Bissell 20Q9 инструкция обслуживания

USER’S GUIDE 3574/73G8/3576/20Q9 SERIES Safety Instructions 3 Product View 4 Assembly Instructions 5-6 Operation / Special T ools 6-8 Maintenance 8-12 T roubleshooting 12-13 Warranty 16 Replacement Parts 14 Consumer Ser vices 15 CleanView ® II BAGLESS DJ68-00280A REV(0.1)[...]

2 Thanks For Buying A BISSELL CleanV iew ® II We’ re glad you purc hased a BISSELL CleanView II Vacuum. Ever ything we know about floor care went into the design and construction of this complete, high-tech home vacuuming system. Y our BISSELL CleanView II is well made , and we back it with a limited comprehensive one-year warr anty . We also st[...]

3 IMPOR T ANT SAFETY INSTR UCTIONS When using an electrical appliance, basic precautions should be obser ved, including the following: READ ALL INST R U CTIONS BEFORE USING Y OUR UPRIGHT V ACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance. W ARNING: T o [...]

4 C AUTION: Do not plu g in you r va cu um cleaner until you are familiar with all instructions a nd operating procedures. Power Switch Carrying Handle Crevice T ool Post-Motor Filter Quick Reach ® Handle Handle Quick Release Cord Wrap Handle Release Pedal Powerfoot Stretch Hose Extension W and Power Cord Furniture Protection Guard Height Adjustme[...]

5 How T o Put It T ogether Select Models Only Th e o nl y t ool yo u’ ll ne ed to a ss em bl e yo ur va cu um cleaner is a screwdriver . Locate the vacuum Handle and remove the screw packet ta ped to the base of the Handle. Stand the vacuum upright and slide the base of the Handle firmly into the grooves at the top of the vacuum bod y . Check to [...]

Press the Handle Release Pedal with your foot to place your vacuum in one of three cleaning positions. Upright- For stora ge and above floor c leaning with tools. Normal Cleaning- Press Handle Release Pedal once. Use for most household floor cleaning tasks. Low Cleaning- With the vacuum in normal cleaning posi - tion, press Handle Release Pedal aga[...]

Y our BISSELL CleanView II is not only a pow - erful carpet and rug vacuum c leaner , it’ s also a versatile above floor vacuum cleaner when you select one of the special tools. Raise Handle to Upright Position. Grasp the Quick Reach Handle and lift Hose Wand to separate from suction intake opening. Attach tools by firmly pushing onto Vacuum Hose[...]

T o maintain maximum cleaning performance, the following maintenance steps must be performed: Empty the Dirt Container when the dirt reaches the “Full” line on the side. Check the Inner and Outer Circular Filters and the Pre-Motor Filter at least once a month and c lean or replace as needed. Replace the Post-Motor Filter every three to six mont[...]

Separate the Outer foam and Inner pleated Circular Filters. Wash each individually by hand in warm water . Mild detergent may be used if desired. Rinse well, then air dry thoroughly before putting them back together and replacing in Filter Cup. The Filter Cup may be washed in warm wa ter with a mild detergent. Make sure it is completely dr y before[...]

For standard models , remove the four screws as shown with a Phillips Head Screwdriver . Lift the Brush Cover off. For wide cleaning path models , Lift tab 1 and release the three la tches in order 2-4 as marked. Lift the Brush Cover off. Grasp Rota ting Floor Brush at both ends and lift. Clean strings, hair and other debris from Rota ting Floor Br[...]

Determine the light bulb type of your vacuum: Standard Bulb (#203-1297) – approximately 1” long, flat end Large Bulb (#203-1007) – approximately 2” long, round end Standard Bulb – remove the bulb from the socket by grasping bulb and pulling straight out. Install the new bulb by pushing it gently into the socket until the bulb snaps into p[...]

12 T roubleshooting V acuum cleaner won’t run P ossible Causes Remedies Power cord not plugged in Check electrical plug Blown fuse/tripped breaker Check/Replace fuse or reset breaker V acuum cleaner won’t pick up dirt P ossible Causes Remedies Incorrect Height Adjustment Adjust Powerfoot to correct height setting Hose not attached to suction op[...]

V acuum cleaner won’t pick up dirt continued P ossible Causes Remedies Dirt Container not installed properly Position correctly and lock in place Filters are dirty Check and clean Inner and Outer Circular Filters, Pre-Motor and Post-Motor Filters Louvers missing or installed incorrectly Check for a c log in the tube in the center of the Dirt Cont[...]

14 Replacement P arts – BISSELL Cleanview II Series 1 2/3 4 7 5 6 8/9 10 11 12 14 15 16 17 13 7 Y ou may purchase replacement parts from your retailer , by calling BISSELL Consumer Ser vices or by visiting our website. T o locate a retailer near you, or to place an order using Visa, MasterCard, Discover or American Express, call BISSELL Consumer [...]

BISSELL Consumer Ser vices For information about repairs or replacement parts, or questions about your warranty , call: BISSELL Consumer Ser vices 1-800-237-7691 Monday - Frida y 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare Inc . PO Box 3606 Grand Rapids , MI 49501 A TTN: Consumer Ser vices Or visit the BISSELL web[...]

Warranty 16 This warranty gives you specific legal rights, and you may also have other rights which may var y from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover , please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below. Limited One Y[...]