts and the bur ner caps using warm water. Any spillage must always be remove d as soon as possible using a rag. If it become [...]

13 SPARE PART LIST Quantity Number Drawing Code Description C3W0..U4X5AUA C3Y0..U4X5AUA 1 601739 CIRCUIT DIAGRAM 1 1 11 202317 PART FOR BURNER FIXI NG 3 3 11 202386 PART FOR DUAL WOK AND SEMI RA PID BURNERS 1 1 13 510507 SMALL BURNER 1 1 13 510508 SEMI RAPID BURNER 1 3 13 510509 RAPID BURNER 1 1 13 510511 DUAL BURNER 1 1 14 504128 SMALL FLAME SPREA[...]

14 1631 501647 TUBE FOR RIGHT BACK BURNER 1 1 1800 501652 REAR CENTRAL TUBE 1 1801 501648 TUBE FOR LEFT BACK BURNER 1 1 1802 501653 FRONT CENTRAL TUBE 1 1803 501655 TUBE FOR EXTERNAL DUAL BURNER 1 1804 501654 TUBE FOR INTERNLA DUAL BURNER 1 1805 501650 CENTRAL TUBE 1 1806 501651 EXTERNAL CENTRAL TUBE 1 1807 501649 TUBE FOR FRONT LEFT BURNER 1[...]

15[...]